70mai A200 Dash Cam User Manual

Introduction

Dear customer, Thank you for purchasing our product. Please read the following instructions carefully before first use and keep this user manual for future reference. Pay particular attention to the safety instructions. If you have any questions or comments about the device, please contact the customer line.

Contact: www.alza.co.uk/kontakt, +44 (0)203 514 4411

Importer: Alza.cz a.s., Jankovcova 1522/53, Holesovice, 170 00 Praha 7, www.alza.cz

Product Overview

The product includes the following components:

• 1. Display screen
• 2. Function buttons
• 3. Power button
• 4. Power port
• 5. Rear camera port
• 6. Memory card slot
• 7. Camera
• 8. Speaker
• 9. Mount slot
• 10. Microphone
• 11. Indicator light
• 12. Adhesive sticker

Note: Illustrations of the product, accessories, and user interface in the user manual are for reference purposes only. The actual product and functions may vary due to product enhancements.

Download 70mai app

This product may be used in conjunction with the 70mai app. You can download and install the app by scanning the QR code or searching for “70mai” in your phone's app store.

Note: Android 5.0 or iOS 11.0 or above is required to connect to the dash cam's Wi-Fi hotspot with a mobile phone.

Package Contents

If you purchased the dash cam only, check the following items in the package:

• Dash cam
• Mount
• Power cord
• Car charger
• Electrostatic sticker ×2
• Adhesive sticker
• Wiring trim tool

If you purchased the dash cam set, check the following items in the package:

• Dash cam
• Mount
• Power cord
• Car charger
• Electrostatic sticker ×2
• Adhesive sticker
• Wiring trim tool
• Rear camera package*

*This package contains the rear camera (integrated with lead wire), signal wire and other accessories for the rear camera. For more information, please refer to the rear camera user manual.

Installation

First, install the electrostatic sticker. Paste the electrostatic sticker on the recommended area of the front windshield. Press the sticker to remove air bubbles out. Avoid the edge of the windshield and select the flat and smooth area for the installation.

Note: Keep the windshield clean and dry without liquid residue to prevent the sticker from losing adhesion and dash cam from dropping.

Next, install the mount. Attach the mount to the mount slot and slide up.

Install the memory card. Insert the memory card into the memory card slot.

Mount the dash cam. Paste the dash cam onto the electrostatic sticker.

Route the cables. Route the power cord to the vehicle's power outlet and connect to power. Start the car engine and the dash cam will automatically turn on.

Finally, adjust the camera angle. Adjust the camera angle based on the image presented on the main screen when dash cam is turned on.

Specifications

Memory Card Instructions

A memory card (sold separately) must be installed in the dash cam before use.

• The dash cam supports standard microSD cards. Please use memory cards with capacity of 32GB ~ 128GB and rating of class 10, U1 or higher.
• The default file partition format of the memory card may be inconsistent with the format supported by the dash cam. When inserting the memory card for the first time, please format it in the dash cam before use. Formatting the memory card will delete all files on the card. Please back up important data to another device beforehand.
• The memory card may become damaged or deteriorated after repeated cycles of overwriting, and this may affect its ability to save video and image files. If this occurs, immediately replace it with a new memory card.
• Please use a high-quality memory card purchased from a reputable vendor. Inferior memory cards may have issues such as actual reading/writing speeds that do not match the stated speeds, and an actual storage capacity that does not match the stated storage capacity. The manufacturer shall not be held liable for lost or damaged videos caused by the use of a low quality memory card.
• Do not insert or remove a memory card while the dash cam is turned on.

Precautions

Before using this dash cam, please read all the precautions and user guide to ensure correct and safe use.

• This dash cam is a driving aid designed to record external images of the vehicle. It does not have the function of ensuring the user's driving safety. Users must abide by local traffic rules and regulations and take driving safety as a priority consideration. Do not operate this product while driving.
• Due to differences in vehicle conditions, driving style, driving environment, and other factors, some functions may not work properly. A power failure, usage in environments outside the normal operating temperature or humidity range, a collision, or a damaged memory card may cause the dash cam to function abnormally. There is no guarantee that this dash cam will function normally under all circumstances. Videos recorded by this dash cam are for reference purposes only.
• Please install this dash cam correctly, and do not block the driver's line of sight, or block the vehicle's airbag, in order to avoid product failure or personal injury.
• If the front windshield where the dash cam is installed is covered with coloured automotive film, it may affect the video recording quality or cause video distortion.
• Avoid collisions or forceful jolts to the dash cam, otherwise the product may malfunction. Keep this dash cam away from any strong magnetic fields.
• Never use chemical solvent or detergent to wash the dash cam.
• Do not use this dash cam in environments with temperatures over 60°C or below -10°C.
• When the dash cam has been operating for a period of time, the temperature of the outer casing will rise, please be careful when touching.
• Please only use this dash cam within the scope permitted by law.
• Please use the included car charger, power cord, and other accessories in order to avoid product failure due to non-conformance. The manufacturer shall not be held liable for any loss or damage caused by the use of a non-genuine car charger or power cord.
• If you use power adapter to charge the dash cam, only use the power adapters that comply with the local safety standards or certified and supplied by qualified manufacturers.
• The dash cam and its accessories may contain small parts. To avoid choking or other hazards or damages caused by the children, keep the dash cam out of the reach of children.

Cautions

• Do not dispose of a battery in fire or a hot oven, or mechanically crush or cut the battery, as that can result in an explosion.
• Do not leave a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas.
• A battery subjected to extremely low air pressure may result in an explosion or the leakage of flammable liquid or gas.
• This device is equipped with a built-in battery that cannot be removed or replaced. Do not disassemble or modify the battery by yourself.
• Replacement of a battery with an incorrect type can defeat a safeguard (for example, in the case of some lithium battery types).

Warranty Conditions

A new product purchased in the Alza.cz sales network is guaranteed for 2 years. If you need repair or other services during the warranty period, contact the product seller directly, you must provide the original proof of purchase with the date of purchase.

The following are considered to be a conflict with the warranty conditions, for which the claimed claim may not be recognized:

• Using the product for any purpose other than that for which the product is intended or failing to follow the instructions for maintenance, operation, and service of the product.
• Damage to the product by a natural disaster, the intervention of an unauthorized person or mechanically through the fault of the buyer (e.g., during transport, cleaning by inappropriate means, etc.).
• Natural wear and aging of consumables or components during use (such as batteries, etc.).
• Exposure to adverse external influences, such as sunlight and other radiation or electromagnetic fields, fluid intrusion, object intrusion, mains overvoltage, electrostatic discharge voltage (including lightning), faulty supply or input voltage and inappropriate polarity of this voltage, chemical processes such as used power supplies, etc.
• If anyone has made modifications, modifications, alterations to the design or adaptation to change or extend the functions of the product compared to the purchased design or use of non-original components.

EU Declaration of Conformity

The manufacturer hereby, declares that this equipment is in compliance with the applicable Directives and European Norms, and amendments. The full text of the EU declaration of conformity is available at the following internet address: https://help.70mai.asia/1193.html

[CE Mark]

WEEE

This product must not be disposed of as normal household waste in accordance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE - 2012/19 / EU). Instead, it shall be returned to the place of purchase or handed over to a public collection point for the recyclable waste. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. Contact your local authority or the nearest collection point for further details. Improper disposal of this type of waste may result in fines in accordance with national regulations.

[WEEE Symbol]