Godox LiteFlow 15 Cine Lighting Reflector

Introduction

Thank you for purchasing the Godox Cine Lighting Reflector. This innovative reflector system allows for precise control of light placement, ensuring simultaneous soft lighting and 100% color fidelity. It features a metal frame with only 3% light loss.

The reflector comes with different diffusion options:

• 1 (Blue): Soft diffusion (13.2%)
• 2 (Yellow): Light diffusion (52%)
• 3 (Green): Soft and linear diffusion (95%)
• 4 (Red): Soft and linear diffusion (94%)

The light effect demonstration is based on the LiteFlow 50.

Important Notes:

1. The reflector is prone to scratching; please use the provided gloves during operation.
2. To ensure the reflector maintains its performance, avoid touching the reflective surface directly. If cleaning is necessary, do so after the surface has cooled down.
3. The reflector may be scratched during transportation or installation.

Parts Name (LiteFlow 15)

The LiteFlow 15 consists of the following parts:

• 1. Reflector
• 2. Sliding Sleeve
• 3. Tilting Bracket
• 4. Safety Corner
• 5. Mounting Hole

The diagram shows a square reflector with four corner brackets, a central mounting point, and a sliding sleeve attached to a tilting bracket.

Cleaning Instructions (Cleaning Agent Sold Separately)

1. Before cleaning, wear the provided gloves.
2. Apply cleaning liquid evenly to the reflective surface.
3. Wait for 15-30 seconds, then use a soft cloth to wipe the reflective surface.
4. After cleaning, use a clean cloth to dry the reflective surface.

Note: To ensure the best cleaning effect, please dry the reflector promptly.

Installation of WMS/Sliding Sleeve WMR

According to your needs, you can install the WMS or WMR sliding sleeve.

For WMS Sliding Sleeve:

The diagram shows a WMS sliding sleeve being attached to a light stand. The sleeve has a 5/8" (5/8 inch) stud, and it can be inserted into the 5/8" receiver of a light stand.

For WMR Sliding Sleeve:

The diagram shows a WMR sliding sleeve being attached to a light stand. The sleeve has a 5/8" (5/8 inch) stud, and it can be inserted into the 5/8" receiver of a light stand.

To attach the sliding sleeve: Rotate the knob on the sliding sleeve, then insert the sleeve from the bottom of the reflector's sliding sleeve mount. Slide to the desired position and tighten the knob.

Optional Accessories

The following optional accessories are available:

• WMS Sliding Sleeve
• WKN Extension Rod
• Extension Rod
• Ball Head
• Extension Rod RS
• Extension Rod RS
• Extension Rod RS

LiteFlow 15 Material List

The package includes:

• LiteFlow 15D1 x 1
• LiteFlow 15D2 x 1
• LiteFlow 15D3 x 1
• LiteFlow 15D4 x 1
• Storage Bag SC14 x 1

The diagram shows four square reflectors of different sizes and a Godox branded storage bag.

Specifications