Buy Rite Aria Styling Chair-Black

Step 1: Prepare Base

Remove the pump cushion from the hydraulic base by pulling it away from the pump shaft. Discard the pump cushion after removal.

[Diagram: Shows a styling chair base with the pump cushion being pulled off the central shaft.]

Step 2: Raise Hydraulic Shaft

Pump the hydraulic to raise the shaft to the highest position, preparing to install the chair top on the hydraulic base.

[Diagram: Shows the hydraulic base with its central shaft extended to its maximum height.]

Step 3: Attach Chair Top

To securely attach the chair top to the hydraulic base, align the notch in the seat bracket (located on the bottom of the chair) with the pin on the metal shaft of the hydraulic base. Place the chair top onto the base, ensuring the pin and notch align for proper installation.

Carefully sit in the chair to ensure the metal shaft is fully secured into the seat bracket. Note: The pin will not slide fully into the top of the seat bracket.

If the chair top is not stable, repeat steps 1 and 2. Additionally, check the screws on the bottom of the hydraulic base that secure the pump to the base plate to confirm they are securely tightened.

[Diagram: Shows the chair top being lowered onto the hydraulic base, with a close-up view of the notch and pin alignment mechanism.]

Step 4: Install Footrest

Using the 14mm wrench provided, loosen the two screws in the footrest brackets attached to the bottom front of the chair top. Once loosened, slide the metal footrest bars into the footrest brackets and tighten the screws.

Ensure all screws are tight and secured prior to use, but be careful not to overtighten.

[Diagram: Shows the footrest being attached to the front of the chair base using a wrench and screws.]