Grille Installation Instruction
Rev. 190301
Part Information
Part#: D45320A/H
Application: For 2005-2010 Dodge Charger 1 PC Cover All
Parts List
| Item | Part Name | QTY | Description | Item | Part Name | QTY | Description |
|---|---|---|---|---|---|---|---|
| 1 | Grille | 1 | Stainless steel | 4 | Studs | 2 | 6-32×1.5" |
| 2 | Studs | 2 | 6-32×3" | 5 | Lock Nuts | 4 | 6# |
| 3 | Plastic Clip | 6 | - | 6 | Flat Washers | 4 | 6# |
Install Notes
Overlay: ❌
Replacement: ✅
Drill: ✅
Cut: ❌
Installation Steps
-
Step 1: Identify the grille & hardware with parts list.
Illustration: A diagram showing a grille with horizontal slats.
-
Step 2: Pop hood, remove the black plastic cover (on top of OEM grille / front panel) from vehicle. This will allow access to the rear of the grille shell.
-
Step 3: Thread a stud in each nut welded to the grille. Hold the grille against the OEM grille shell, center and mark holes for drilling. Remove billet grille and drill holes according to your mark. Secure grille using the flat washers and lock nuts from the back side of the OEM grille shell.
Illustration: A close-up view of the grille area on the car's front panel with arrows pointing to where studs, washers, and nuts should be attached. Text labels indicate: '(2) 6-32x1.5" Studs', '(2) 6# Flat Washers', '(2) 6# Lock Nuts' for the upper holes, and 'Mark and drill 2 holes', '(2) 6-32x3" Studs', '(2) 6# Flat Washers', '(2) 6# Lock Nuts' for the lower holes.
-
Step 4: Make sure the grille is centered and tighten the fasteners, but do not over-tighten.
-
Step 5: Reinstall the black plastic cover which was removed in step 2.
-
Step 6: Installation completed!!!
Illustration: A diagram showing the installed grille on the car.
Important Notes
The instruction here is for your reference only. You may need to bend the billet grille bars or tabs a little bit to adjust to fit. We strongly recommend the professional installer for best result.
Please use masking tape and tape the OEM grille shell along the edge to protect your vehicle during installation. We are not responsible for any damage caused by the installation. Thank you for choosing our product!
Page 1 of 1
