Grille Installation Instruction
For 2003-2007 Scion XB
Part#: T65441C/J
Rev. 180401
Parts List
| Item | Part Name | QTY | Description | Item | Part Name | QTY | Description |
|---|---|---|---|---|---|---|---|
| 1 | Billet Grille | 2 | Stainless steel | 3 | Keyslot Studs | 10 | 6-32×2" |
| 2 | Mounting Clips | 10 | 4 | Kep Nuts | 10 | 6-32 |
Install Notes
Overlay ✓ Replacement X Drill X Cut X
| Step | Description | Illustration |
|---|---|---|
| 1 | Identify the grille & hardware with parts list. |
[Image of grille and hardware] |
| 2 | Optional (for vehicles with black plastic cover under hood), Pop hood, remove the black plastic cover (on top of OEM grille / front panel) from vehicle. This will allow access to the rear of the grille shell. If you are still unable to access the rear, remove the grille shell and reattach after installation. | N/A |
| 3 | Center the billet grille into the opening of the factory grille shell. Secure the bolt to the threaded holes on the front of the grille. Be sure the bolts are through the OEM grille shell. | N/A |
| 4 | Secure billet grille using the mounting clip and nuts from the back side of the OEM grille shell. | N/A |
| 5 | Make sure the billet grille is centered and tighten the fasteners, but do not over-tighten. | N/A |
| 6 | Reinstall the black plastic cover which was removed in step 2. | N/A |
| 7 | Installation completed!!! | N/A |
The instruction here is for your reference only. You may need to bend the billet grille bars or tabs a little bit to adjust to fit. APS strongly recommends the professional installer for best result.
Please use masking tape and tape the OEM grille shell along the edge to protect your vehicle during installation.
APS is not responsible for any damage caused by the installation. Thank you for choosing our product!
Page 1 of 1
grille.Be
