TCL LINKZONE MW63AF

Overview

The TCL LINKZONE MW63AF is a mobile hotspot device.

Buttons

Status LED Indicators

The device features several LED indicators:

• Signal Indicator (①):
  • Solid blue: Connected to the network.
  • Solid red: SIM card or network service not available.
  • Blinking blue: Disconnected from the network.
• Wi-Fi Indicator (②):
  • Solid blue: Wi-Fi is enabled.
  • Off: Wi-Fi is off.
• SMS Indicator (③):
  • Solid blue: New message(s).
  • Flashing blue: SMS inbox is full.
  • Off: No new message.
• Battery Indicator (④):
  • Solid blue: Battery level 21% - 100%.
  • Flashing blue: Device is charging.
  • Solid red: Battery level is low.

SIM Card and Battery Installation

Follow these steps to insert the SIM card and battery:

1. Locate the micro SIM card slot (①) and the reset button (②).
2. Insert a micro SIM card into the slot, ensuring correct orientation.
3. Insert the battery.

Note: Heed the orientation of your SIM card. Make sure you align the SIM card with the slot and slide it into the slot until it sits properly.

Power On

Press and hold the power button for 3 seconds to turn on your LINKZONE.

Connect to the Network

To connect to the network, ensure your SIM card is inserted and the device is powered on. The Signal Indicator will show the network connection status.

Note: The default Wi-Fi name and password can be found on the label inside your LINKZONE.

Configure the Network

To configure your LINKZONE Wi-Fi network:

1. Open a web browser on a device connected to the LINKZONE network.
2. Go to the login website (found on the label beneath the battery) and follow the on-screen instructions.

Note: For a full user manual, check the Help section on the login website.

General Information

• Manufacturer: TCL Communication Ltd.
• Address: 5/F, Building 22E, 22 Science Park East Avenue, Hong Kong Science Park, Shatin, NT, Hong Kong
• Website: Visit www.tcl.com/mx for tutorials, FAQs, and to download the User Manual.
• Support: For device support, visit TCL support website or call the relevant number for your region (e.g., Argentina: 0810-999-1099, Chile: +56 229589694, Colombia: 18009520823, Ecuador: 800000635, Mexico: 8008909908, Peru: 080000698, Dominican Republic: 8887600164, Uruguay: 405296624, Venezuela: 08001005368).

Important Safety Information

Read all safety information before using your device. Failure to follow these instructions could result in injury or damage to your device or other property.

Safety and handling instructions

• Do not use the device in areas where wireless devices are prohibited.
• Keep the device at least 15 cm from medical devices like pacemakers, hearing aids, or insulin pumps. Consult your physician and the medical device manufacturer for specific guidance.
• Do not allow children to use the device and its accessories unsupervised.
• Handle your device with care and keep it in a clean, dust-free place.
• Do not attempt to repair the device yourself.
• Do not drop, throw, or bend your device.
• Do not dispose of the device and its accessories in a fire.

Power Adapter

Charge your device with the supplied USB cable. Use only adapters compliant with international and regional safety standards (CE-approved). Using other adapters may cause damage or pose a risk. Keep the adapter in a well-ventilated area. Do not use damaged power adapters.

• Recommended adapter specifications: Input voltage/AC frequency: 100-240 V, 50/60 Hz; Output voltage/current/power: 5.0 V / 1.0 A / 5.0 W.

Battery

CAUTION: RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERIES ACCORDING TO INSTRUCTIONS.

The battery may not be fully charged upon purchase. Please charge it first.

• Do not attempt to open the battery.
• Do not puncture, disassemble, or short-circuit the battery.
• Recycle or dispose of batteries separately from household waste according to local environmental laws.
• Replace the battery only with a qualified battery of the same type.
• Do not use a damaged battery.

Operating Environment

The device operates best between 0°C and 45°C (32°F and 113°F) and should be stored between -10°C and 70°C (14°F and 158°F). Avoid dramatic changes in temperature or humidity.

Waste Disposal and Recycling

Dispose of the device, accessories, and battery in accordance with applicable environmental regulations. Take these items to designated municipal waste disposal centers or collection points at points of sale for recycling.

Radio Waves

THIS DEVICE MEETS GOVERNMENT REQUIREMENTS FOR EXPOSURE TO RADIO WAVES.

The Specific Absorption Rate (SAR) limit is 1.6 W/kg averaged over 1 gram of body tissue, as set by authorities like the FCC. Tests are conducted using standard operating positions at the highest certified power level.

This device complies with SAR for general population/uncontrolled exposure limits in ANSI/IEEE C95.1-1992 and has been tested according to IEEE1528.

FCC ID: 2ACCJB188. SAR information can be found on the FCC website: www.fcc.gov/oet/ea/fccid. The highest SAR value for MW63AF when tested for body-worn operation is 1.25 W/Kg at a distance of at least 10 mm from the body using a non-metallic accessory.

For additional SAR information, visit the CTIA website: www.ctia.org.

This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. If interference occurs, try to correct it by reorienting or relocating the receiving antenna, increasing the separation between the equipment and receiver, connecting the equipment to an outlet on a different circuit, or consulting a dealer or experienced radio/TV technician.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.

For receiver devices associated with licensed radio service (e.g., FM broadcast), the following statement applies: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

Your device is a transceiver that operates in FDD LTE (Band 2/4/5/7/28/66), UMTS/HSPA/HSPA+ (Band 1/2/4/5/8).

Licenses

Certified by Wi-Fi Alliance.

Privacy Statement

Personal data shared with TCL Communication Ltd. will be handled according to their Privacy Notice, available at https://www.tcl.com/global/en/communication-privacy-policy.

Disclaimer

There may be differences between the user manual description and the device's operation depending on software release or operator services. TCL Communication Ltd. is not legally responsible for such differences or their consequences.