DOMUS
29-31 Richland St. Kingsgrove. Sydney NSW 2208 Australia
Phone: 02 9554 9600 | Fax: 02 9554 9433
Email: enquiries@domuslighting.com.au | Website: www.domuslighting.com.au
Installation Manual
MILEY-10 Wall Light
Date: May 20, 2022
Product Details
- Product Name: MILEY-10 Wall Light
- Variants: Black (Item No. 22664), White (Item No. 22665)
- Colour Temperature Options: TRIO (Multiple CCTs available)
Thank you for purchasing your new MILEY-10 Wall Light. Please take the time to read and understand the instruction sheet below. Failure to do so may void warranty.
Specifications
| Voltage: | 240V | Lumen (±5%): | Warm White 3000K - 350lm Neutral White 4000K - 375lm White 5700K - 400lm | Dimmable: | No |
| Power: | 10W | Beam Angle: | 30° | Operating Temp: | -20° C ~ 45° C |
| IP Rating: | 65 | CCT: | 3000K - 4000K - 5700K | Power Factor: | 0.9 |
| CRI: | ≥90 | Lifespan: | 50,000hrs |
Installation Instructions
Preparation and Mounting
Gather necessary tools: a drill [drill], screwdriver [screwdriver], and hammer [hammer].
Mark the desired mounting location on the wall. Use the drill [drill] to create pilot holes according to the mounting bracket template.
Secure the mounting bracket to the wall using appropriate screws and wall plugs, potentially using a hammer [hammer] to seat the plugs.
Electrical Connections
Important: Ensure the main power supply is switched OFF before proceeding.
Connect the electrical wiring to the terminals on the light fixture's base or mounting plate. The terminals are typically labeled:
- L: Live (Brown or Black wire)
- N: Neutral (Blue or White wire)
- Earth: Ground (Green or Green/Yellow wire)
Refer to the diagram for correct wire placement.
Fixture Attachment and CCT Selection
Attach the MILEY-10 light fixture to the mounted bracket. Ensure it is securely fastened.
Select the preferred colour temperature (CCT) for the light. The MILEY-10 supports TRIO options, allowing selection between Warm White (3000K), Neutral White (4000K), and White (5700K).
Important Notes
- The lamp must be installed by a professional electrician.
- Ensure the power supply is switched off before fitting this product.
- Do not touch the lamp when it is in use, as it may be hot.
- Keep the fixture away from hot steam and corrosive gases.
