Dumor Rabbit Cage Assembly Instructions

Assembly Steps

1. Take the folded cage out of the carton and place it on a flat surface. Remove the top panel and ensure the door on the front panel is closed to keep the cage secure during assembly.

   [Image Description: A flat, folded wire cage with a close-up view of the door latch mechanism.]

2. Grab any two adjacent side panels and slide the vertical panel into the side hooks until secure.

   [Image Description: Two side panels being connected, with a close-up showing how the vertical panel slides into hooks on the side panels.]

3. Repeat step 2 for the remaining side panels. You should now have the sides of the cage assembled.

   [Image Description: A partially assembled cage showing three sides connected.]

4. Gently place the top panel on the cage, then secure the top panel with the hooks on all 4 sides. This is similar to securing the side panels.

   [Image Description: The top panel being placed onto the assembled sides, with a close-up of the hooks used for attachment.]

5. Check the cage and make sure all the panels are well secured in position.

   [Image Description: A fully assembled rabbit cage.]