Hama USB-C and USB-A PD/QC 3.0, 2.0, 30W Charger - Operating Instructions

Thank you for choosing this Hama product!

Take your time and read the following instructions and information completely. Please keep these instructions in a safe place for future reference.

1. Explanation of warning symbols and notes

• Risk of electric shock: This symbol indicates a risk of electric shock from touching uninsulated product parts that may carry hazardous voltage.

• Warning: This symbol is used to indicate safety instructions or to draw your attention to specific hazards and risks.

• Note: This symbol is used to indicate additional information or important notes.

2. Package contents

• Charger
• These operating instructions

3. Safety instructions

• Protect the product from dirt, moisture and overheating and use it in dry rooms only.
• Do not drop the product and do not expose it to any major shocks.
• Do not operate the product outside the power limits specified in the technical data.
• Do not modify the device in any way. Doing so voids the warranty.
• Do not continue to operate the product if it is visibly damaged.
• Use the product only for the intended purpose.
• As with all electrical products, this device should be kept out of the reach of children.
• Do not use the product in the immediate vicinity of heaters, other heat sources or in direct sunlight.
• Route all cables so there is no risk of tripping.
• Do not bend or crush the cable.
• Always pull directly on the plug when disconnecting the cable, never on the cable itself.
• Dispose of packaging material immediately in accordance with the locally applicable regulations.
• The product is intended only for use inside buildings.
• Only use the article under moderate climatic conditions.
• Do not use the product in areas in which electronic products are not permitted.
• Do not use the product in a damp environment and avoid splashing water.
• Risk of electric shock: Do not open the device or continue to operate it if it becomes damaged.
• Do not use the product if the AC adapter, the adapter cable or the mains cable are damaged.
• Do not attempt to service or repair the product yourself. Leave any and all service work to qualified experts.

4. Operation

• Note - mains voltage 100 - 240 V: The charger is suitable for mains voltages of 100 - 240 V and therefore can be used worldwide. Please note that a country-specific adapter may be necessary.
• Warning - connecting devices: Before connecting a device, check whether it can be adequately supplied with the charger's current capacity. Ensure that the power of the connected device does not exceed 20 W. Note the instructions in your device's operating manual.
• Note - Power Delivery / QC 3.0, 2.0: Plug & GO: no additional software required, simply plug in and start: Thanks to Power Delivery / QC 3.0, 2.0, the voltage and power are adjusted automatically. Be aware that, for efficient and optimised charging, your terminal device must support the PD (Power Delivery) / QC 3.0, 2.0 function. If you have a large number of PD/QC-enabled devices with different firmware updates, it may be that the function is not fully supported.

5. Care and maintenance

• Only use soft, dry towels to clean the product.
• Note: Disconnect the device from the mains before cleaning and during prolonged periods of non-use.

6. Technical data

7. Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides no warranty for damage resulting from improper installation/mounting, improper use of the product or from failure to observe the operating instructions and/or safety notes.