AEG BL18S Battery Charger
Original Instructions
Charging Process and Indicators
The charger is designed to charge AEG system slide 18V batteries.
Charging Temperatures: Optimal charging occurs between 0°C and 50°C. Charging may be delayed if the battery is too hot or too cold, waiting until it reaches the acceptable temperature range.
Charging Steps:
- Step 1: Connect the charger to a power outlet. [Illustration: Charger plugged into wall socket, power cord shown.]
- Step 2: Insert the battery pack into the charger. [Illustration: Battery pack being inserted into charger.]
- Step 3: The battery is now charging. [Illustration: Battery pack fully inserted and charging.]
Charging Indicators:
- Green Lamp Flashing: Battery is automatically charging.
- Orange Lamp Continuous: Battery is hot or cold; charging will begin once the battery reaches the correct temperature (0°C - 50°C).
- Green Lamp Continuous (Red Lamp Off): Charging is complete; the charger is in trickle charge mode to maintain full capacity.
- Red Lamp Continuous: Indicates a fault in the battery or charger. Stop use immediately and have them inspected by an AEG Customer Service Centre.
Battery Status: [Illustration: Battery pack showing 100% charge.]
Battery Insertion/Removal:
- Step 4: Insert the battery pack into the charger. [Illustration: Battery pack insertion with upward arrow.]
- Step 5: Remove the battery pack from the charger. [Illustration: Battery pack removal with upward arrow.]
Important Safety Information
[Safety Alert] This appliance is not intended for use or cleaning by persons with reduced physical, sensory, or mental capabilities, or lack of experience or knowledge, unless supervised by a responsible person. Children must not use, clean, or play with this appliance and should be secured out of their reach when not in use.
[Safety Alert] Read all safety warnings, instructions, illustrations, and specifications provided with this power tool. Failure to follow instructions may result in electric shock, fire, and/or serious injury. Save all warnings and instructions for future reference.
Charger Safety Warnings
- Do not dispose of used battery packs in household refuse or by burning. Return old batteries to AEG Distributors for environmental protection.
- Do not store battery packs with metal objects to prevent short circuits.
- Use only System AEG GBS chargers for System AEG GBS battery packs. Do not use battery packs from other systems.
- Do not attempt to charge non-rechargeable batteries.
- Prevent any metal parts from entering the battery section of the charger to avoid short circuits.
- Never break open battery packs or chargers. Store only in dry rooms and keep dry at all times.
- Do not touch the tool with conducting objects.
- Never charge a damaged battery pack; replace it with a new one.
- Before use, check the machine, cable, and plug for any damages or material fatigue. Repairs should only be carried out by authorized service agents.
Additional Battery Safety Warnings
- [Safety Alert] To reduce the risk of fire, personal injury, and product damage due to a short circuit, never immerse your tool, battery pack, or charger in fluid, or allow fluid to flow inside them. Corrosive or conductive fluids can cause a short circuit.
Specified Conditions of Use
The quick charger is intended to charge AEG system slide 18V batteries. Do not use the product in any way other than as stated for intended use.
Mains Connection
Connect only to single-phase A.C. current and to the system voltage indicated on the rating plate.
Battery Management
- Recharge battery packs that have not been used for some time before use.
- Temperatures exceeding 50°C (122°F) reduce battery pack performance. Avoid extended exposure to heat or sunshine to prevent overheating.
- Keep charger and battery pack contacts clean.
- For optimal battery life, fully charge battery packs after use.
- To maximize battery life, remove the battery pack from the charger once fully charged.
- For storage longer than 30 days: Store batteries below 27°C, away from moisture, at a 30%-50% charge level. Recharge every six months.
Battery Pack Protection
The battery pack features overload protection for long life. Under extreme stress, the battery electronics will automatically switch off the machine. To restart, switch the machine off and then on again. If it does not start, the battery pack may be completely discharged and needs recharging.
Maintenance
- The supply cord cannot be replaced. If damaged, the appliance should be scrapped.
- Keep ventilation slots clear at all times.
- Use only AEG accessories and spare parts. Contact an AEG service agent for component replacement.
- An exploded view of the tool can be ordered from local service agents by providing the Article No. and machine type.
Transportation of Lithium Batteries
Lithium-ion batteries are subject to Dangerous Goods Legislation. Transportation must comply with local, national, and international regulations. Users can transport batteries by road without further requirements. Commercial transport by third parties requires compliance with Dangerous Goods regulations and must be handled by trained persons. Ensure battery terminals are protected and insulated, battery packs are secured against movement, and do not transport cracked or leaking batteries. Consult forwarding companies for advice.
Technical Data
Rated voltage: 18 V
Quick charge current Li-Ion: 2.0 A
Recommended ambient charging temperature: +5 to +40 °C
Weight (not including battery pack): 0.35 kg
Compatible Battery Packs
| Battery pack | Voltage | Battery capacity | Number of cells for battery | Cell type | Approximate charge time |
|---|---|---|---|---|---|
| L1820R TYPE II | ≤ 2.0 Ah | 5 | Lithium-Ion | 90 minutes | |
| L1820S | ≤ 2.0 Ah | 5 | 90 minutes | ||
| L1825R TYPE II | ≤ 2.5 Ah | 5 | 110 minutes | ||
| L1830R-X5 | ≤ 3.0 Ah | 5 | 125 minutes | ||
| L1840R TYPE II | ≤ 4.0 Ah | 5 x 2 | 170 minutes | ||
| L1850R TYPE II | ≤ 5.0 Ah | 5 x 2 | 190 minutes | ||
| L1860R TYPE II | ≤ 6.0 Ah | 5 x 2 | 210 minutes | ||
| L1860R-X5 | ≤ 6.0 Ah | 5 x 2 | 210 minutes | ||
| L1890R | ≤ 9.0 Ah | 5 x 3 | 375 minutes |
Symbols and Compliance
- [Safety Alert] Symbol indicating a safety warning.
- [Volts] Symbol for voltage.
- [Direct Current] Symbol for direct current.
- [Regulatory Compliance Mark] Product meets applicable regulatory requirements.
- [Class II equipment] Indicates double insulation.
- [Time-lag fuse 2.0A] Specifies the fuse rating.
- For indoor use only.
- [Recycling Symbol] Do not dispose of electric tools with household waste. Collect separately and return to an environmentally compatible recycling facility.
Service and Contact Information
Techtronic Industries Australia Pty Ltd
PO Box 1065
Mount Waverley VIC 3149
Tel. no. 1300 234 797
Techtronic Industries N.Z. Limited
Unit C, 70 Business Parade South,
Highbrook, Auckland 2013, New Zealand
Tel. no. 0800 234 797 (0800 AEGPWR)
AEG is a registered trademark used under license from AB Electrolux (publ). © 2020 Techtronic Cordless GP.
Document reference: 961096683-01A
