Operating Instruction
1. Power off
The device should be powered off before any installation or maintenance.
Caution: To avoid electric shocks, please consult a qualified professional for help when installing and repairing. Do not touch the switch during use.
2. Wiring instruction
Input: 100-240V AC 50/60Hz
Output: 100-240V AC 50/60Hz
Wiring Diagram:
Connect the 100-240V AC power supply to the 'L In' and 'N In' terminals. Connect the light bulb to the 'L Out' and 'N Out' terminals. Ensure the neutral wire and live wire connections are correct.
Note: The device can only connect incandescent light bulbs and dimmable LED lights.
3. Download APP
Download the eWeLink app from the App Store or Google Play to manage your device.
Scan the QR code to download the eWeLink app for Android & iOS.
4. Power on
After powering on, the device enters quick pairing mode (Touch) and the connected light enters the “breathing mode”.
If the device is not paired within 3 minutes, it will exit quick pairing mode. To re-enter this mode, power off and restart the device until the connected light enters the “breathing mode”.
5. Add the device
Open the eWeLink app, tap “+” and select “Quick Pairing”. Follow the on-screen prompts to add the device.
Pairing method for the device and SONOFF RM433 remote controller:
Short press any button on the RM433 remote controller within 5 seconds after powering on the device. You will hear a “Bi” sound, indicating successful pairing.
Note: The RM433 remote controller is sold separately.
RM433 Introduction
| Buttons | Functions |
|---|---|
On |
On |
Off |
Off |
↓ |
Short press for low brightness, long press to turn down the brightness. |
↓ |
Short press for medium brightness, long press to turn down the brightness. |
↑ |
Short press for higher brightness, long press to turn up the brightness. |
↑ |
Short press for high brightness, long press to turn up the brightness. |
2 |
Long press for 5s until “Beep Beep” is heard, then release. The remote controller is cleared successfully. After clearing, short press any button within 5s after powering on again to pair. A “Beep” sound indicates successful pairing. |
➿ |
Long press for 5s until the connected light enters breathing mode. This indicates the device enters quick pairing mode (Touch). You can then add the device in the eWeLink APP. In quick pairing mode, short press any button on the remote controller to exit this mode. |
Specifications
| Model | D1 |
|---|---|
| Input | 100-240V AC 50/60Hz |
| Output | 100-240V AC 50/60Hz |
| Light Load | Incandescent:200W LED:150W |
| Operating systems | Android & iOS |
| Wi-Fi | IEEE 802.11 b/g/n 2.4GHz |
| RF | 433.92MHz |
| Working temperature | -10°C~40°C |
| Material | PC VO |
| Dimension | 62x47x32.5mm |
Features
The D1 is a Wi-Fi smart dimmer switch used to adjust light brightness and set various atmospheres. It allows remote control of lights, scheduling on/off times, and sharing control with family members.
Features include:
- Remote Control
- Single/Countdown Timing
- Voice Control
- Share Control
- Smart Scene
- 433MHz Remote Control
- Stepless dimming
- Scene Mode
- LAN Control
- Group control
Factory Reset
To reset the device to factory defaults, turn it on and off 3 times repeatedly or delete the connected light on the eWeLink APP until it enters “breathing mode”. The device will then be reset and enter quick pairing mode (Touch).
Note: Reset the device to factory defaults if you want to use other Wi-Fi networks, then reconnect the network.
