LED Modern Vanity Light Installation Sheet

Safety First

• Make sure POWER is COMPLETELY OFF at the fuse box.
• Have your fixture installed by a qualified licensed electrician.
• Prepare everything in a clear area.
• Wear gloves at all time during this installation.
• Read instructions carefully before you start assembly.
• Keep this installation sheet for future reference.

Installation Instructions

1. Remove fixture from its original package.
2. Separate mounting plate from fixture body by removing canopy screws.
3. Attach mounting plate to electrical junction box using screws provided in hardware package.
4. Secure mounting plate to mounting surface with additional screws.
5. Make proper electrical connections (black to hot "L", white to neutral "N", ground to "GND") with wire nuts provided in hardware package.
6. Attach mounting plate to holes on fixture body, and then attach using canopy screws.

Diagram Descriptions:

Diagram (1): Mounting Plate and Wiring Preparation
This diagram illustrates the mounting plate being attached to an electrical junction box. It shows the plate, screws for the junction box, and the initial wiring components including wires from the fixture and the junction box, along with wire nuts for making connections.

Diagram (2): Electrical Connections
This diagram focuses on the electrical connections. It shows the fixture wires (typically black, white, and ground) being connected to the corresponding wires from the junction box using wire nuts. Labels indicate connections: black wire to "L" (hot), white wire to "N" (neutral), and ground wire to "GND".

Diagram (3): Fixture Assembly and Attachment
This diagram shows the final assembly steps. It depicts attaching the fixture body to the prepared mounting plate, aligning holes, and securing it with canopy screws. Multiple variations of the fixture (e.g., 2-light, 3-light, 4-light) are shown in the process of being mounted.