SellTec 270221 LED Board
Brand: SellTec
Energy Efficiency
This LED luminaire features an energy efficiency rating scale from A++ (most efficient) to E (least efficient). The specific energy consumption for this model is 40 kWh/1000h.
Technical Specifications
- Product Name: LED Board
- Model Number: 270221
- Light Source Type: LED
- Power Consumption: 40 W
- Luminous Flux: 2,940 lumens (typical), 2,080 lumens (minimum)
- Rated Lifespan: 30,000 hours
- Color Temperature Range: 3,000 K to 5,000 K
- Switching Cycles: 15,000
- Startup Time: Less than 0.5 seconds
- Operating Voltage: 230V / 50Hz~
- Included Component: 1x LED-Board 40W / 370VDC
- Cable Entry/Mounting Hole Diameter: Ø6mm
Installation Instructions
Follow these steps for safe and correct installation. Ensure the power supply is disconnected before beginning any work.
- Preparation: Identify the mounting location. Mark the positions for the fixture or its mounting bracket.
- Drilling: Drill holes at the marked locations. If required, insert appropriate wall anchors.
- Mounting Bracket: Securely attach the mounting bracket to the surface using suitable screws.
- Wiring: Connect the power supply wires to the terminal block. The diagram indicates the following connections for the wires labeled 'a', 'b', and 'c':
- Wire 'a' connects to the Live (L) terminal.
- Wire 'b' connects to the Neutral (N) terminal.
- Wire 'c' connects to the Live (L) terminal. (Note: The label 'c=L' for the third terminal appears to be an anomaly. Standard electrical installations typically require a connection for Earth/Ground. Consult specific local regulations or a qualified electrician if unsure.)
- Attach LED Board: Mount the LED board onto the installed bracket.
- Secure Fixture: Close or secure the main housing of the luminaire.
- Final Check: Verify that all connections are secure and the fixture is properly installed.
- Power On: Restore power. The luminaire can be operated using the included remote control or a wall switch, indicated by the [Power On/Off] symbol (I/O).
Color Temperature Adjustment: The color temperature can be adjusted through the available options: 3.000K (Warm White), 4.000K (Neutral White), and 5.000K (Cool White). This is typically controlled via the remote or a compatible switch.
Remote Control: A remote control is provided for operating the luminaire and selecting the desired color temperature.
Safety Information
The light source within this luminaire is not user-replaceable. It should only be replaced by the manufacturer, a service technician authorized by the manufacturer, or an individual with equivalent qualifications. This ensures the continued safety and proper functioning of the product.
