V-TAC LED SYNC CONTROLLER - RGB

Technical Data

Introduction & Warranty

Thank you for selecting and buying V-TAC product. V-TAC will serve you the best. Please read these instructions carefully before starting the installation and keep this manual handy for future reference. If you have any another query, please contact our dealer or local vendor from whom you have purchased the product. They are trained and ready to serve you at the best. The warranty is valid for 2 years from the date of purchase. The warranty does not apply to damage caused by incorrect installation or abnormal wear and tear. The company gives no warranty against damage to any surface due to incorrect removal and installation of the product. The products are suitable for 10-12 Hours Daily operation. Usage of product for 24 Hours a day would void the warranty. This product is warranted for manufacturing defects only.

Warning

• Please make sure to turn off the power before starting the installation.
• Installation must be performed by a certified person.

Caution, risk of electric shock. ⚡

This marking indicates that this product should not be disposed of with other household wastes. ♻️

Product Description

The controller adopts the advanced micro control unit, it is used for controlling a variety of LED light. For instance, point source of light, flexible light strip, wall washer lamp and so on. It has many advantages such as good appearance, easy connection and simplicity to use. It utilizes an RF 20-key remote control for ON/OFF, color selection, and changing dynamic modes.

Direction of Use

• Connect the load wire and sync-signal cable at first, followed by the power wire.
• Ensure no short circuit can occur before you turn on the power.
• The device uses an RF wireless remote control with 20 keys. The function of each button is as follows:

Remote Control Functions

• Brightness +
• Brightness -
• Pause / On/Off
• Static Red
• Static Green
• Static Blue
• Static White
• Static Orange
• Static Yellow
• Static Cyan
• Static Purple
• Auto run three base color jumpy
• Three color gradually change speed +
• Flash seven base color jumpy
• Seven color gradually change speed -

RF Code Operations

RF Code

The receiver can be controlled by any identical remote control as factory default. The remote control is delivered with a unique RF code as factory default. If unique control is needed, please match the code before installation and using.

Matching Code Operation

The receiver and remote control are coded by default. Match them before using. If unique control or a new-coded remote is needed, pair the remote and the receiver as per the following operation instructions before using:

1. Step 1: Press and hold the "FLASH" key, then power on the controller. The load LEDs will respond with 50% brightness white.
2. Step 2: Press "FLASH" 3 times within 3 seconds. The LED brightness will change (25% - 10% - back to preset level) as confirmation.
3. Code learning is successful if the receiver can only be controlled by the paired remote.
4. If not, please re-operate from step 1 to 2.

Clear Code Operation

To revert to factory default settings, the wall panel can be controlled by any identical remote control.

1. Step 1: Press and hold the "JUMP7" key, then power on the controller. The load LEDs will respond with 50% brightness white.
2. Step 2: Press "JUMP7" 3 times within 3 seconds. The LED brightness will change (25% - 10% - back to preset level) as confirmation.
3. Code clearing is successful if the LEDs return to their state before power off, and the receiver can now be controlled by any remote control (any identical remote control can be used to clear the code).
4. If not, please re-operate from step 1 to 2.

Typical Application

This controller is suitable for various LED lighting applications, including LED strips, spot lights, and wall washers.