Brook P5 PLUS Fighting Board Firmware Update Guide

Introduction

This document describes how to update the firmware of the Brook P5 PLUS Fighting Board.

Important Notes:

• The update must be performed on a PC; it cannot be done on a console.
• Ensure your PC is connected to the internet.
• You may need to disable antivirus software or run the program as an administrator.

Update Procedure

Step 1: Download the Update File

Download the latest update file from the "Download" section on the Brook website:

www.brookaccessory.com

[Image description: Icon representing the firmware update executable file]

Step 2: Connect the Board to PC

Press and hold the PS and Share/Select buttons simultaneously. While holding these buttons, connect the USB cable from the board to your computer.

[Image description: Visual guide showing pressing PS and Share/Select buttons, then connecting USB to PC.]

Step 3: Start the Update

Once the "START" icon appears in the firmware update application, click it to begin the update process.

[Image description: Firmware update application window showing "Select Version", "Device Current Version", and a "START" button.]

Step 4: During the Update

DO NOT disconnect the board from the PC during the update process.

[Image description: Firmware update application showing the Brook logo and "Don't remove the device."]

Step 5: Successful Update

When the firmware update is successfully finished, the following screen will be displayed:

[Image description: Screen showing a large green checkmark and the text "The firmware has been successfully updated." with a "FINISH" button.]

Step 6: Failed Update

If the firmware update fails, the following screen will be displayed. Please try the setup again from the beginning.

We recommend visiting the Brook website (www.brookaccessory.com) to download the update file again before restarting the update.

[Image description: Screen showing a large red cross symbol and the text "The firmware update failed." with a "Confirm" button.]