MCombo Recliner with Ottoman Owner's Manual

Purchaser's Agreement

By accepting delivery of this product, you agree not to alter, modify, or remove any safety features. You also agree to accept any retrofit kits provided by MCombo to enhance safe use.

Contents

1. Safety Guidelines
2. Assembly Instructions
3. Care and Maintenance
4. Troubleshooting
5. Warranty
6. Return/Replacement Policy
7. MCombo Customer Support

I. Safety Guidelines

1. Mandatory

Read all safety and instruction thoroughly before use. Failure to follow guidelines can result in injury or product damage and void the warranty. Keep this manual for future reference.

2. Danger

• Keep plastic bags away from children to prevent suffocation.
• Do not allow children to play on or near the chair when in use, as serious injury or death could occur if a child is under the chair when it is in motion.
• Keep cords out of reach of small children and do not use where it may be a trip hazard.
• Plug directly into a wall outlet. Do not use an extension cord or adapter.
• Do not use this product if it is wet, in water, or around water or any liquid.
• Before moving or troubleshooting, unplug power cords and secure the mechanism to prevent unexpected movement.
• Avoid exposing the chair to burning cigarettes, cigars, open flames, or high temperatures.
• Do not operate the unit until the back is installed and locked.
• Do not attempt to disassemble or repair the actuator; there are no serviceable parts inside.
• Do not allow the electrical cord to be pinched between moving parts or between the frame and the floor.
• Do not place the cord under carpet or in a location where it could become worn.
• Do not attempt to disconnect the power plug by pulling the power cord; always hold the power plug and pull it out.
• Supervise children and disabled persons closely when they use this product.
• Keep children and pets away from openings and moving parts to reduce the risk of head entrapment and other injuries.
• Regularly check the condition of power supplies, electrical cords, plugs, and connectors. Keep them away from heat sources. Never operate the unit with a damaged power supply, cord, plug, or connector.
• Unplug the power cord immediately if you detect strange odors or fumes.
• The chair is intended for a single occupant not exceeding 330 pounds. Do not operate with more than one occupant.
• If you give this product to someone else, include this owner's manual.

3. Warning

• Weight Capacity: 330 lbs.
• INDOOR USE ONLY.
• To avoid tip over, do not put your weight against the back of the chair.
• Do not stand, sit, or place extra weight on the arms, back, or open footrest.
• Do not use this product if it is damaged. Do not use attachments or substitute parts.

4. Symbols Information

The symbols below represent labels used on the product to identify warnings, mandatory actions, and prohibited actions. It is important to read and understand these symbols. Do not remove these labels.

• [Read and follow manual]
• [Weight capacity: 320 lbs]
• [Do not connect extension cord]
• [Keep pets away from chair base]
• [Electrical Hazard]
• [Indoor Use Only]

5. Disclaimer

Read and understand this manual before using your MCombo Product. MCombo is not responsible for any damage or injury incurred due to improper or unsafe use, or any use that does not comply with applicable laws.

6. Pre-Assembly Introduction

Teamwork/2-People Recommended

Always have at least two people to help with transporting and assembling the product to avoid potential injury and/or damage.

Avoid Scratches

Use cardboard or carpet area when assembling the product to prevent scratches.

Level & Flat Surface

Make sure the product rests on a flat and level surface so that each leg touches the floor evenly.

An Allen Wrench is included for installation. Phillips screwdriver is not included.

II. Assembly Instructions

Notice

• Please read these instructions thoroughly before using.
• Do not plug the power supply in until assembly is complete.
• Contact MCombo Customer Support immediately if anything is missing or damaged.

1. Product Parameters

Part List

Parts for Ottoman

• Ottoman Cushion (A*1PC)
• Ottoman Legs (B*2PCS)
• Round Ottoman Base (C*1PC)
• Ottoman Brackets (D*2PCS)

Parts for Recliner

• Back Cushion (E*1PC)
• Seat Cushion (F*1PC)
• Chair Legs (G*2PCS)
• Round Chair Base (H*1PC)

Arm Assembly Parts

• Right Arm (I*1PC)
• Left Arm (J*1PC)

Other Parts

• Lumbar Pillow (K*1PC)
• Remote Control (L*1PC)
• Adapter (M*1PC)

Hardware List

• Bolt M8*70mm (N*2PCS)
• Bolt M8*38mm (O*10PCS)
• Bolt M8*25mm (P*2PCS)
• Washer 13*35*2mm (Q*4PCS)
• Flat Washer 8*22*2mm (R*2PCS)
• Nuts M8 (S*2PCS)
• Bolt M6*25mm (T*2PCS)
• Bolt M6*20mm (U*10PCS)
• Bolt M5*10mm (V*2PCS)
• Allen Wrench M8 (W*1PC)
• Allen Wrench M6 (X*1PC)
• Spanner (Y*1PC)

Assembly of Ottoman

Step 1

1. Use 4 Bolts #O and 4 Washers #U to fix 2 Ottoman Legs #B to Round Ottoman Base #C. Tighten with Allen Wrench #W.
2. Attach the two Brackets #D to the Ottoman legs #B as shown.

Step 2

Turn over the Ottoman Cushion #A and use 2 Bolts #R to fix Ottoman Brackets #D to Ottoman Cushion #A.

Assembly of Chair

Assembly of Chair Base

Step 3

1. Use 6 Bolts #O and 6 Washers #U to attach 2 Chair Legs #G to Round Chair Base #H.
2. Tighten the bolts with Allen Wrench #W.

Note: The black rod protruding from the black iron bar on Chair Legs should face inwards.

Assembly of Seat Cushion

Step 4

Insert the bolts protruding from both sides of the Seat Cushion #F into Washers #T and the protruding black rod on the inside of the Chair Legs #G, reinforced with Bolts #S.

Assembly of Chair Back

Step 5

1. Align the holes in iron plates on Back Cushion #E with iron plates on Seat Cushion #F.
2. Fix Nuts #V and Bolts #P with Spanner #Y and Allen Wrench #W.

Step 6

1. Align the holes in the iron sheet of the armrest with the holes on both sides of the Back Cushion #E.
2. Use 2 Bolts #N to attach the Back Cushion to the Seat Cushion and tighten the bolts with Allen Wrench #X.

Assembly of Chair Arms

Step 7

Use Bolts #Q to install Right & Left Arm on the thin armrest plate.

Step 8

Power Cord #M: Connect the two black connectors.
Remote Control #L: Connect the two black connectors.
Vibrating Cord: Connect the two white connectors on the back cushion and seat cushion.

Congratulations!

Now you have installed it. Relax your body on this chair and decorate your living room.

III. Care and Maintenance

Your MCombo product will provide years of superior performance and satisfaction with regular care and maintenance. Please follow the guidelines and cleaning procedures below.

Notice

• Do not place your chair in direct sunlight, as sunlight causes fading.
• Do not smoke cigarettes while seated in or using your chair.
• Avoid extreme changes in temperature by arranging the chair away from radiators, heat, and air vents.
• Do not use solvent-type cleaners to spot clean.
• Do not saturate fabric.
• Be careful that pet scratches may cause fabric or leather to break.

1. Fabric Care

• Inspect the fabric regularly for any pulls, tears, or gaps.
• Frequent vacuuming or light brushing with a nonmetallic, stiff bristle brush is recommended to remove dust and grime.
• When liquid spills onto the fabric, immediately wipe off spills with a dry or lightly dampened clean white cloth, sponge, or paper towel.

2. Electronics Care

• Inspect all wiring harnesses to ensure they are not damaged or stuck under the chair.
• Keep all electronics free from moisture and temperature extremes.
• Check electrical components frequently for signs of corrosion and replace as necessary.
• Contact MCombo Customer Support if damage is present; do not attempt to fix it yourself.

3. Faux Leather Care

• Never use detergents, polishes, preservers, saddle soap, abrasive brushes, or scrubbers, as they can remove natural oils.
• Dust, vacuum, or wipe leather regularly with a clean, dry microfiber cloth for routine maintenance.
• Do not place in direct sunlight; it will lighten or discolor leather over time.
• If spills occur, immediately soak up any liquids with an absorbent cloth and allow to air dry. For thorough cleaning, consult a leather specialist.
• For more stubborn dust, dampen the cloth with distilled water. Ensure the cloth is not soaking wet. Never let water soak into leather.

4. Wood Base Care

• Keep the wood base away from fireplaces, heating and cooling vents, moisture sources (like humidifiers), and direct sunlight.
• Daily exposure to heat or sunlight may fade wood finishes and dry the wood, which can create cracks over time.

5. Metal Care

• Avoid bumping and handle gently when moving.
• Avoid touching hard metal parts (like fruit knives, keys) to prevent scratches.
• Do not fold too fast to ensure the folded part is not damaged.
• Avoid direct exposure to sunlight to prevent paint discoloration, dry cracking, peeling of colored paint layers, oxidation, and deterioration of metal.
• Avoid placing chairs in damp places. Avoid cleaning metal furniture with boiling water; wipe with a damp cloth, but do not rinse with running water.

6. Disposal & Recycling

Dispose of your power recliner sofa according to applicable local and national statutory disposal regulations. Contact your local waste disposal agency for information on proper disposal of packaging, metal/wood frame components, fabric, and electronic components.

IV. Troubleshooting

The following troubleshooting FAQs summarize common issues. If you are uncomfortable performing these steps, contact MCombo Customer Support.

V. Warranty

Notice

• MCombo can provide replacement service for products beyond the limited manufacturer warranty period and scope, but a basic charge will apply.
• The warranty applies only to MCombo products and does not include accessories or enhancements.
• Warranties are valid only in the 48 contiguous United States and are contingent upon the consumer operating the product according to the instruction manual.

Consumer Warranty Limitations and Exclusions

All warranties begin on the date of delivery and are valid for the original purchaser from MCOMBO® only.

MCOMBO® will replace defective parts or send replacement products provided the parts have not been subjected to misuse, abuse, or improper service, including damaged wires due to negligence or improper operation.

Exclusions also include components with damage caused by:

• Contamination
• Abuse, misuse, accident, or negligence
• Commercial use or use other than normal
• Improper operation, maintenance, or storage

VI. Return/Replacement Policy

Notice

Why don't we recommend returning the item by yourself?

• Huge cost - UPS/FedEx oversize fee.
• Need you to take the box to UPS/FedEx facility.

Return/Replacement Policy

MCOMBO® offers a 30-day return/replace policy. During this time, MCOMBO® will cover the shipping cost of return and replacement for defective and damaged products by providing a pre-paid return label or pick-up service.

NOTE:

• Keep the original packaging for returns. If not available, new packaging must meet UPS/FedEx size standards: (width + height) * 2 + length < 128 inches.
• Disassemble the product before returning to avoid oversized costs.
• Do not purchase return labels for damaged/defective products yourself.
• Contact us immediately if you have any problems with returns for assistance.
• Customers are responsible for freight costs unless the chair is defective. Chairs returned due to refused delivery or being undeliverable are subject to a 20% restocking fee.

VII. MCOMBO Customer Support

If you have any questions or suggestions, please refer to the following contact information. We will do our best to assist you.

• Email: sales@mcombo.com (Respond within 24 hours)
• Phone: 1-323-597-1109 (8:00 a.m. - 4:00 p.m. Monday-Friday, PST)

Contact Locations:

• California: 2808 Vail Ave, Commerce, CA, 90040, 1-323-597-1109
• Tennessee: 3980 PREMIER AVE, MEMPHIS, TN, 38118
• Delaware: 2411 Bear Corbitt Rd STE 1, New Castle, DE, 19720