Kenwood TS-2000 Series Transceiver Manual

Key Features:

• All-mode operation from HF to 1.2 GHz (with optional unit).
• Dual high-speed Digital Signal Processing (DSP) units.
• High-speed Digital Automatic Gain Control (AGC).
• Independent sub-receiver for 144 MHz and 430/440 MHz bands.
• Built-in Antenna Tuner for HF/50 MHz bands.
• Built-in 9600/1200 bps TNC for packet operations.
• Advanced CW capabilities with a 50 Hz DSP filter.

Installation and Operation:

The manual details the installation process, including antenna and ground connections, DC power supply setup, and accessory connections for both front and rear panels. It guides users through their first QSOs on HF/50 MHz and VHF/UHF bands, covering basic receiving and transmitting procedures.

Key operating sections include:

• Getting Acquainted with the Front and Rear Panels
• Operating Basics: Power, Volume, Gain, Band/Mode Selection, Squetch, Frequency Tuning
• Menu Setup and Configuration
• Basic and Enhanced Communications (SSB, FM, AM, CW, Repeater Operation)
• Sub-Receiver Operation
• Interference Rejection techniques using DSP filters
• Memory Features and Scanning
• Operator Conveniences and Peripheral Equipment Connections
• Installing Optional Accessories
• Troubleshooting Guide

Important Precautions:

Users are advised to observe safety precautions to prevent fire, personal injury, and transceiver damage. This includes proper power source connection, safe cable routing, avoiding liquid spills, and ensuring adequate grounding and ventilation. The manual also includes FCC warnings and information regarding compliance with digital device regulations.

Further Information:

For detailed specifications, an index, and a list of optional accessories, please refer to the respective chapters within this manual. For support and additional resources, users can visit the Kenwood website.