SONOFF D1 Wi-Fi Smart Dimmer Switch
User Manual V1.0
Specifications
| Model | D1 |
|---|---|
| Input | 100-240V AC 50/60Hz |
| Output | 100-240V AC 50/60Hz |
| Light Load | Incandescent: 200W LED:150W |
| RF | 433.92MHz |
| Operating Systems | Android 4.1 & iOS 9.0 or higher |
| Wi-Fi | IEEE 802.11 b/g/n 2.4GHz |
| Material | PC |
| Dimension | 62x47x32.5mm |
Features
- ? Remote Control
- ⏰ Single/Countdown Timing
- ? Voice Control
- ? Share Control
- ? Brightness Adjustment
- ? Scene Mode
- ? 433MHz Remote Control
- ? Sync Status
- ? LAN Control
RM433 Introduction
The RM433 is a remote controller for the SONOFF D1 dimmer switch.
| Button | Function |
|---|---|
| Power Button (On) | On |
| Power Button (Off) | Off |
| ▼ (Brightness Down) | Short press for low brightness, long press to turn down brightness. |
| ▼ (Brightness Down) | Short press for medium brightness, long press to turn down brightness. |
| ▲ (Brightness Up) | Short press for higher brightness, long press to turn up brightness. |
| ▲ (Brightness Up) | Short press for high brightness, long press to turn up brightness. |
| Button 2 | Long press for 5s until you hear "Bi Bi" and release, then the remote controller is cleared successfully. If you need to use, short press any button within 5s after powering on again and you will hear "Bi", which indicates the remote controller is paired successfully. |
| Wi-Fi Pairing Button | Long press for 5s until the connected light enters the breathing mode, which indicates the device enters quick pairing mode (Touch), then you can add the light on eWeLink APP. In quick pairing mode, you can short press any button on the remote controller to exit this mode. |
Factory Reset
To reset the SONOFF D1 to factory defaults:
- Turn the connected light on and off 3 times repeatedly, or delete the light from the eWeLink APP, until the light enters "breathing mode".
- The device is now reset successfully and enters quick pairing mode (Touch).
Note: Please reset the switch to factory defaults if you want to use other Wi-Fi networks, then reconnect the network.
