BON CHARGE Max Red Light Therapy Device
User Manual
Welcome
The Max Red Light Therapy Device delivers high-powered and focused red light at 660nm (visible red light) and near-infrared light at 850nm (invisible light). The device can run these wavelengths separately or together. For optimal results, the light should be shone onto bare skin.
Intended Use
This device is a wellness device aimed at improving the appearance of skin and providing general wellness benefits to the user.
Key Points
Activating Your Max Red Light Therapy Device
For the best possible results, it is highly recommended to read this manual before first use.
Photosensitivity Test
Perform a photosensitivity test before long sessions. Turn on both Red and NIR switches, shine light on an exposed part of your forearm (3 inches to 1 foot away) for 4 minutes. If you experience discomfort or redness, discontinue use and seek professional advice.
Usage Instructions
Position the device 3 inches to 1 foot away from the body. The device delivers >100 mW/cm² of energy at this distance, providing an optimal session time of ten minutes.
Multiple Usages
Light therapy is most effective when administered consistently. Daily use is recommended for best results, with a minimum of 4 times a week. For major injuries, long-term aches, or severe skin conditions, using the device up to three times per day can be beneficial.
What to Expect
Results vary based on personal goals. Numerous peer-reviewed studies support the long-term benefits of red light therapy. Many users experience benefits within a week of consistent use, while others may take up to 3 months. Daily use optimizes benefits.
Setting Up and Using Your Max Red Light Therapy Device
What's in the Box?
- 1 x Max Red Light Therapy Device
- 1 x Power Cord
- 2 x Braided Steel Cables
- 1 x Eye Goggles
- 1 x Threaded Posts
- 1 x Height-Adjusting Pulley
- 1 x Door Hook
Step 1: Prepare the Device
Place your Max Red Light Therapy Device face down on a scratch-free surface. Screw the threaded posts into the top of the device. Hand-tighten and then screw the braided cables to the threaded posts.
Step 2: Hang the Door Hook
Hang the door hook on any standard-sized door.
Step 3: Connect the Pulley System
Connect the braided cables to the snap link attached to the height-adjusting pulley. Connect the snap link on the opposite end directly to the door hook.
Step 4: Adjust Height
To raise your device to the desired height, pull down on the loose cable while supporting the device with your opposite hand.
Step 5: End Session
Once your session is over, switch off the Red and NIR lights (or your chosen combination) to ensure battery longevity.
Step 6: Power Connection
Plug the power cord into the male power socket on the back of the device. Plug the other end into the wall power outlet. Switch the power on.
Step 7: Set Session Time
Use the [+] and [-] buttons on the control panel to adjust session time in five-minute increments, up to a maximum of 30 minutes.
Step 8: Select Light Mode
Your device features both red and near-infrared wavelengths. Select only red (R indicator light illuminates), only near-infrared (IR indicator light illuminates), or both modes by pressing the "RED" or "NIR" buttons on the control panel.
Step 9: Begin Session
Put on your goggles (if required) and enjoy your session. The device's cooling fans may run for up to 5 minutes after the session to cool the LEDs.
Troubleshooting
My Max Red Light Therapy Device won't turn on
- Ensure the device is plugged in and the mains power is switched on.
- Ensure you are using the supplied power cable.
- If the issue persists, contact BON CHARGE at hello@boncharge.com.
Frequently Asked Questions
How to use the timer in the control panel
The "Time" button adjusts session time in 5-minute increments, up to 30 minutes. The time display cycles back to 5 minutes after 30 minutes. The device will recall the last programmed session time for subsequent sessions.
How should I use my Max Red Light Therapy Device?
We recommend 10-minute sessions, positioned 3 to 12 inches from the target area.
Do I need to wear eye protection?
Protective goggles are supplied and recommended. Do not look directly into the LED lights.
Why does it appear that the Near Infrared lights aren't working?
Near Infrared (NIR) light is invisible. You can confirm it's working by the presence of a dim light within the NIR LED bulbs, indicating they are functioning.
What is the difference between red and near infrared light?
Red light (660nm) is best for improving skin appearance. Near Infrared light (850nm) is invisible and penetrates deeper into muscle tissue, making it ideal for muscle recovery.
Can I use my Max Red Light Therapy Device with clothes on?
While possible, results are not guaranteed. Optimal results are achieved with bare skin absorbing the light directly in the target area.
Will the light disrupt any medication I am taking?
If you are taking photosensitizing medication (e.g., Tetracycline, Digoxin, Retin A), seek medical advice before use. Light therapy is generally safe and effective, but consulting your healthcare provider is always recommended.
Can my children use the Max Red Light Therapy Device?
Clinical trials show red light therapy to be safe and beneficial. However, consulting a healthcare professional before use by children is recommended.
When can I expect to see results?
Some users may experience reduced swelling, stiffness, and clearer skin after a few sessions, or a warming sensation after one session. Consistent use over time yields the best results, especially for muscle or joint-related issues.
Technical Specifications
Model | BON CHARGE Max Red Light Therapy Device |
Size | 91cm x 21cm x 6.5cm (35 inches x 8.3 inches x 2.5 inches) |
Irradiance | >142 mW/cm² |
Weight | 8kg (17.64 lb) |
Wavelengths | 660nm Red (200pcs) 850nm Near Infrared (200pcs) |
Flicker | <0.1% |
Warranty | 1 Year |
Power | 1,000W |
Voltage | AC85-265V |
Certification | CE and FCC |
LEDs | 5W – 200 LEDs |
Beam Angle | 30 degrees |
Warnings and Cautions
Warnings
- Do not stare directly into the LEDs or their reflection, as this can cause temporary eye irritation.
- Do not allow children to use the device unsupervised or without medical clearance.
- As an electrical device, adhere to the following to avoid electric shocks:
- Do not drop the device in liquid.
- Do not wash the device with any liquids.
- Do not touch with wet hands.
- Do not use the device on wet or damp skin.
- Do not tug or pull on the charging cable.
- Do not use the device if it has been dropped, left outside, or exposed to liquids.
- Do not use on or near hot surfaces.
- Do not operate near flammable or combustible products or where vapors may be present, as explosion or fire may occur.
- Do not use this device on disabled, sleeping, or unconscious people.
- Do not use this device on open wounds.
- Do not use in conjunction with salves, balms, or ointments.
- Do not modify or attempt to modify this device.
- Do not attempt to repair this device.
- Do not pull, carry, or lift the device by its cord. If the cord is damaged, do not use the device.
- Do not store or use the device in temperatures exceeding 130°F (54°C).
- Do not use the device if it is damaged, as continuous use may result in electric shock or injury.
- Do not use extension cords unless they are designed to carry the total wattage of the device.
- Do not unplug by pulling directly on the cord.
Cautions
- For first-time users, start with 2-3 minute sessions per area, gradually increasing to 10 minutes over 2-3 weeks as your body adjusts.
- BON CHARGE advises seeking professional medical advice before using the device if:
- You are pregnant.
- You are taking medications known to cause skin sensitivity to light.
- You have suspicious or cancerous lesions.
- You have recently had a steroid injection or use topical steroids.
- The device is not intended for use on infants.
- If you experience discomfort or have concerns, stop use immediately and contact your doctor.
- The device is for indoor use only.
- Use only provided equipment.
- Do not exceed a 20-minute session.
Electrical Safety
CAUTION: Placing the device directly on bare skin may result in burns or injury. Hold the device at a minimum of 3 inches away from your skin as instructed.
- Do not place or operate the device near water or liquids.
- Do not place near or pour running water over the device.
- This device is not to be used in the vicinity of water.
- Do not store the device in temperatures exceeding 140°F (60°C).
- Do not use your device if damaged, as this may result in electric shock or injury.
Disclaimer
BON CHARGE Max Red Light Therapy Device is not intended to diagnose, cure, or prevent specific diseases or medical conditions. These products are intended for mild conditions that have been medically diagnosed. The information provided is not medical advice or a substitute for medical advice. BON CHARGE does not intend these products to cure any physical or skin conditions solely from their use.
A qualified health professional or doctor should always be consulted prior to using the products, and professional medical attention should be sought regarding any serious or life-threatening conditions. These statements have not been evaluated by the Food and Drug Administration. This product is not intended to diagnose, treat, cure, or prevent any disease.
Maintenance, Cleaning, and Disposal
Maintenance
The Max Red Light Therapy Device does not require any maintenance.
Cleaning
- Ensure your Max Red Light Therapy Device is switched off.
- Clean the surface with a dry cloth.
- Avoid using any polishes or bleaches, as they may damage the device.
Disposal
This device must not be disposed of with normal household rubbish. It requires disposal via a designated waste collection point. This device contains a lithium battery, which must be disclosed when handing it over to the waste collection point advisor. [waste-disposal-symbol]
Warranty and Returns
Manufacturer's Warranty
BON CHARGE warrants that this Device will function and perform within specifications for one year from the date of delivery.
What does this Manufacturer's Warranty cover?
This warranty covers any defect in material or workmanship under normal use during the warranty period. BON CHARGE will repair or replace, at no charge, defective products or parts due to improper material or workmanship.
How long does the cover last?
The warranty is valid for one (1) year from the date of purchase. A replacement device or part assumes the remaining warranty of the original.
What does this warranty not cover?
- Conditions, malfunctions, or damage not resulting from defects in material or workmanship.
- Equipment that has been abused, modified, damaged, or fitted with substitute parts.
What do you have to do?
To obtain warranty service, contact BON CHARGE to determine the problem and the most appropriate solution. Contact details: hello@boncharge.com, 2/40 King Edward Road, Osborne Park, 6017, Western Australia.
If service is required, the buyer is responsible for returning the device to BON CHARGE within the one-year warranty period.
BON CHARGE reserves the right to provide parts in different colors to the original device.
BON CHARGE goods come with guarantees that cannot be excluded under the Australian Consumer Law. Consumers are entitled to a replacement or refund for a major failure and compensation for other reasonably foreseeable loss or damage. Goods are also entitled to be repaired or replaced if they fail to be of acceptable quality and the failure does not amount to a major failure.
Returns
Visit the Returns Centre for a hassle-free return experience. Details to note:
- Return shipping is your responsibility; BON CHARGE cannot be responsible for lost or damaged shipments.
- All returns or exchanges must be received in like-new condition with all original accessories and packaging.
- Returns with damaged or missing components may incur additional fees, deducted from the refund.
- Returns will be inspected and processed within 3-5 days of receipt by BON CHARGE.
- Returns must be postmarked before the end of the 30-day guarantee period.
- This product contains a lithium battery and must be disclosed to your logistics carrier when shipping back to Australia. Our preferred carrier is DHL Express.
Connect with BON CHARGE
[Facebook] @boncharge
[Instagram] @boncharge_
[Website] boncharge.com