Skykey/Magickey Coding Instructions
- Locate the learn button on the receiver, which will be attached to the motor.
- Press and immediately release the learn button once; the LED will illuminate.
- Press and hold a button on the new remote for 2 seconds, then release. This will cause the LED on the receiver to either flash or go out.
- Press and hold a button on the new remote for 2 seconds, then release. This will cause the LED on the receiver to either flash or go out.
- After the receiver light has gone out, test the remote.
WARNING
To prevent possible SERIOUS INJURY or DEATH:
- Battery is hazardous: NEVER allow children near batteries.
- If a battery is swallowed, immediately notify a doctor.
- To reduce risk of fire, explosion, or chemical burn:
- Replace ONLY with the same size and type battery.
- DO NOT recharge, disassemble, or heat above 100° C. Incinerating the battery will cause SEVERE or FATAL injuries in 2 hours or less if swallowed or placed inside any part of the body.
[Battery Hazard Warning]
