What's Included
The following items are typically included with your Clover Kitchen Display System:
- Clover Kitchen Display System unit
- Power adapter
- Regional power cables (select regions)
Illustrations show a power adapter brick, a cable connecting to the display, and regional power cables with different plug types.
Mounting and Connections
VESA Mounting
The system supports 100mm VESA mounting. Use M4 screws with a maximum length of 14mm (4 screws required).
Diagram shows the rear of the display with VESA mounting holes and screw indicators. It also labels the "Power Over Ethernet" port.
Ports
The display features a Power Over Ethernet (PoE) port, a power input port, and USB ports.
Setup Instructions
Step 1: Attach to Stand
Use the instructions provided with your stand to attach the screen. Note: The stand is not included.
Diagram illustrates attaching the display to a stand using screws through the VESA mount bracket.
Step 2: Connect Power (AC Adapter)
1. Remove any waterproof caps from the power port first.
2. Plug the power adapter into the display.
3. Plug the power adapter into a grounded AC power outlet.
Diagram shows the power adapter being connected to the display and then to a wall outlet. An icon indicates the power port on the display.
Step 3: Connect Power (Power Over Ethernet - PoE)
On PoE-enabled networks, the Power Over Ethernet port (IEEE 802.3at, PoE+) can be used as an alternative source of power.
Diagram shows an Ethernet cable connecting the display's Ethernet port to a PoE+ network port.
PoE Considerations: The Clover KDS should be connected only to PoE networks without routing to the outside plant.
Regulatory Information
FCC Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to two conditions: (1) it may not cause harmful interference, and (2) it must accept any interference received.
This equipment has been tested and found to comply with the limits for a Class B digital device, designed to provide reasonable protection against harmful interference in residential installations. It generates, uses, and can radiate radio frequency energy.
If interference occurs:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment to an outlet on a circuit different from the receiver's.
- Consult a dealer or experienced radio/TV technician.
FCC Warning: Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. This transmitter must not be co-located or operating with any other antenna or transmitter. Operations in the 5.15-5.25GHz band are restricted to indoor usage only.
FCC Radiation Exposure Statement
This equipment complies with FCC radio frequency (RF) exposure limits for an uncontrolled environment. It should be installed and operated with a minimum distance of 20 cm between the radiator and your body.
Innovation, Science and Economic Development Canada (ISED) Statement
This device complies with ISED's licence-exempt RSSs. Operation is subject to the following two conditions: (i) this device may not cause harmful interference, and (ii) this device must accept any interference received, including interference that may cause undesired operation.
(French translation: Le présent appareil est conforme aux CNR d' ISED applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes: (i) le dispositif ne doit pas produire de brouillage préjudiciable, et (ii) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable.)ISED Radiation Exposure Statement
This equipment complies with ISED radiation exposure limits set forth for an uncontrolled environment. It should be installed and operated with greater than 20cm between the radiator and your body.
(French translation: Cet équipement est conforme aux limites d'exposition aux rayonnements ISED établies pour un environnement non contrôlé. Cet équipement doit être installé et utilisé à plus de 20 cm entre le radiateur et votre corps.)Caution
Operation in the 5150-5250 MHz band is for indoor use only to reduce potential interference to co-channel mobile satellite systems. Applicable antenna types, models, and worst-case tilt angles for compliance must be clearly indicated.
(French translation: Les dispositifs fonctionnant dans la bande 5150-5250 MHz sont réservés uniquement pour une utilisation à l'intérieur afin de réduire les risques de brouillage préjudiciable aux systèmes de satellites mobiles utilisant les mêmes canaux. Les types d'antennes, numéros de modèle et angles d'inclinaison nécessaires pour rester conforme à l'exigence de la p.i.r.e. applicable au masque d'élévation doivent être clairement indiqués.)Product Information
Product Name: Clover Kitchen Display System 24"
Model Number: C701
Manufacturer: Clover Network, LLC.
Address: 415 N Mathilda Ave, Sunnyvale, CA 94085, USA
Patents: clover.com/patents
Waste Electrical and Electronic Equipment (WEEE)
This product is covered electronic equipment under the European Union's WEEE Directive (2012/19/EU). It requires separate collection and management from typical household waste in all EU member states. Please follow guidance from your local environmental authority or the retailer for collection or recycling options.
WEEE Symbol: ♻️ [Recycling Symbol]
Document Version/Identifier: HDUIA002010-3A (v6)
Clover Help
