TPI Pocket Digital Thermometer

Selecting Measurement Mode

Select either the Fahrenheit or Celsius mode:

• With the unit "off", press and continue to hold the ON/OFF button. The LCD will alternate between °F and °C. Release the ON/OFF button when the desired measurement mode appears on the LCD.

Taking a Measurement

Remove the protective sheath from the stem. Press the ON/OFF button. Insert stem into the area or object to be tested. At least 1/2" of the stem must be inserted.

Auto Field Calibration

1. Fill a container with crushed ice and add clean water to a depth of 4 inches. Stir the ice and water for 2 to 3 minutes.
2. Insert at least one inch of the stainless steel shaft of the thermometer into the ice bath. Allow the reading on the thermometer to stabilize. The temperature reading must be within ±2° of 32°F or ±1° of 0°C for calibration to have effect.
3. Press and hold the D-H/CAL button for approximately 8 seconds until "CAL" is displayed. The thermometer will return to normal operation. Calibration is complete.

WARNING

The stem is a sharp and pointed object which can be dangerous.

Data Hold Function

The Data Hold function is used by pressing the D-H button when taking a measurement. The measurement will flash in the LCD when Data Hold is in use. To return to normal function, press and release the D-H button a second time.

Operation and Power Off

Press the ON/OFF button to end operation, or the unit will automatically power off after 35 minutes.

Specifications

Range

-58° to 300 °F/-50° to 150 °C

Resolution

0.1°F/°C

Accuracy

+/-2°F/+/-1°C

Sampling Time

1.5 seconds

Battery

1.5 Volt Button

Compliance

THIS INSTRUMENT is in compliance with:

• EN 61326-1:2013
• EN 61000-3-2:2014
• EN 61326-2-2:2013
• EN 61000-3-3:2013