TELESIN Floating Remote Tripod

Preface

Thank you for purchasing a Telesin product. Please read this user manual carefully before use.

Important Notes

• Please keep this user manual properly. When handing over the product to others, be sure to include this user manual.
• Pay attention to all warnings and follow all instructions in the user manual.
• After using the product in a seawater environment:
  • First, soak it in fresh water for 10 minutes;
  • To avoid salt residue interfering with the extension mechanism, fully extend the pole and rinse it upside down under running fresh water for at least 5 minutes.
  • After washing, wipe away any water droplets remaining on the surface with a soft, dry cloth and leave to dry. Do not dry with a hair dryer or any other heat source.
  • Store the product in a dry, well-ventilated location.
• Do not disassemble or damage this product. If it becomes deformed or damaged, stop using it immediately.
• Do not cover the product with items like towels or clothes during charging to prevent fire hazards.
• Do not drop the product or use it under high temperatures or short-circuit conditions.
• Keep this product out of reach of children.
• The product has passed the waterproof test of GB/T4208-2017 and IEC60529-2013 enclosure protection rating standard IP68. It is not recommended to use the product in extreme water environments or unknown liquid environments. Do not use it in hot springs or corrosive liquids.
• The waterproof depth of this product is 15 meters.

Warnings

Do not disassemble the product or replace the battery. If you suspect any problem with the product, contact the purchase platform for after-sales service.

Usage Instructions

Function Introduction

[Diagram: Shows the remote with numbered buttons: ① Camera Mode, ② Power Button, ③ Mode Button, ④ Shutter Button.]

1. Switch Shooting Modes

   Press the mode button Ⓜ to switch between camera time-lapse ⏱️, video ?, or photo ? mode. The status light of the corresponding mode will light up when switching.

2. Start Shooting

   Press the shooting button ? to start shooting, press the shooting button ? again to end shooting.

3. Remote Power Control

   Press and hold the shooting button ? for 3 seconds to remotely power the camera on or off.

4. Quick Record
   • When the camera is off and supports Quick Record, short press the Shutter button ? on the remote for 1 second to wake the camera and start recording automatically.
   • If the remote is off: press and hold the Power button ⏻ for 3 seconds to turn it on (red light indicates current mode); then short press the Shutter button ? for 1 second — the camera will connect and start recording automatically.

Indicator Light Prompts

*Note: ? (light is steady on), ? (light is flashing), ⚪ (light is off)

Charging

Use the provided charging cable. Connect the contact end to the charging port on the left side of the selfie stick, and the other end to a USB power source.

• Charging time: 2.5 hours
• Battery capacity: 80mAh
• Input: 5V ⎓ 1A
• Charging Method: Pogo Pin connector

(Data determined by Telesin laboratory; slight deviations may occur due to environmental changes.)

[Diagram: Shows the charging port on the selfie stick and the pogo pin connector.]

Product Specifications

• Material: Plastic, Aluminum Alloy
• Dimensions:
  • Folded: 52.5 x 45.3 x 274.2 mm
  • Extended: 52.5 x 45.3 x 472.5 mm
• Weight: 215g

Disclaimer

Please read this statement carefully and by using this product you will be deemed to have acknowledged and accepted it in full. Please check the product carefully before each use and do not use it if damaged or deformed. By using this product, you acknowledge and agree that you are fully responsible for your actions and the possible consequences of using this product. You undertake to use this product only for legitimate and lawful purposes. You understand and agree that Telesin shall not be liable for any misuse, adverse effects, damages, injuries, penalties or other legal consequences arising directly or indirectly from the use of this product. The user should follow the precautions including but not limited to those mentioned herein. To the extent, Telesin reserves the right to interpret and modify this commitment within the limits of national laws and regulations. The warranty period for TELESIN products begins 6 months on the day you receive the product.

FCC Caution

15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

15.21 Information to user. Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

15.105 Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

RF warning for Portable device: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure conditions without restriction.

IC Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:

• (1) This device may not cause interference.
• (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.

RF exposure statement: The device was evaluated to meet general RF exposure requirements. The device can be used in portable exposure condition without restriction.

French: Cet appareil contient des émetteurs / récepteurs exemptés de licence conformes aux RSS (RSS) d'Innovation, Sciences et Développement économique Canada. Le fonctionnement est soumis aux deux conditions suivantes: (1) Cet appareil ne doit pas causer d'interférences. (2) Cet appareil doit accepter toutes les interférences, y compris celles susceptibles de provoquer un fonctionnement indésirable de l'appareil. Tout changement ou modification non expressément approuvé par la partie responsable de la conformité pourrait annuler l'autorité de l'utilisateur à utiliser l'équipement. Déclaration d'exposition RF: L'appareil a été évalué pour répondre aux exigences générales en matière d'exposition aux RF. L'appareil peut être utilisé en condition d'exposition portable sans restriction.