User Manual for Shenzhen models including: NDASCNFC, NDASCNFC scnfc, SC-NFC Reader, SC-NFC, Reader
Gold Apollo Co Ltd SCNFC NFC reader NDASCNFC NDASCNFC scnfc
File Info : application/pdf, 2 Pages, 862.05KB
DocumentDocumentNFC Reader NFC SC-NFC User Manual 000-00000-0 ONLINE MANUAL 250305-V1.1 · Do not operate this device in a hazardous atmosphere. · Do not replace or change accessories in a hazardous atmosphere. Contact sparking may occur while installing or removing accessories and cause an explosion or fire. · Do not disassemble this device in any way that exposed the internal electrical circuits of the unit. · Make sure to read this manual before using the machine. Please keep it in hand for future reference. · Disclaimer: The products of GOLD APOLLO are intended for legal use only. Users must comply with local laws and regulaons. GOLD APOLLO assumes no legal responsibility for any consequences arising from improper, illegal, or infringing acons. In the event of violaons, we reserve the right to terminate transacons. : OVERVIEW PREPAREDNESS SPECIFICATIONS NFC NFC Sensing Area Power Cable Port TRG Indicator Power Indicator NFC NFC Reader (SC-NFC) USB-C USB-A USB-C to USB-A Cable STANDBY CURRENT <100mA RFID PROTOCOL ISO/IEC 14443A/B , ISO/IEC15693 OPERATING FREQUENCY 13.56Mhz TAG READING DISTANCE 0~30mm OPERATING VOLTAGE DATA TRANSMISSION FORMAT ANTENNA DIMENSION & WEIGHT 4.5~5.5V USB HID Keyboard PCB Antenna 69(W)×104(H)×12.6(D)mm ; 55 g OPERATION PROCEDURE FOR SC-NFC WITH SC-800 SC- USB-C to USB-A SC-800 SC-NFC Use a USB-C to USB-A cable to connect the SC-800 and SC-NFC. (The connection is successful when the power indicator light turns red.) NFC Tag SC-NFC TRG When the restaurant pager with an NFC tag is brought close to the sensing area, the SC-NFC's TRG indicator light will flash red once and emit a beep sound, indicating a successful detection. Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help. FCC Caution To assure continued compliance, any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. (Example - use only shielded interface cables when connecting to computer or peripheral devices). FCC Radiation Exposure Statement This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 0.5 centimeters between the radiator and your body. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. The antennas used for this transmitter must be installed to provide a separation distance of at least 0.5 cm from all persons and must not be co-located or operating in conjunction with any other antenna or transmitter. (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NCC Regulatory Notice 1. 2. 3.Adobe PDF library 17.00 Adobe Illustrator 27.6 (Windows)