GermGuardian Airsafe+ Intelligent Air Purifier with HEPA + UV-C

Important Safety Instructions & Warnings

Failure to comply with the warnings listed below may result in electric shock or serious injury.

• This product should be used only in accordance with the specifications outlined in this manual. Usage other than what has been specified here may result in serious injury.
• When using electrical appliances, basic precautions should always be followed to reduce the risk of fire, electric shock and injury to persons, including the following:
• Read all instructions before using appliance.
• IMPORTANT: This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
• WARNING: To reduce the risk of fire or electric shock, do not use with an extension cord.
• To avoid fire or shock hazard, plug the appliance directly into a 120V AC electrical outlet.
• Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put the cord under rugs, near heat registers, radiators, stoves or heaters.
• To protect against electrical hazards, DO NOT immerse in water or other liquids. Do not use near water.
• Extreme caution is necessary when any appliance is used by or near children or people with disabilities and whenever the appliance is left operating unattended.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do NOT play with the appliance.
• Always unplug the air purifier before moving it, opening the grill, changing filters, cleaning or whenever the air purifier is not in use. Be sure to pull by the plug and not the cord.
• NEVER drop or insert any object into any openings.
• DO NOT run cord under carpeting.
• DO NOT cover cord with throw rugs, runners, or similar coverings.
• DO NOT route cord under furniture or appliances. Arrange cord away from traffic area and where it will not be tripped over.
• DO NOT operate any appliance with a damaged cord or plug, if motor fan fails to rotate, after the appliance malfunctions, or if it has been dropped or damaged in any manner. Call Customer Service for assistance.
• If the SUPPLY CORD is damaged, it must be replaced by the manufacturer, service agent or similarly qualified persons in order to avoid a hazard.
• Use appliance only for intended household use as described in this manual. Any other use not recommended by the manufacturer may cause fire, electric shock or injury to persons.
• DO NOT use outdoors.
• DO NOT place anything on top of unit.
• NEVER block the air openings, grills/outlets or place on a soft surface such as a bed or sofa, as this could cause the unit to tip over, blocking the air intake or outtake opening.
• DO NOT attempt to repair or adjust any electrical or mechanical functions on this unit. Doing so will void your warranty. The inside of the unit contains no user serviceable parts. All servicing should be performed by qualified personnel only.
• WARNING: To reduce the risk of fire or electric shock, do not use this purifier with any solid-state speed control device.
• WARNING: Skin or eye damage may result from directly viewing the light produced by the lamp in this apparatus. Always disconnect power before replacing lamp or servicing. Replace Lamp With Lamp Model No. LB1000, Manufactured by Guardian Technologies.
• Always unplug the unit before cleaning or servicing in any way.
• CAUTION: DO NOT use gasoline, benzene, thinner, harsh cleaners, etc. on and/or in the unit while cleaning as they will damage the product. NEVER use alcohol or other solvents.
• WARNING: To reduce the risk of fire, electric shock, or injury to persons. Do not use replacement parts that have not been recommended by the manufacturer (e.g. Parts made at home using a 3D printer).
• CAUTION: THIS EQUIPMENT SHOULD BE INSPECTED AND CLEANED IN ACCORDANCE WITH THE MANUFACTURER'S INSTRUCTIONS ON A REGULAR BASIS TO PREVENT EXCESSIVE ACCUMULATION OF DUST PARTICLES THAT CAN RESULT IN FLASHOVER OR A RISK OF FIRE.
• The 8 hour TWA Ozone for this product is 0.001 ppmv when tested in a 30 m³ chamber. The product complies with the maximum allowable concentration of ozone of 0.050 parts per million by volume (ppmv) in a 24-hour period. The Health Canada Guideline 2010 recommends that the maximum exposure limit, based on averaging time of 8 hours, is 0.020 ppmv or less when tested in a sealed, controlled room approximately 30 m³.
• WARNING: Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.
• This product earned the ENERGY STAR label by meeting strict energy efficiency guidelines set by the U.S. EPA. Room air cleaners have demonstrated the potential for improving air quality and providing health benefits. EPA does not endorse manufacturer claims regarding the degree to which a specific product will produce healthier indoor air. The energy efficiency of this ENERGY STAR certified model is measured based on a ratio between the model's CADR for Smoke and the electrical energy it consumes, or CADR/Watt.
• (Hg) LAMP CONTAINS MERCURY. Manage in accordance with Spills, Disposal and Site Cleanup Requirements. In case of breakage, follow clean-up procedures provided by contacts below. www.epa.gov/cflcleanup 1-866-284-4010

Specifications

Intelligent Air Purifier + HEPA + UVC

Key Components:

• UV-C Button
• Power/ Speed Setting
• Air Inlet
• Air Outlet
• IntelliSense™ Air Quality Monitor
• Power Cord
• Bottom Filter Cover

Control Panel Functions:

• UVC Reset: Press 3 Sec.
• Filter Reset: Press 3 Sec.
• Modes: Auto, Off

Air Cleaning System

Improve your indoor air quality with your new GermGuardian Air Purifier. The HEPA filter captures allergens and includes a charcoal filter layer to help reduce household odors. The UV-C light helps to reduce airborne germs.

Components:

• Air Quality Monitor Sensor
• UV-C Bulb
• HEPA Filter
• Activated Carbon Filter

Operating Instructions

IMPORTANT: The air purifier is shipped with the filter stored in the filter compartment, in a bag to prevent degradation. Remove and discard the bag before use.

Before Operating:

1. Select a firm, level, and flat location for the air purifier.
2. For proper air flow, locate the unit at least 1 foot from any wall or furniture.
3. Ensure none of the grills are blocked.
4. Plug the power cord into a 120V AC outlet.

Operating the Air Purifier:

1. Power Button Operation:
   • ONCE: Turn unit on and enter Auto Mode. Auto Mode indicator illuminates.
   • TWICE: Enter Speed One. Low fan speed indicator illuminates.
   • THREE times: Enter Speed Two. Medium fan speed indicator illuminates.
   • FOUR times: Enter Speed Three. High fan speed indicator illuminates.
   • FIVE times: Enter Sleep Mode. Air quality monitor flashes for 10 seconds, all lights turn off, and the purifier runs at low fan speed.
   • SIX times: Power the unit off.
2. UV-C Button: Press to turn on the UV-C light. The button illuminates when the light is on. Press again to turn off.

What is Auto Mode?

In Auto Mode, the fan speed adjusts based on the room's air quality. If the Air Quality Monitor (AQM) detects higher particle levels, the fan speed increases. Once air quality improves, the speed decreases. You can leave the purifier in Auto Mode 24/7 for best results.

To exit Auto Mode, press the power button again to cycle through the remaining speed levels.

Saving Energy in Auto Mode:

If air quality is excellent, the motor cycles off for 30 minutes, then on for 5 minutes. If air quality remains excellent, this cycle repeats until it worsens. To exit Auto Mode, press the Fan Speed button to cycle through speed levels.

What is Sleep Mode?

In Sleep Mode, the air purifier runs at Speed One with no lights, while still filtering the air. To exit Sleep Mode, press the power button again to shut off the unit.

Air Quality Monitor

The Air Quality Monitor senses and detects particulate matter (PM2.5). The light on the front of the unit changes color to indicate the air quality level. See chart for values and status ranges.

Filter Cleaning and Maintenance

When to Replace the Filter:

Depending on usage and environmental conditions, the filter lasts approximately 6 months. The filter replacement indicator light on the control panel will flash red when it is time to replace the filter. The filter's internal pleats will turn from white to grey when dirty and needing replacement. Replace the filter according to the directions, then press and hold the power button for 3 seconds to reset the light.

IMPORTANT: DO NOT wash and re-use the filter. Please contact Customer Service or visit our website guardiantechnologies.com to purchase a replacement filter.

Removing and Replacing Filter:

1. Turn off and unplug the unit.
2. Remove the bottom panel by pressing the two corners and pulling up.
3. Replace with a new filter, pushing it completely into the unit.
4. Return the bottom panel and ensure all three corners are locked in place when you hear the click. IMPORTANT: Make sure the filter is installed and the bottom panel is closed properly, otherwise the unit will not function.
5. RESET THE FILTER LIGHT by holding the Power Button control for 3 seconds.

Replacement Parts

Filters:

• Model No. FLT151
• FLT151SM (Smoke)
• FLT151VO (VOC's / Toxins)
• FLT151PT (Pet)

Replacement Bulb:

• Model No. LB1000

Carbon Replacement 4-PACK:

• Model No. FLT15CB4

Check out our AutoShip & Save Filter Replacement Program™ at www.guardiantechnologies.com. Scan QR code to purchase replacement parts.

IMPORTANT: To maintain performance of the air cleaner, use Guardian Technologies GENUINE Replacement Parts only. To purchase, visit our website guardiantechnologies.com.

Installing & Removing UV-C Bulb

The UV-C light will begin to flash continuously when it's time to replace the UV-C bulb. Replace the bulb according to the directions, then press and hold the UV-C control button for 3 seconds to reset the UV-C indicator light.

Changing the UV-C Bulb:

1. The UV-C bulb is located in a compartment in the center of the purifier. To access, first follow the instructions to remove the filter.
2. After removing the filter, hold the unit in place with one hand. Locate the bulb cover and turn counter-clockwise (left) to remove.
3. Hold the unit in place with one hand. Turn the bulb counter-clockwise (left) to loosen from the socket.
4. Take the new bulb and screw into the unit clockwise. Wipe off fingerprints with a dry cloth.
5. Reassemble by reversing steps 1 & 2. Turn the unit back on and hold the UV-C control button for 3 seconds to reset the UV-C indicator light.

IMPORTANT: The UV-C bulb should be replaced every 10 months, depending on use.

Maintenance

Cleaning:

• Always unplug the appliance before cleaning.
• Never immerse the appliance in water or any other liquid.
• Never use aggressive or flammable cleaning agents such as bleach or alcohol to clean any part of the appliance.

Body of the Appliance:

1. Regularly clean the inside and outside of the body to prevent dust accumulation.
2. Wipe away dust with a soft dry cloth from the body of the appliance.
3. Clean the air inlet and air outlet with a soft dry cloth.

Pre-Filter Screen:

The pre-filter/charcoal layer collects larger dust and debris and should be cleaned monthly or more frequently depending on use. Remove and clean regularly with the brush attachment of your vacuum cleaner. This will remove lint and dirt and help maintain the filter's life. (See filter replacement section to locate and clean or remove the filter). Replacement pre-filters are available by visiting our website at guardiantechnologies.com.

Note: DO NOT stick any foreign objects or fingers inside the unit.

Caution: DO NOT use gasoline, benzene, thinner, harsh cleaners, etc. on or in the unit while cleaning as they will damage the product. NEVER use alcohol or other solvents.

Troubleshooting Guide

Limited Warranty

What this warranty covers: This product is warranted against defects in workmanship and/or materials.

How long this warranty lasts: This warranty extends only to the original purchaser of the product and lasts for three years from the date of original purchase or until the original purchaser of the product sells or transfers the product, whichever first occurs.

What Guardian Technologies will do: During the warranty period, Guardian Technologies will, at its sole option, either repair or replace any part or parts that are defective or replace or repair the whole product with the same or comparable model. For all warranty claims, the product may be required to be returned to Guardian Technologies at the customer's expense with proof of purchase sufficient to demonstrate warranty coverage. Contact the Guardian Technologies customer service department to obtain a Return Authorization (RA). Please do not return products without an RA or the warranty claim will not be processed.

What this warranty does not cover: This warranty does not apply if the product was damaged or failed because of accident, improper handling or operation, shipping damage, abuse, misuse, alteration, or unauthorized repairs made or attempted. Guardian Technologies shall not be liable for (i) incidental or consequential damages from any cause whatsoever, or (ii) replacement or repair of any house fuses, circuit breakers or receptacles. Notwithstanding anything to the contrary, in no event shall Guardian Technologies' liability exceed the purchase price of the product and any such liability shall terminate upon the expiration of the warranty period. Some states and provinces do not allow limitations on implied warranty or the exclusion or limitation of incidental or consequential damages, so these exclusions or limitations may not apply to you. You may also have other rights depending on your state or province of residence.

CUSTOMER SERVICE: Email: support-GT@lasko.com Web: www.lasko.com. Our Customer Service team is available to assist you with product service questions and replacement parts. Chat with us at www.lasko.com Monday-Friday 8am - 9pm EST (Valid in U.S. and Canada only). Please have your model number available (located on the underside/backside of your product). Customer Service Dept., 26251 Bluestone Blvd. Euclid, OH 44132. Please do not send product to this location.

Guardian Technologies LLC
26251 Bluestone Blvd. • Euclid, OH 44132
1.866.603.5900 • www.guardiantechnologies.com
©2016 Guardian Technologies LLC