Panasonic LEICA DG VARIO-ELMARIT 12-60mm f/2.8-4.0 ASPH. POWER O.I.S. Interchangeable Lens

Introduction

Please read these instructions carefully before using this product, and save this manual for future use. This lens is compatible with digital cameras featuring the "Micro Four Thirds™ System" mount standard. It cannot be mounted on cameras with the Four Thirds™ mount specification. For support and questions, visit: USA: http://shop.panasonic.com/support; Canada: www.panasonic.ca/english/support (English) / www.panasonic.ca/french/support (French). Register online at http://shop.panasonic.com/support (U.S. customers only). Manufacturer: Panasonic Corporation of North America, Two Riverfront Plaza, Newark, NJ 07102-5490. Canadian Distributor: Panasonic Canada Inc., 5770 Ambler Drive, Mississauga, Ontario L4W 2T3. © Panasonic Corporation 2017. Printed in China.

Regulatory Information

For U.S.A. (FCC Note): This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. Operation is subject to two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Responsible Party: Panasonic Corporation of North America.

For Canada: CAN ICES-3(B)/NMB-3(B).

Information for Your Safety

• Keep the unit away from electromagnetic equipment (microwaves, TVs, video games, radio transmitters, high-voltage lines).
• Avoid using the camera near cell phones to prevent noise interference.
• If the camera malfunctions due to electromagnetic interference, turn it off, remove the battery/AC adapter, then reinsert/reconnect and turn it on.

Lens Care and Precautions

This lens features dust-proof and splash-proof construction. Use with compatible dust-proof and splash-proof digital cameras.

General Care:

• When detaching the lens, prevent sand, dust, or water from entering the lens or terminals.
• The lens is not waterproof; do not use underwater. Wipe with a soft dry cloth if splashed.
• A lens mount rubber is used for dust/splash resistance. It may mark the camera body mount, which does not affect performance.
• Do not press the lens with excessive force.
• Clean lens surfaces with a soft, dry cloth to remove dirt, water, oil, or fingerprints.
• Attach the lens rear cap when not in use to prevent dust entry.
• Do not place the lens with its mount surface facing down to protect contact points. Keep contact points clean.

About Condensation (Fogging): Condensation can occur due to temperature and humidity differences (e.g., moving from cold outdoors to warm indoors, or from air conditioning). This can cause dirt, mold, or malfunction. ? Note: If condensation occurs, turn off the camera and leave it for about two hours to acclimatize.

Cautions for Use:

• Avoid dropping, knocking, or applying excessive pressure to the lens.
• Do not drop the bag containing the lens.
• When carrying the camera with the lens attached, hold both securely.
• Keep the lens away from pesticides and volatile substances, as they can damage the exterior or paint.
• Do not point the lens at the sun or strong light sources, as this can cause overheating and fire.
• Avoid storage in direct sunlight, high temperatures/humidity, dusty/sandy environments, near heaters/air conditioners/humidifiers, wet locations, or inside vehicles.
• Store with a desiccant (silica gel) if not used for a prolonged period to prevent mold.
• Do not leave the lens in contact with rubber or plastic products for extended periods.
• Do not touch the lens contact points.
• Do not disassemble or alter the unit.
• In cold environments (below 0°C / 32°F), prolonged direct contact with metal parts may cause skin injury. Use gloves.
• Do not use benzine, thinner, alcohol, or similar cleaning agents on the lens glass or exterior, as they can cause damage or paint peeling. Use a soft, dry cloth for cleaning.

Supplied Accessories

Product numbers are subject to change.

• Lens Pouch
• Lens Cap
• Lens Rear Cap
• Lens Hood

The lens rear cap and lens cap are attached to the lens at the time of purchase.

Names and Functions of Components

Refer to the illustrations for numbered parts:

• 1 Lens surface: The front glass element.
• 2 Focus ring: Rotate to focus when using manual focus (MF).
• 3 Zoom ring: Rotate to adjust focal length for telephoto (large) or wide-angle (wide) shots.
• 4 [O.I.S.] switch: Activates/deactivates the Optical Image Stabilizer function. Recommended to set to [OFF] when using a tripod.
• 5 [AF/MF] switch: Switches between Auto Focus (AF) and Manual Focus (MF). Manual Focus is enabled if either the lens switch or camera setting is set to [MF].
• 6 Lens fitting mark: Align with the camera body's mount mark for attachment.
• 7 Contact points: Electrical contacts for communication between lens and camera.
• 8 Lens mount rubber: Seals the lens mount against dust and moisture.

Attaching and Detaching the Lens

Refer to your digital camera's owner's manual for detailed instructions.

• Ensure the digital camera is turned OFF before attaching or detaching the lens.
• To attach: Remove the lens rear cap by rotating it in the direction of the arrow. Align the lens fitting mark on the lens with the corresponding mark on the camera body and rotate until it clicks.
• To detach: Ensure the camera is off. Press the lens release button on the camera body and rotate the lens in the direction of the arrow to detach.
• Always attach the lens cap or rear cap after detaching the lens to prevent dust entry.

Attaching Filters

• Vignetting may occur if using two or more filters simultaneously.
• The lens cap can be attached with a filter already mounted.
• When using the lens hood and a filter, attach the filter first.
• Conversion lenses or adapters cannot be attached to this lens. Filters can be used, but other attachments may damage the lens.

Attaching the Lens Hood

Align the alignment mark on the lens hood with the mark on the tip of the lens. Rotate the lens hood in the direction of the arrow until it clicks. Then, align the second mark on the lens hood with the mark on the tip of the lens.

To remove: Rotate the lens hood in the direction of the arrow while pressing the release button on the hood.

To store temporarily: Align the storage mark on the lens hood with the mark on the tip of the lens and rotate until it clicks into place.

? Note: When using the flash with the lens hood attached, the lower part of the screen may darken (vignetting), and flash control may be affected. Detaching the hood is recommended in such cases.

Troubleshooting

Symptom: A sound is heard when the camera is turned on/off or when taking a picture of a bright subject.

Cause: This is the sound of lens or aperture movement and is not a malfunction.

Symptom: Autofocus sounds may be recorded during motion picture recording in quiet situations.

Solution: Switch to Manual Focus (MF) or set the O.I.S. switch to [OFF] and use a tripod if O.I.S. sounds are bothersome during video recording.

Specifications

Specifications are subject to change without notice.

Limited Warranty

For U.S.A. Only: Panasonic Corporation of North America warrants this product against defects in materials or workmanship for the period specified (Parts: 1 Year, Labor: 1 Year for Interchangeable Lens; 90 Days for Accessories; 10 Days for Non-Rechargeable Batteries). This warranty covers repair, replacement, or refund at the warrantor's option. It excludes normal wear and tear, cosmetic damage, and damages from misuse, accidents, unauthorized service, etc. Proof of purchase is required.

For Canada Only: Panasonic Canada Inc. warrants this product against defects in materials or workmanship under normal use for one (1) year from the date of original purchase (parts and labor) for Interchangeable Lenses. This warranty covers repair, replacement, or refund at Panasonic Canada Inc.'s option. It excludes normal wear and tear, cosmetic damage, and damages from misuse, accidents, unauthorized service, etc. Proof of purchase is required. Rechargeable batteries are warranted for ninety (90) days.

For warranty service and support, visit: http://shop.panasonic.com/support (USA) or www.panasonic.ca/english/support (Canada).