Instruction Manual for JMTek models including: MPB800, MPB800 Wireless Power Bank, Wireless Power Bank, Power Bank, Bank
JMTEK TECHNOLOGY(ZHONGSHAN) CO., LTD MPB800 WirelessPowerBank 2BNTC-MPB800 2BNTCMPB800 mpb800
180mm Wireless Power Bank 1:1 c'SPOU 90mm c#BDL 180 x 90mm 70g 2 MPB800-SMS-JMT001 MPB800 70431-0372-01 90 x 45mm 241212 Sam Steven EU warning statement: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. Product name: Wireless Power Bank Product model: MPB800 Manufacturer: JMTEK TECHNOLOGY(ZHONGSHAN) CO., LTD Frequency Range: 112kHz~205kHz Max. Transmit Power: 23.79(db A/m) SIMPLIFIED EU DECLARATION OF CONFORMITY The simplified EU declaration of conformity referred to in Article 10(9) shall be provided as follows: Hereby, JMTEK TECHNOLOGY(ZHONGSHAN) CO., LTD declares that radio equipment type MPB800 is in compliance with Directive 2014/53/EU, and this product is allowed to be used in all EU member states. The full text of the EU declaration of conformity is available at following This product can be used across EU member states. EUT Operating temperature: -10~45 Caution: Risk of explosion if battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. FCC warning: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the folRloeworiniegnmt oerarseulroecsa:te the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction. MPB800-SMS-JMT001 MPB800 70431-0372-01 241212 Sam StevenAdobe PDF library 15.00 Adobe Illustrator(R) 24.0