Silonn Portable Automatic Ice Maker
Instruction Manual
Model: SLIM01G1
V1.0 (A)
Important Safety Information
READ ALL INSTRUCTIONS BEFORE USING THE APPLIANCE.
WARNING
To reduce the risk of fire, explosion, electrical shock, or injury when using the unit, follow these basic safety precautions:
- Do not under any circumstances, alter or move the third (ground) prong from the power cord. For personal safety, the unit must be properly grounded.
- Do not exceed the power outlet limit. It is recommended that the unit is connected to its own circuit. Use only a 115V, 60 HZ standard electrical supply that is properly grounded following the National Electric Code and local codes and ordinances.
- Due to potential safety hazards under certain conditions, Silonn strongly advises against the use of an extension cord. However, if an extension cord must be used, it is absolutely necessary that it is a UL-listed, 3-wire ground type appliance extension cord having a grounding type plug and that the electrical rating of the cord is 2 Amperes (minimum) and 115 Volts.
- The unit must be properly installed and located following the installation instructions before it is used. The unit is for indoor household use only. Do not use outdoors.
- Do not store or use flammable vapors or liquids near the unit.
- Do not allow children to climb, stand, or hang on the unit. Serious injury may occur.
- Do not use water that is micro-biologically unsafe or of unknown quality.
- Do not place the power cord in such a way it could be pulled on by children or cause a tripping hazard.
- Do not place the power cord in such a way that it is in contact with hot surfaces.
- Do not operate if any component, including the cord or plug, is damaged.
- Unplug the unit before cleaning by hand and when not in use.
- Do not immerse any part of the unit in water.
- Do not plug or unplug the unit with wet hands.
- Do not attempt to disassemble, repair, modify, or replace any part of the unit.
- Use the unit only for its intended purpose as described in this instruction manual.
- Do not use any accessories not recommended by this instruction manual.
- When handling, installing and operating the unit, care should be taken to avoid damage to the refrigerant tubing.
- Servicing shall be performed by factory authorized service personnel and component parts shall be replaced with manufacturer authorized replacement components.
- Do not operate if any component, including the cord or plug, is damaged.
CAUTION
To reduce the risk of injury when using the unit, follow these basic safety precautions:
- Do not remove any safety, warning, or product information labels from the unit.
- Closely watch children who are near the unit when it is making ice.
WARNING
FIRE OR EXPLOSION HAZARD Flammable Refrigerant
This unit contains an isobutane refrigerant, also known as R600a, a natural gas with high environmental compatibility. However, it is also combustible. Adhere to the warnings below to reduce the risk of injury or property damage.
- When handling, installing and operating the unit, care should be taken to avoid damage to the refrigerant tubing.
- Disposal of the unit under Federal and Local Regulations. Contact your local authorities for the environmentally safe disposal of your refrigerator.
- Keep ventilation openings in the unit enclosures or the built-in structure clear of obstruction.
- Do not place the unit near heat sources such as an oven.
- Ensure a minimum of three inches of clearance around the side and back walls of the unit for proper air circulation.
- Do not place the unit in direct sunlight.
Product Introduction
The following diagram illustrates the components of the Silonn Portable Automatic Ice Maker:
Diagram Description:
The diagram shows two views of the ice maker. The top view shows the lid open, revealing the ice basket and control panel. The side view shows the air exhaust fan and drain plug.
- 1. Ice Shovel: Used to scoop ice.
- 2. Ice Full Sensor: Detects when the ice basket is full.
- 3. Ice Basket: Holds the ice produced.
- 4. Large Viewing Window: Allows observation of the ice-making process.
- 5. Air Exhaust Fan: Dissipates heat from the unit.
- 6. Drain Plug: Located at the bottom of the unit for draining water.
- 7. Maximum Water Fill Line: Indicates the maximum water level for the reservoir. This line is visible when the ice basket is removed.
- 8. Control Panel: Interface for operating the ice maker.
- 9. Ice Scoop: Included for serving ice.
Control Panel Introduction
The control panel allows you to manage the ice maker's functions:
Key (with indicator light):
Indicator/Button | Function |
---|---|
1. ADD WATER | The indicator light turns red when the water reservoir lacks water. |
2. ICE FULL | The indicator light turns red when the ice basket is full. |
3. S | The indicator light turns green when small ice mode is selected. |
4. L | The indicator light turns green when large ice mode is selected. |
5. ON/OFF CLEAN | Short press to turn on the ice maker; the "POWER" indicator light turns green. Short press to turn off the ice maker; the "POWER" indicator flashes green. When the ice maker is in "stand by" mode, long-press for 5 seconds to initiate self-cleaning mode; the "S" and "L" indicator lights will flash green consecutively. |
6. SELECT | Confirms the selection of large ice mode or small ice mode. |
Using Your Ice Maker
Before First Use
- Unpack the unit and verify that all accessories, including the ice basket and ice scoop, are included. Contact Silonn if any accessories are missing.
- Ensure the unit is placed on a level and stable surface to prevent malfunction.
- Use only drinking water.
- Do not fill the water reservoir with hot water, as this may damage the unit. It is best to use water at room temperature or lower.
- Do not use the unit in very cold environments (below 41°F/5°C).
- Clean the unit by following the "CLEANING AND MAINTENANCE" procedure before operating.
Cleaning And Maintenance
To maintain fresh-tasting ice and keep the unit in optimal condition, Silonn recommends cleaning the unit once per week.
- Remove the ice basket.
- Clean the unit interior with a soft cloth soaked in warm water and vinegar. Rinse with clean water and then drain all the water.
- Clean the exterior of the unit with a soft damp cloth. Use a mild dishwashing soap if necessary.
Note:
- Do not use organic solvents, boiled water, detergent, strong acid, or strong alkali for cleaning.
- Empty the water reservoir and dry the interior if the unit will not be used for an extended period.
- Store the unit in a well-ventilated area.
Product Specifications
Specification | Details |
---|---|
Model | SLIM01R/SLIM01G1 |
Voltage/Frequency | 115V/60Hz |
Ice-making Current | 1.7A |
Ice-harvest Current | 2.0A |
Working Power | ≤160W |
Water Reservoir | 2L (0.53gal) |
Ice Basket Capacity | 1.32 lbs (0.6 Kg) |
Ice Making Rate | 26 lbs per day |
Ice Shape | Bullet |
Ice Size | Small or Large |
Material | ABS, PP |
Troubleshooting
PROBLEM | POSSIBLE CAUSES | SOLUTION |
---|---|---|
"ADD WATER" indicator turns on. | Lack of Water. | Stop the ice making cycle, fill water, and press the "ON/OFF/CLEAN" key again to restart the ice maker. |
"ICE FULL” indicator turns on. | Ice basket is full. Infrared light sensor does not work. | 1. Remove the ice from the basket. 2. Contact Silonn for assistance. |
Ice making cycle is normal but no ice is produced. | 1. Making ice takes too much time. 2. The water temperature is too low. | The room temperature should be 50°F –105°F, water temperature should be 40°F -90°F. |
Thank you again for choosing this Silonn product!
Silonn appreciates your product purchase. We hope you are as happy with the unit as we are in designing and manufacturing it for you. We strive to provide the best quality products and services in the industry. If you have any questions, please do not hesitate to contact Silonn.
Technical Support:
877-546-8603 Mon-Fri 8am - 8pm (CST)
Other Info:
support@silonnus.com