Sealey - Leading Professional Tool & Workshop Equipment Supplier
Instruction Manual for SEALEY models including: LED1000, LED1000 10W Cob LED Rechargeable Pocket Floodlight, 10W Cob LED Rechargeable Pocket Floodlight, LED Rechargeable Pocket Floodlight, Rechargeable Pocket Floodlight, Pocket Floodlight, Floodlight
2024-06-03 — IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE. THE PRODUCT CORRECTLY AND WITH CARE ...
Jun 3, 2024 — IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE. THE PRODUCT CORRECTLY AND WITH CARE ...
Jun 3, 2024 · The battery indicator will blink blue during charging. 4.1.4. As the battery charges it will indicate 25% flashing blue light 50%, flashing blue ...
File Info : application/pdf, 2 Pages, 653.05KB
DocumentDocument10W COB LED RECHARGEABLE POCKET FLOODLIGHT 1000 LUMENS, WITH FLIP OUT MAGNETIC BRACKET MODEL NO: LED1000 Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE. Refer to instructions 1. SAFETY 1.1. GENERAL 9 Ensure the lamp is fully charged before initial use. 8 DO NOT turn the lamp on when it is being charged. 8 DO NOT shine directly into your, another person's or an animal's eyes. 8 DO NOT allow children to use the lamp. 8 DO NOT handle or move the lamp whilst it is being charged. 8 DO NOT use the lamp if you suspect that the battery, the lamp casing or the cable is damaged. Consult your Sealey Stockist. 8 DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently recharge the battery at least once every six months of non-use. 1.2. BATTERY SAFETY WARNING! To reduce the risk of burns or fire: 8 DO NOT Attempt to open, dismantle, modify or service the battery pack. 8 DO NOT Crush, puncture, short external contacts or dispose of in fire or water. 8 DO NOT Expose to temperatures above 40°C or below -10°C. 8 DO NOT Expose to direct sunlight for long periods of time. 8 DO NOT Expose to moisture. WARNING! DO NOT place the lamp face down while in use. 9 If the electrolyte in the cells gets on your skin, wash thoroughly with soap and water. If it gets in your eyes, rinse thoroughly with cool water and seek immediate medical attention. 2. INTRODUCTION Compact, lightweight design with a large 1000lm output. Made with a tough ABS plastic housing with flip-out magnetic bracket. Includes small carabiner, which can be used when no ferrous surface is available for additional storage and application solutions. Magnetic bracket can be angled at a range of 180° making it simple and easy to direct up to 1000 lumens of light. Three light output settings; low, high and flashing. Features LED battery level indicator. Fitted with a high quality 3.7V 2Ah lithium polymer battery. Charges via a USB-C lead. (Supplied, with charge time of 4 hours). IP rating: IPX4. 3. SPECIFICATION Model No.:....................................................... LED1000 Battery: ................................................3.7V 2Ah Li-Poly Charging Time: .........................................................4hr IP Rating ................................................................ IPX4 LED Type: ...................................................... 10W COB Length: ................................................................... 9cm Lumen Output .................................................... 1000lm Operating time: ......................................................4.5hr The battery fitted to this lamp is considered to be a consumable item and its ability to accept a charge will reduce over time.We will provide warranty against mechanical and electrical defect for a period of one year. This does not cover fair wear and tear.If the battery is not properly charged before first use, or regularly conditioned, its capacity will diminish. Under these circumstances we will not replace the battery regardless of whether it is less than one year old. NOTE: The lithium battery does not suffer from memory effect and once fully charged may be stored for up to six months without another charge. © Jack Sealey Limited Original Language Version LED1000 Issue 3 (4) 03/06/24 Carabiner/magnetic stand Mode Selection Button (On/ Off) Tripod Mounting USB Connections Cover/ Charging Point LED charge indication Tripod Mounting Mode Selection Button (On/ Off) 4. OPERATION 4.1. 4.1.1. 4.1.2. 4.1.3. 4.1.4. 4.2. 4.2.1. 4.2.2. 4.2.3. 4.2.4. CHARGING Insert the Micro USB plug on the USB cable into the charging port on the side of the lamp. Plug the other end of the USB cable into a 5V USB outlet. WARNING! DO NOT turn lamp on whilst charging. The battery indicator will blink blue during charging. As the battery charges it will indicate 25% flashing blue light 50%, flashing blue light, 75% flashing blue light, 100% flashing blue light until the battery has charged fully and all remain solid. USE OF LAMP Direct the lens away from your eyes, other people and animals before switching on. Push the ON/OFF switch once for half power mode, twice for full power mode and a third time for flashing mode. The lamp may be held by the handle or attached to any ferrous surface by using the magnet. IMPORTANT: Only use the cable supplied with the product. 5. MAINTENANCE 5.1. Clean the casing externally (not the glass) with a moist cloth. 5.2. If necessary clean the glass with an alcohol dampened soft cloth. 8 DO NOT use solvents or abrasives. 8 DO NOT allow unit to get wet or use/store in a damp environment. ENVIRONMENT PROTECTION Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations. REGISTER YOUR PURCHASE HERE WEEE REGULATIONS Dispose of this product at the end of its working life in compliance with the EU Directive on Waste Electrical and Electronic Equipment (WEEE). When the product is no longer required, it must be disposed of in an environmentally protective way. Contact your local solid waste authority for recycling information. BATTERY REMOVAL Under the Waste Batteries and Accumulators Regulations 2009, Jack Sealey Ltd are required to inform potential purchasers of products containing batteries (as defined within these regulations), that they are registered with Valpak's registered compliance scheme. Jack Sealey Ltd's Batteries Producer Registration Number (BPRN) is BPRN00705. Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 sales@sealey.co.uk www.sealey.co.uk © Jack Sealey Limited Original Language Version LED1000 Issue 3 (4) 03/06/24