GermGuardian Airsafe+ Intelligent Air Purifier + HEPA + UV-C

Limited Warranty

Guardian Technologies LLC warrants this product to be free of defects in materials or workmanship commencing upon the date of the original purchase. An original sales receipt or comparable substitute proof of purchase bearing the date of original purchase is required for eligibility. Warranty length for your specific model is available on the Guardian Technologies website. This warranty applies only to the original purchaser and covers repair or replacement of defective parts free of charge. It does not apply to damage resulting from unusual wear, commercial/abusive/unreasonable use, unauthorized repairs, or use not in accordance with the manual. Defects from normal wear and tear are not considered manufacturing defects.

To submit a product for warranty service, the complete machine must be delivered pre-paid to Guardian Technologies LLC. Include a description of the problem, the product model number, the date of purchase, and a copy of the original sales receipt, along with your name, address, and telephone number.

Contact Information:
USA and Canada
Guardian Technologies LLC
26251 Bluestone Blvd.
Euclid, Ohio 44132
1.866.603.5900
www.guardiantechnologies.com

Product registration is optional but recommended for superior customer service. Additional copies of the instruction manual can be obtained from the website or by calling customer service.

Warnings and Safety Instructions

❗ Failure to comply with the warnings listed below may result in electric shock or serious injury.

This product should be used only in accordance with the specifications outlined in this manual. Usage other than what has been specified here may result in serious injury.

When using electrical appliances, basic precautions should always be followed:

• Read all instructions before using the appliance.
• IMPORTANT: This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of electric shock, this plug is intended to fit in a polarized outlet only one way. If the plug does not fit fully, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
• WARNING: To reduce the risk of fire or electric shock, do not use with an extension cord.
• To avoid fire or shock hazard, plug the appliance directly into a 120V AC electrical outlet.
• Keep the cord out of heavy traffic areas. To avoid fire hazard, NEVER put the cord under rugs, near heat registers, radiators, stoves, or heaters.
• To protect against electrical hazards, DO NOT immerse in water or other liquids. Do not use near water.
• Extreme caution is necessary when any appliance is used by or near children or people with disabilities, and whenever the appliance is left operating unattended.
• This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction by a person responsible for their safety. Children should be supervised to ensure they do NOT play with the appliance.
• Always unplug the air purifier before moving it, opening the grill, changing filters, cleaning, or whenever it is not in use. Pull by the plug, not the cord.
• NEVER drop or insert any object into any openings.
• DO NOT run cord under carpeting or cover with throw rugs, runners, or similar coverings.
• DO NOT route cord under furniture or appliances. Arrange cord away from traffic areas where it will not be tripped over.
• DO NOT operate any appliance with a damaged cord or plug, if the motor fan fails to rotate, after malfunctions, or if it has been dropped or damaged. Call Customer Service for assistance.
• If the supply cord is damaged, it must be replaced by the manufacturer, service agent, or similarly qualified persons to avoid a hazard.
• Use appliance only for intended household use as described in this manual. Any other use may cause fire, electric shock, or injury.
• DO NOT use outdoors.
• DO NOT place anything on top of the unit.
• NEVER block air openings, grills/outlets, or place on soft surfaces like a bed or sofa, as this could cause the unit to tip over, blocking air flow.
• DO NOT attempt to repair or adjust any electrical or mechanical functions. Doing so will void your warranty. No user-serviceable parts inside; all servicing by qualified personnel only.
• WARNING: To reduce the risk of fire or electric shock, do not use this purifier with any solid-state speed control device.
• WARNING: Skin or eye damage may result from directly viewing the light produced by the lamp. Always disconnect power before replacing lamp or servicing. Replace Lamp With Model No. LB1000, Manufactured by Guardian Technologies.
• Always unplug the unit before cleaning or servicing.
• CAUTION: DO NOT use gasoline, benzene, thinner, harsh cleaners, etc., on or in the unit, as they will damage the product. NEVER use alcohol or other solvents.
• CAUTION: THIS EQUIPMENT SHOULD BE INSPECTED AND CLEANED REGULARLY TO PREVENT EXCESSIVE ACCUMULATION OF DUST PARTICLES THAT CAN RESULT IN FLASHOVER OR A RISK OF FIRE.
• The 8 hour TWA Ozone for this product is 0.001 ppmv. The product complies with the maximum allowable concentration of ozone of 0.050 ppmv in a 24-hour period.
• WARNING: Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.
• This product earned the ENERGY STAR label by meeting strict energy efficiency guidelines set by the U.S. EPA.
• [Hg] LAMP CONTAINS MERCURY Manage in accordance with Spills, Disposal and Site Cleanup Requirements. In case of breakage, follow clean-up procedures provided by contacts below. www.epa.gov/cflcleanup 1-866-284-4010

Specifications

Product: Intelligent Air Purifier + HEPA + UV-C

Model No.: AC3000

Brand: GermGuardian

Air Cleaning System

Improve your indoor air quality with your new Germguardian Air Purifier. The HEPA filter captures allergens and includes a charcoal filter layer to help reduce household odors. The UV-C light helps to reduce airborne germs.

Diagrams and Components

Unit Overview: The GermGuardian Airsafe+ air purifier is a cylindrical device. The top surface features an air outlet grille, a UV-C button, and a Power/Speed Setting button. The front displays the 'germ guardian' logo and the 'intellisense ai™ Air Quality Monitor'. Air inlets are visible on the sides. The power cord emerges from the rear, and the bottom is covered by a filter cover.

Control Panel: The control panel includes a 'UVC Reset' button (press 3 sec.) and a 'UV-C' button. Below these is a rotary dial with settings for 'Auto', 'Off', and fan speeds (indicated by icons). A 'Filter Reset' button (press 3 sec.) is also present.

Air Purification System Components: The system comprises three main components: a UV-C Bulb, a HEPA Filter, and an Activated Carbon Filter, which are stacked vertically inside the unit.

Operating Instructions

Before Operating the Air Purifier:

1. Select a firm, level, and flat location for the air purifier.
2. For proper air flow, locate the unit at least 1 foot [0.3 meters] from any wall or furniture.
3. Ensure none of the grills are blocked.
4. Plug the power cord into a 120V AC outlet.

Operating the Air Purifier (Power Button):

Press the power button:

• ONCE: Turns the unit on and sets it to Auto mode. The Auto Mode indicator will turn on.
• TWICE: Sets speed to 1 (Low). The low fan speed indicator will turn on.
• THREE times: Sets speed to 2 (Medium). The medium fan speed indicator will turn on.
• FOUR times: Sets speed to 3 (High). The high fan speed indicator will turn on.
• FIVE times: Enters Sleep mode. The air quality monitor on the front will flash for 10 seconds, all lights will turn off, and the purifier will run at low fan speed.
• SIX times: Powers the unit off.

UV-C Button:

Press the UV-C button to turn the UV-C light on. The button will illuminate when the UV-C light is on. Press again to turn it off.

What is Auto Mode?

In Auto Mode, the fan speed automatically adjusts based on the air quality level in the room. If the Air Quality Monitor (AQM) detects higher particle levels, the purifier will increase fan speed. Once air quality improves, it will lower the speed. Leaving the purifier in Auto mode 24/7 is recommended for best results.

To exit Auto Mode, press the power button again to cycle through the remaining speed levels.

What is Sleep Mode?

In Sleep Mode, the air purifier runs at Speed One with no lights, while still filtering the air. To exit Sleep Mode, press the power button again; the unit will shut off.

Air Quality Monitor (AQM)

The Air Quality Monitor senses and detects the amount of particulate matter (PM2.5) in the air. The light on the front of the unit changes colors to indicate the air quality level in the room. The fan speed in 'AUTO' mode is selected based on the detected particulate matter.

Filter Cleaning and Maintenance

When to Replace the Filter:

Depending on usage and environmental conditions, the filter will last approximately 6 months. The filter replacement indicator light on the control panel will flash red when it is time to replace the filter. The filter will also turn from white to grey when it is dirty and needs replacing.

IMPORTANT: DO NOT wash and re-use the filter. Please contact Customer Service or visit our website guardiantechnologies.com to purchase a replacement filter.

Removing and Replacing the Filter:

1. Turn off and unplug the unit.
2. Remove the bottom panel by pressing the two corners and pulling up.
3. Replace with new filter, pushing completely into unit.
4. Return bottom panel and ensure all three corners are locked in place when you hear the click.

IMPORTANT: Make sure the filter is installed and the bottom panel is closed properly, otherwise the unit will not function.

Reset the Filter Light:

Hold the Power Button control for 3 seconds to reset the filter indicator light.

Installing & Removing UV-C Bulb

The UV-C light indicator will flash continuously when it's time to replace the UV-C bulb. Replace the bulb according to the directions, then press the UV-C control button and hold for 3 seconds to reset the UV-C indicator light.

Changing the UV-C Bulb:

1. The UV-C bulb is located in a compartment in the center of the purifier. To access, first follow the instructions to remove the filter.
2. After removing the filter, hold the unit in place with one hand. Locate the bulb cover and turn in a counter-clockwise [left] direction to remove.
3. Hold the unit in place with one hand. Turn the bulb in a counter-clockwise [left] direction to loosen from the socket.
4. Screw in the new bulb using a clockwise motion. Wipe off fingerprints with a dry cloth.
5. Reassemble by reversing steps 1 & 2. Turn the unit back on and hold the UV-C control button for 3 seconds to reset the UV-C indicator light.

IMPORTANT: The UV-C bulb should be replaced every 10 months depending on use.

Note: Do NOT stick any foreign objects or your fingers inside the unit.

Cleaning and Maintenance

General Cleaning:

• Always unplug the appliance before you clean it.
• Never immerse the appliance in water or any other liquid.
• Never use aggressive or flammable cleaning agents such as bleach or alcohol to clean any part of the appliance.

Body of the Appliance:

Regularly clean the inside and outside of the body to prevent dust from collecting.

1. Wipe away dust with a soft dry cloth from the body of the appliance.
2. Clean the air inlet and the air outlet with a soft dry cloth.

Pre-filter Screen:

The pre-filter/charcoal layer collects larger dust and debris and should be cleaned monthly or more frequently depending on use. Remove and clean regularly with the brush attachment of your vacuum cleaner. This will remove lint and dirt and help maintain the life of the filter. (See filter replacement section to locate and clean or remove the filter). Replacement pre-filters are available on the website.

Troubleshooting Guide

Replacement Parts

Filters:

• Model No. FLT151
• FLT151SM (Smoke)
• FLT151VO (VOC's / Toxins)
• FLT151PT (Pet)

Replacement Bulb: Model No. LB1000

Carbon Replacement (4-PACK): Model No. FLT15CB4

Check out the AutoShip & Save Filter Replacement Program™ at www.guardiantechnologies.com for filter replacements.

Important Information

[ENERGY STAR certified] This product earned the ENERGY STAR label by meeting strict energy efficiency guidelines set by the U.S. EPA.

[Hg] LAMP CONTAINS MERCURY Manage in accordance with Spills, Disposal and Site Cleanup Requirements. In case of breakage, follow clean-up procedures provided by contacts below. www.epa.gov/cflcleanup 1-866-284-4010

WARNING: Cancer and Reproductive Harm. For more information go to www.P65Warnings.ca.gov.