Personal Information Security
To ensure the safety of you and your family, please make sure that your product is only bound by authorized persons. Botslab will take strict measures to ensure the security of your and your family's information.
Product Disposal and Recycling
This symbol indicates that the product must be disposed of as household waste and should be taken to an appropriate recycling organisation for recycling. Proper disposal and recycling helps to protect natural resources, human health, and the environment. For more information on the disposal and recycling of this product, please contact your local municipality, disposal service, or the shop where you purchased this product.
INGESTION HAZARD
This product contains a button cell or coin battery.
- Ingestion may cause death or severe injury.
- A swallowed button cell or coin battery can cause internal chemical burns in as little as 2 hours.
- Keep new and used batteries OUT OF REACH OF CHILDREN.
- Seek immediate medical attention if it is suspected that a battery has been swallowed or inserted into any part of the body.
Battery Handling and Disposal:
- Remove and immediately recycle or dispose of used batteries according to local regulations and keep them away from children.
- Do NOT dispose of batteries in household trash or incinerate them.
- Even used batteries may cause severe injury or death.
- Call a local poison control center for treatment information.
- Battery type: ML621.
- Nominal battery voltage: 3V.
- The product contains a button/coin cell battery that cannot be replaced by the user.
- Do not force discharge, recharge, disassemble, heat above 60℃, or incinerate. Doing so may result in injury due to venting, leakage, or explosion resulting in chemical burns.
Warranty Information
In regards to service policies within the warranty period of the Botslab dash cam:
- This product has a two-year warranty. For detailed information on warranty services, please contact your local authorized dealer.
- Non-electronic accessories are not covered by the warranty.
Regulatory Conformance
FCC Regulatory Conformance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
- This device may not cause harmful interference.
- This device must accept any interference, including interference that may cause undesired operation.
NOTE: This device has been tested and found to comply with Part 15 of the FCC Rules, and is designed to meet the requirements of a Class B digital device. This means that it is intended to provide reasonable protection against harmful interference in a residential installation.
This equipment is capable of generating and using radio frequency energy, and if not installed and used in accordance with the instructions provided, may cause harmful interference to radio communications. It is important to note that there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to take one or more of the following measures to correct the interference:
- Reorient or relocate the receiving antenna.
- Increase the distance between the equipment and receiver.
- Connect the equipment to an outlet on a circuit that is different from the one to which the receiver is connected.
- Seek help from the dealer or an experienced radio/TV technician.
It is important to note that the manufacturer cannot be held responsible for any radio or TV interference caused by unauthorized modifications made to this equipment. Please be aware that such modifications may void the user's authority to operate the equipment.
RF Exposure (FCC)
This equipment conforms to the radiation exposure limits set by the FCC for use in an uncontrolled environment. To ensure safe operation, it is recommended to maintain a minimum distance of 20 cm between the device and your body. Do not operate this transmitter in conjunction with any other antenna or transmitter.
IC Regulatory Conformance
This device complies with CAN ICES-003 (B)/NMB-003(B).
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the following two conditions:
- this device may not cause interference, and
- this device must accept any interference, including interference that may cause undesired operation of the device.
RF Exposure (IC)
This equipment complies with IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
CE Regulatory Conformance
EU Regulatory Conformance:
RF exposure information: The Maximum Permissible Exposure (MPE) level has been calculated based on a distance of 20cm between the device and the human body. To comply with RF exposure requirements, it is recommended to use the product while maintaining a distance of 20cm between the device and the human body.
CE DOC
Hereby, Botslab Inc. declares that the radio equipment type DC-BD08-M5 is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet address: https://global.botslab.com
Manufacturer Information
Company name: Botslab Inc.
Address: 919 North Market Street, Suite 950, Wilmington, New Castle, Delaware, USA
Operation temperature: -20~60℃
Battery charging temperature: 10-45℃
Operation frequency (Max power):
- WiFi 2.4G: 2412-2472MHz (＜17.0dBm)
- WiFi 5G: 5745-5825MHz (＜13dBm)
- Bluetooth: 2402-2480MHz (＜8.0dBm)
