Qoltec 50990 DIN Rail Relay 63A with Electricity Meter
Thank you for choosing Qoltec. This manual provides instructions for the installation and use of the product, including important safety guidelines for proper operation and installation. For any questions after reading this manual, please contact our Customer Service.
Product Information
The device allows for automatic control of electrical energy flow in domestic and industrial installations. Its advanced features ensure safety and energy efficiency, providing full control over connected devices.
Device Functions
- Remote Control: Allows management of the device from anywhere, at any time.
- Timer and Cyclic Timer: Enables programming of the unit's operation within a specific time frame.
- Energy Measurement: Monitors the amount of electricity consumed.
- Low Voltage Protection: Adjustment range: 50V-190V; automatic disconnection in case of failure: 170V.
- High Voltage Protection: Adjustment range: 250V-300V; automatic disconnection in case of failure: 270V.
- Current Overload Protection: Adjustment range: 1A-63A; automatic disconnection in case of failure: 63A.
- Leakage Current Protection: Default setting 50mA.
- Automatic Device Disconnection: Thresholds for voltage and current can be set, beyond which the device automatically switches off.
Technical Parameters
| Parameter | Value |
| Rated supply voltage | AC 220V |
| Operating range | AC 80V-400V (single-phase) |
| Rated frequency | 50 / 60 Hz |
| Current range | 1-63 A |
| Trip delay | 0.5 s |
| Reset/restart delay | 5-90 s |
| Measurement accuracy | ± 2 % |
| Rated insulation voltage | 1000 V |
| Operating temperature range | -30°C to 70°C |
| Energy consumption display range | 0-9999 kWh |
Wiring Diagram
Refer to Figure 1 for the wiring diagram.
Unit Installation
Attention:
Installation of the appliance must be performed by a qualified electrician. Ensure the power supply is turned off before starting installation. The unit is intended for indoor use. Do not expose it to direct moisture or extreme temperatures. Mount the Wi-Fi relay on the DIN rail, ensuring it is securely fastened.
Parameter Setting
- Press the SET button to display all data.
- Press and hold the SET button for 5 seconds to enter setting mode, then use the UP and DOWN buttons to adjust the settings.
Wi-Fi Setup: Hold the button for 5 seconds until the WIFI indicator flashes rapidly. Activate Bluetooth on your phone, start the device, and the indicator will flash slowly. In the app, select "Doodle Function" (or click "+"), choose your Wi-Fi network, enter the name and password, and click "Next" (only 2.4 GHz networks are supported). If your Wi-Fi network is 5GHz, set it to 2.4GHz using your router's configuration method.
Assistance and Repair
Improper repair can cause serious damage to the device and pose a risk to the user. If you experience problems with the device and lack the experience or knowledge for repair, it is advisable to consult a specialist or technical service. Warranty repair is available if the defect is due to a manufacturing issue. Warranty repair may include repairing the faulty component, replacing parts with new ones, or replacing the entire product if repair is not feasible.
Maintenance and Cleaning
- Turn off the appliance before cleaning.
- Clean the unit with a dry cloth. Do not use chemicals or water.
Disposal
To prevent environmental pollution, do not dispose of the appliance in regular waste containers. Return the appliance to designated electronic waste collection points or recycling centers for electronic equipment.
