Product Information
This errata applies to the following product:
- MPC5777C
Key mask-specific details:
- Major mask revision number: 1
- Minor mask revision number: 0
- JTAG identifier: 0x1837_701D
Errata Summary
The following table lists the identified errata with their respective IDs and titles. Detailed descriptions and workarounds are provided in subsequent sections.
| Erratum ID | Erratum Title |
|---|---|
| e6990 | CJTAG: possible incorrect TAP state machine advance during Check Packet |
| e10439 | CMU: CMU_0 OLR is set out of reset when XOSC used in 8 mhz mode, due to wrong RCDIV reset value |
| e7116 | CRC: AutoSAR 4.0 8-bit CRC8 0x2F is not supported in hardware |
| e8251 | DECFIL: timestamp may be lost in edge trigger mode |
| e9783 | DSPI: Frame transfer does not restart after DSI frame matches preprogrammed value |
| e9664 | DSPI: Frame transfer does not restart in case of DSI parity error in master mode |
| e9656 | DSPI: Frame transfer does not restart in case of SPI parity error in master mode |
| e7352 | DSPI: reserved bits in slave CTAR are writable |
| e10542 | DSPI: Transmit, Command, and Receive FIFO fill flags in status register is not cleared when DMA is improperly configured |
| e1147 | DSPI: Using DSPI in DSI mode with MTO may cause data corruption |
| e7001 | EBI: External TA and TEA do not operate properly when internal master does burst aborts to EBI |
| e7546 | EBI: Input signal valid to D_CLKOUT posedge (setup time) spec is not met |
| e9978 | eMIOS: Unexpected channel flag assertion during GPIO to MCB mode transition |
| e8313 | EQADC: TUE specification not met |
| e9344 | eSCI: Late assertion of Transmit Data Ready Interrupt Flag (TXRDY) for Local Interconnect Network (LIN) frame receive (RX) operation |
| e9001 | eSCI: Incorrect behavior while in LIN Standard Bit error detection mode |
| e9361 | eSCI: Timing of TXRDY interrupt flag assertion is incorrect for LIN TX Frame |
| e9797 | eSCI: Unable to send next frame after timeout in LIN mode |
| e5642 | ETPU2: Limitations of forced instructions executed via the debug interface |
| e8252 | eTPU: ETPU Angle Counter (EAC) Tooth Program Register (TPR) register write may fail |
| e9090 | eTPU: Incorrect eTPU angle counter function under certain conditions |
