Olight Seeker 2 User Manual
Introduction
Thank you for purchasing this Olight Product. Please read this manual carefully before use.
In the Box
- Seeker 2 (with Battery)
- USB Magnetic Charging Cable (MCC1A)
- Lanyard
Specifications
Mode | Lumens | Runtime | Throw | Candela |
---|---|---|---|---|
TURBO | 3,000 | 3+155mins | 220m | 12,100cd |
HIGH | 1,200 | 110+50mins | 135m | 4,550cd |
MEDIUM | 300 | 13h | 68m | 1,150cd |
LOW | 50 | 72h 28m | 28m | 190cd |
MOON | 5 | 15days | 10m | 25cd |
Body Material: AL6061-T6 aluminum alloy.
Waterproof: IPX8 (2m)
Impact Resistance: 1.5m
Dimensions: (L)4.96 x (D)1.38in / (L)126 x (D)35mm (Including Battery)
Weight: 185g / 6.53oz
* All performance measurements in accordance with ANSI/NEMA FL1-2009 standards.
* The minimum output at Turbo and high mode is 600 lumens.
Product Overview
- Side Switch
- Battery Level Indicator
- TIR Optic Lens
- Magnetic Tailcap
- Lanyard Hole
Before First Use
Unscrew the tailcap and remove the insulating film from the battery compartment.
Battery Level Indicator
Note: Under moonlight mode, the indicator will not turn on when battery power is above 10%. When battery power is less than 10%, the indicator will light up red or blink red.
Charging
Connect the magnetic USB end of the charging cable (MCC1A) to an external USB power source, then attach the other end to the charging port on the flashlight. Full charging takes no more than 6 hours.
Please fully charge the product before first use.
How to Operate
ON/OFF
Single click the side switch to turn the light on/off. When turned on, it returns to the previously selected brightness level (memorized modes: moonlight, low, medium, high. Turbo is memorized as high. Strobe is not memorized).
Change Brightness Level
When the flashlight is on, press and hold the side switch to automatically cycle through moonlight, low, medium, high, and back to low. Release the switch to select the desired mode.
Moonlight Mode
When the flashlight is off, press and hold the side switch for about one second to access moonlight mode. If moonlight was the last memorized mode, a single click will activate it.
Direct Access to Turbo
Quickly double-click the side switch to enter Turbo mode. Double-click again to exit Turbo mode. If the memorized mode was High, exiting Turbo switches to Medium. If the memorized mode was Medium, Low, or Moonlight, exiting Turbo returns to the previously memorized mode.
Strobe Mode
When the flashlight is on, triple-click the side switch to activate strobe mode. Single-click or press and hold the switch to exit.
Timer
The Seeker 2 has a long (9 minutes) and short (3 minutes) timer for automatic shut-off. With the flashlight on, double-click and hold the side switch at the current brightness level to access timer settings. A single blink indicates the short timer; two blinks indicate the long timer. The flashlight will turn off automatically when the timer expires. After setting the timer, double-click and hold the switch to change timer settings. If the timer expires and you re-enter timer settings, it will revert to the last set timer.
Lockout/Unlock
When the flashlight is off, press and hold the side switch (for about 2 seconds) to access lockout mode. The flashlight will briefly enter moonlight mode before switching off to signal lockout. In lockout mode, pressing the switch for less than one second will briefly illuminate a red indicator below the switch. To unlock, press and hold the switch for over one second until moonlight mode is activated.
Safety Precautions
⚠️ DANGER
- Do NOT throw the light directly into human eyes. This may cause temporary blindness or permanent damage.
- Do NOT cover the light head when the flashlight is on, or place the flashlight head on the ground. The radiation energy may damage the flashlight or cause burning to flammable objects.
- Do not separate the battery from the flashlight. The included rechargeable battery has extremely strong discharge power; short-circuiting the battery may lead to overheating, combustion, or unexpected disasters.
- The battery can only be charged while installed in the flashlight. Use the provided charger or a compatible Olight charger.
❗ WARNING
- Keep out of reach of children.
- When the flashlight is operating on high mode, the surface temperature can reach 50°C. Please switch off the flashlight temporarily or turn it to low mode.
- If the light is to be stored or transported for a long time, unscrew the tailcap for half a circle to cut off the circuit.
- Do not use turbo mode continuously when the environmental temperature is high to prevent the flashlight body from becoming too hot to hold.
- Ensure the battery is inserted with the negative (-) end pointing towards the head of the flashlight (LED side).
- Store the battery with care. If the battery needs to be changed, take good care of the removed battery and do not mix it with conductive metals.
? NOTICE
- When the flashlight is turned off, the current mode will be memorized. Memorized modes are: moonlight, low, medium, and high. High mode is memorized for 10 minutes before reverting to medium mode. If turned off on turbo mode, high mode is memorized instead and will also revert to medium after 10 minutes; turbo mode cannot be memorized.
- Turbo mode will stay on for 2 minutes and then step down to high mode within a minute.
- Moonlight and turbo modes are not normal brightness levels. Under these modes, press and hold the switch to enter the normal brightness level cycle.
Warranty
- Within 30 days of purchase: Contact the original seller for repair or replacement.
- Within 5 years of purchase: Contact Olight for repair or replacement.
- Battery Warranty: Olight offers a one-year warranty for all rechargeable batteries.
This warranty does not cover normal wear and tear, modifications, misuse, disintegration, negligence, accidents, improper maintenance, or repair by anyone other than an Authorized retailer or Olight itself.
Contact & Compliance
EU-Declaration of Conformity: https://olightworld.com/ec-declaration
USA Customer Support: cs@olightstore.com
Global Customer Support: Customer-service@olightworld.com
Visit www.olightworld.com to see our complete product line of portable illumination tools.
Company: Dongguan Olight E-Commerce Technology Co., Ltd
Address: 4th Floor, Building 4, Kegu Industrial Park, No 6 Zhongnan Road, Changan Town, Dongguan City, Guangdong, China.
Model/Document ID: 3.0036.6010.9003 D. 05. 06. 2020
Made in China