Qoltec 63A DIN Rail Relay with Electricity Meter - Operating Instructions
Thank you for choosing the Qoltec 63A DIN rail relay with electricity meter. This manual provides essential information for the installation and use of this product, including important safety guidelines for proper operation and installation. For any questions after reading this manual, please contact the Qoltec Customer Service Department.
About the Product
The Qoltec 50990 device facilitates the automatic control of electricity flow in domestic and industrial systems. Its advanced features ensure safety and energy efficiency, offering complete control over connected devices.
Device Functions
- Remote Control: Manage the device from any location, at any time.
- Timer and Cyclic Timer: Program the unit to operate within specific time frames.
- Energy Measurement: Monitor electricity consumption.
- Low Voltage Protection: Adjustment range: 50V-190V; automatic disconnection at 170V.
- High Voltage Protection: Adjustment range: 250V-300V; automatic disconnection at 270V.
- Current Overload Protection: Adjustment range: 1A-63A; automatic disconnection at 63A.
- Current Leakage Protection: Default setting is 50mA.
- Automatic Disconnection: The device automatically shuts down when voltage and current thresholds are exceeded.
Technical Parameters
| Rated supply voltage: | AC 220V |
| Operating range: | AC 80V-400V (single phase) |
| Rated frequency: | 50 / 60 Hz |
| Current range: | 1-63 A |
| Tripping delay: | 0.5 s |
| Reset/reboot delay: | 5-90 s |
| Measurement accuracy: | ± 2 % |
| Rated insulation voltage: | 1000 V |
| Operating temperature range: | -30°C to 70°C |
| Energy consumption display range: | 0-9999 kWh |
Wiring Diagram
Refer to Figure 1 for the wiring diagram.
Installation of the Unit
Warning: Installation should be performed by a qualified electrician. Ensure the power is switched off before commencing installation. This unit is intended for indoor use only. Avoid exposure to direct moisture or extreme temperatures. Mount the Wi-Fi relay securely on the DIN rail.
Setting Parameters
- Press the SET button to display all data.
- Press and hold the SET button for 5 seconds to enter setting mode.
- Use the UP and DOWN buttons to adjust the settings.
Wi-Fi Connection: Hold down the button for 5 seconds until the Wi-Fi indicator flashes rapidly. Enable Bluetooth on your smartphone, launch the device app, and the indicator will flash slowly. Select "Doodle Function" (or tap '+'), choose your Wi-Fi network, enter the network name and password, and click "Next". Note: Only 2.4 GHz networks are supported. If you have a 5GHz network, configure it to 2.4GHz using your router's settings.
Service and Repair
Improper repairs can cause serious device damage and pose a risk to the user. If you encounter issues with your device and lack the necessary experience or knowledge for repair, it is recommended to seek assistance from a specialist or technical service. Warranty repairs may be available if the defect is due to a manufacturing issue. This can include repairing defective components, replacing parts, or replacing the entire product if repair is not feasible.
Maintenance and Cleaning
- Turn off the power before cleaning.
- Wipe the unit with a dry cloth. Do not use chemicals or water.
Disposal
To prevent environmental pollution, avoid disposing of this appliance with regular household waste. Return the device to designated electronic waste collection points or recycling facilities.
