Home - Blaupunkt
Installation Guide for BLAUPUNKT models including: 2-IN-1 Vehicle Tracking System Dvr, GT320D
This manual is intended to familiarize the user with the device’s important functions. Read this carefully, prior to using the device. Keep this manual in an easily accessible location. In addition, do observe the instructions of the devices used in conjunction with this device. Attentions • • • • • • • • • • CAUTIONS ...
File Info : application/pdf, 12 Pages, 967.51KB
DocumentDocument2-IN-1 VEHICLE TRACKING SYSTEM with DVR GT320D Operating and Installation Instructions CAUTIONS Safety Notes This device has been manufactured according to established safety guidelines. However, dangers may still occur if the safety notes in this manual is not observed. This manual is intended to familiarize the user with the device's important functions. Read this carefully, prior to using the device. Keep this manual in an easily accessible location. In addition, do observe the instructions of the devices used in conjunction with this device. Attentions · This device is intended for installation and operation in a vehicle with 12V and 24V vehicle system voltage. · Please insert the micro SD card in the right direction to avoid damage to the card or the device. If device shows error message, please format the micro SD card from device menu. Please reset device or change micro SD card if similar error continues. Note : All files will be deleted when formatting micro SD card or firmware update, please backup the important files prior to that. When reset function is selected, the device will return to default setting. · Ensure bracket is installed correctly & firmly on windscreen to avoid damage to device and for better recording angle. · Weak signal or signal interference of device can arise from obstacle locations such as underground parking. · For abnormalities, please refer to the "Troubleshooting" section. Consult with Blaupunkt dealer for further assistance, in case if the problem cannot be resolved. This manual may be updated from time to time without any notice. Visit www.blaupunkt.com/ase for latest info. Disclaimer · Blaupunkt is not liable for any loss or damage caused or resulting from unauthorized disassembly or modification to the product. · In no event shall Blaupunkt be liable for any direct, indirect, punitive, incidental, special consequential damages to property or life and whatsoever arising out of or connected with the use or misuse of our products. · USA & CANADA: This product is not intended for sale in the United States and Canada. If purchased in the U.S. or Canada, this product is purchased on as-is basis. No warranty, whether expressed or implied is provided in the U.S. or Canada. · Please do not record or take picture facing sunlight. · To obtain clear image, please clean windscreen and device lens regularly. Avoid using device in dusty environment. · Handle device with care and avoid direct impact on the device. Avoid using device in high electromagnetic environment. · This device is NOT intended to be used for illegal purpose, surveillance and shall not be used in any form as evidence for claim purposes. · Some countries prohibit drivers from mounting anything on the windshield, or restrict mounting to specific areas of the windshield. It is the owner's responsibility to mount the device in compliance with local laws. · Keep the device away from children. · Keep the device away from flammable areas or liquids. · The device should be stored in dry and low humidity place. · Please operate the product within the temperature of -20°C ~ 80°C. Continuous exposure to sunlight, especially when locked in cabin where temperature exceeds 80°C may result to device malfunction, colour change, housing and image distortion. · Error may occur depending on the surrounding environment and the voltage of the car. · Blaupunkt is not liable/responsible for non-recorded event, missing files, etc. · Blaupunkt does not warrant the performance of the local telecommunication network used with our product. It is recommended to test for network compatibility prior to purchase. 1 STRUCTURE & FUNCTIONS Front Camera 1 23 4 5 67 T-Flash SD Rear Camera Functions 1. LCD Touch Screen 2. Reset Button 3. Power Button (On/Off ) 4. Front DVR Lens 5. DVR Bracket 6. T-Flash Card Slot 8 7. MicroSD card Slot 8. LED Light 9 9. Rear DVR Lens 2 SPECIFICATIONS · Real-time location and speed tracking · Historical tracking via wireless control app (Available on iOS and Google) · Real-time alarms notification: Acc On/Off, Geofence Entry/Exit, Power Disconnection, Overspeed · Real-time vehicle status report : Mileage, speed & overspeeding, parking · Operating Voltage : DC 9V-36V (Suitable for 12V & 24V vehicle) · Current : 10mA · Resolution : Front 2MP FHD 1920 x 1080 (30 fps); Rear 2MP HD 1280 x 720 (30fps) · Wide viewing angle : Front - 151°; Rear - 110° · 3" touch screen LCD display · Automatic park recording with smart motion/ time- lapse (24-hour park monitoring) · SOS for manual emergency alert broadcast, G-sensor, loop recording, low car battery voltage cut-off · Built-in microphone & speaker · Language : English, Simplified Chinese, Thai, Vietnamese · Support up to 32GB Micro SD, class 10 & above FUNCTIONS LIST OF THE DEVICE Vehicle Tracking System Functions Details Descriptions Vehicle Status Detection Acc On/ Off Uploaded data include the Acc On/ Off status each time in dynamic view. External Power Disconnection When the vehicle voltage is reached 11.8V, vehicle battery consumption is stopped, the tracking function will be disconnected. Alarm Low External Battery Vehicle battery voltage is between 5V to 10V. It is an Notification indicate that the vehicle battery is low. External Power Supply Power is supplied to the device. External Power Disconnection Power supply has been disconnected from the device. Enter Fence The vehicle enters the defined area set by user. Leave Fence The vehicle leaves the defined area set by user. Speeding Start Vehicle speed exceeds value set. Default is 120km/hr for 10 seconds. Vibration Alarm Vehicle vibration is experienced. The sensivity of collision Other Features detection can be adjusted (Low/Normal/High). SOS Start The SOS button is enabled by the user for emergency. Setting Video WiFi Date / Time Language Screensavers Frequency Format Default setting Version Resolution Image Loop Recording Record Audio Date Stamp G-sensor Quick Review Date Stamp DVR ON/OFF MM/DD/YY, According to the network or GPS English, Simplified Chinese, Thai, Vietnamese Off/1-min/3-min/5-min 50Hz/60Hz All data will be deleted. Backup data to prevent unwanted files from being deleted Restore setting to default setting PRL_DT45-V1.2.14 1080P 1920x1080 30FPS 720P 1280x720 30FPS Off/30s/1-min/3-min ON/OFF ON Off/ Low/ Medium/ High Off/2-sec/5-sec ON 3 WIRING DIAGRAM BLACK (Ground) YELLOW (DC12~24V) RED (ACC) OFF BATTERY TROUBLESHOOTING If any of the following problem occur, please resort to Troubleshooting for the possible solutions. Consult Blaupunkt authorized dealer if problem persist. Problems Weak or no GPS signal The device is not responding to SMS commands The device is not functioning Unable to record video Memory card cannot be regconized The videos are blurry and unclear Possible Causes Solutions GPS tracking device is not positioned Check the installation location of the device. properly. Ensure it is not being shielded by metal. SIM card has run out of credit. Top up the SIM card. Improper installation of SIM card. Check whether the SIM card has been slotted correctly. Check that the SMS command is correct. The connecting cable is loose or not Check if the connecting cable is connected to the connected properly. vehicle and the device properly. The vehicle's battery is low. Check the vehicle's battery level. The memory card is full. Check the remaining space on memory card, delete or format the files if necessary. Memory card is not inserted properly Ensure that the memory card has been inserted in the or it is damaged. correct direction. Replace it with a new memory card if it is damaged. The protective film on the lens is not Ensure that the protective film on the camera lens has removed. been removed. The camera lens or windshield is Do not touch the lens with fingers and ensure the covered with fingerprints or stains. windshield is clean. Improper installation location of the Check the installation location of the camera and adjust camera. the camera's viewing angle. 5 INSTALLATION INSTRUCTION Front Camera 1. Select an ideal installation location that without obstructing the driver's vision. Ensure that the front camera lens is located in the center of the windscreen. 4. Clean the preferred location on the windscreen before installing the device. M3M3M3M3M3M3M33MM3M3M3 3M 2. Slide the mount to the mount rail on the device. 5. Adjust the viewing angle against the preview screen to ensure that the camera is facing the front. 3. Remove 3M tape from the mount and bracket before joining them together. M3M3M3M3M3M3M33MM3M3M3 3M 6. Insert the microSD card into microSD card Slot & insert the T-Flash card to T-Flash Card Slot. Ensure the cards are in the correct direction before inserting them into the device. 7. It is recommended to place the GPS antenna on the top right of the windshield in order to keep a distance between the devices to prevent signal disruption. 6 OPERATION INSTRUCTION Rear Camera 1. Select an ideal installation location. a) Tail Light · Remove one side of the reverse light socket from its housing then remove the bulb from its socket. SOFTWARE OPERATION Wireless Control Application Search "Blaupunkt Tracker" on Google Play Store or iOS App Store to download the App. Home Page 1.0 Click on the menu button 2.0 Click to enter tracking interface. 1 · Connect the reverse light power cable to the camera, screwn the housing & camera back into position with a screwdriver. b) Hatch Handle · Use a screwdriver to remove the original hatch handle 2 · Mount the camera where the original hatch handle used to be 1.0 Menu c) Car Plate · Remove the rotating mount before installation. Drill an access hole for the camera cables · Mount the camera onto the acces hole & secure it in position with 3M tape/ screws 7 OPERATION INSTRUCTION 1.1 Setting 2.1 Tracking Details 2.0 Tracking · Click to enter tracking details interface. 2.1.1 Playback 8 OPERATION INSTRUCTION 2.1.2 Dynamic 2.1.4 Mileage Analysis & Report 2.1.3 Fence 2.1.5 Velocity Analysis & Report 9 Designed and engineered by Blaupunkt Competence Centre 1 351 19 002 18 01