Retekess TR626 User Manual

Important Safety Information

Thank you for purchasing our products. Please read this manual carefully before using this product. If you encounter any difficulties or problems during use, please contact us for further assistance.

Precautions

• There may be electric shock danger when you don't operate or use this machine correctly; please strictly operate in accordance with its regulations. Except for authorized repairing personnel, never open the back cabinet arbitrarily to avoid the danger of electric shock.
• Please do not expose the unit to rain or humid places, preventing from water and spray. Do not place anything filled with liquid, like a vase, etc., above this unit.
• Please do not press or bend the AC cord of the unit, in case the copper inside the AC cord breaks and leads to an open circuit.
• When a thunderstorm occurs or you do not use this machine for a long time, please pull out the AC plug. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference. (2) And this device must accept any interference received, including interference that may cause undesired operation.
• Please pull out the batteries when not using DC power supply, so as to avoid batteries leaking liquid and corroding the radio.
• Do not use batteries combined with new and old, or different categories. Please dispose of dumped batteries at designated places to avoid environmental pollution.

Specifications

• Frequency Range: FM 76-108 MHz, MW 520-1710 kHz, LW 160-280 kHz, SW 8-18 MHz
• Voltage: AC110V 60Hz or AC220 50Hz, DC 6V (UM-1x4)
• Speaker: 3.5" 8Ω 2W
• Max no-distortion output: 1.2W
• Max consuming power: 6W
• Antenna: MW/LW: inner magnetic rod antenna; FM/SW: Rod antenna
• Dimensions: 240*60*150mm / 9.4*2.4*5.9in
• Weight: About 0.76 kg (Batteries not included)
• Accessories: AC Power cord

Product Diagram and Controls

The Retekess TR626 is a portable 4-band radio with Bluetooth. The front panel features a large speaker grille on the left. The right side has a control panel with the following elements:

• 1. ON/OFF/VOL+/-: Power On/Off and Volume Control knob. Rotating clockwise turns the unit on and increases volume; counter-clockwise turns it off or decreases volume.
• 2. Band selector: Switches between FM, MW, SW, and LW frequency bands.
• 3. FUN selector: Selects the operating mode: BT (Bluetooth) or RADIO.
• 4. Speaker: Integrated speaker for audio output.
• 5. Power indicator: An LED light that indicates the power status. It lights up red when the radio is on and tuned.
• 6. Tuning knob: Used to select radio stations within the selected band.
• 7. Earphone jack: A 3.5mm jack for connecting headphones or earphones for private listening.
• 8. AC power input: Socket for connecting the AC power adapter (supports AC110V and AC220V).
• 9. Antenna: A telescopic rod antenna for FM and SW reception, and an internal magnetic rod antenna for MW and LW reception.
• 10. Handle: A foldable handle for easy portability.
• 11. Battery door: Located on the back, provides access to the battery compartment for four UM-1 batteries.

Operation

Radio Operation

1. Rotate the Volume knob to turn on the unit. Set the FUN selector to RADIO position. The red indicator light will be lit. Adjust the volume by rotating the volume knob.
2. Select the desired band (FM/MW/SW/LW) using the Band selector. Extend the antenna to get a better signal.
3. Rotate the Tuning knob to select a channel. The channel indicator stays red when a channel is properly selected.
4. If you prefer private listening, plug an earphone into the earphone jack.

Note:

• If you experience poor reception, please extend the antenna and change its direction to improve signal strength.
• Please handle the Tuning knob and Band selector gently.

Bluetooth Operation

1. Rotate the Volume knob to turn on the unit. Set the FUN selector to BT position. The blue indicator light in the upper right corner will blink, indicating it is ready to pair.
2. Turn on the Bluetooth feature on your audio device (smartphone, tablet, etc.), search for "TR626", and select it to pair.
3. Once your device is successfully paired, you will hear a short confirmation sound from the unit.
4. Play and stream music from your paired device to the radio.
5. Rotate the Volume knob to turn off the unit.

Note: Bluetooth version: 5.1

RF Energy Exposure and Product Safety Guide

Local Government Regulations

When radios are used as a consequence of employment, Local Government Regulations require users to be fully aware of and able to control their exposure to meet occupational requirements. Exposure awareness can be facilitated by the use of a product label directing users to specific user awareness information. Your Retekess radio has a RF Exposure Product Label. Also, your Retekess user manual, or separate safety booklet includes information and operating instructions required to control your RF exposure and to satisfy compliance requirements.

Unauthorized Modification and Adjustment

Changes or modifications not expressly approved by the party responsible for compliance may void the user's authority granted by the local government radio management departments to operate this radio and should not be made. To comply with the corresponding requirements, transmitter adjustments should be made only by or under the supervision of a person certified as technically qualified to perform transmitter maintenance and repairs in the private land mobile and fixed services as certified by an organization representative of the user of those services. Replacement of any transmitter component (crystal, semiconductor, etc.) not authorized by the local government radio management departments equipment authorization for this radio could violate the rules.

FCC Requirements

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• (1) This device may not cause harmful interference, and
• (2) This device must accept any interference received, including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.

This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.

Compliance and Safety Information

CE Requirements

Henan Eshow Electronic Commerce Co., Ltd declares that the radio equipment type is in compliance with the essential requirements and other relevant provisions of RED Directive 2014/53/EU and the ROHS Directive 2011/65/EU and the WEEE Directive 2012/19/EU. The full text of the EU declaration of conformity is available at the following internet address: www.retekess.com.

Disposal

♻️ The crossed-out wheeled-bin symbol on your product, literature, or packaging reminds you that in the European Union, all electrical and electronic products, batteries, and accumulators (rechargeable batteries) must be taken to designated collection locations at the end of their working life. Do not dispose of these products as unsorted municipal waste. Dispose of them according to the laws in your area.

IC Requirements (Canada)

Licence-exempt radio apparatus. This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:

• (1) This device may not cause interference.
• (2) This device must accept any interference, including interference that may cause undesired operation of the device.

Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de brouillage; (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.

RF Warning Statements

The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

RF Exposure Information

• DO NOT operate the radio without a proper antenna attached, as this may damage the radio and may also cause you to exceed RF exposure limits. A proper antenna is the antenna supplied with this radio by the manufacturer or an antenna specifically authorized by the manufacturer for use with this radio, and the antenna gain shall not exceed the specified gain by the manufacturer declared.
• To avoid interference, turn off the radio in areas where signs are posted to do so.
• DO NOT operate the transmitter in areas that are sensitive to electromagnetic radiation such as hospitals, aircraft, and blasting sites.

Avoid Choking Hazard

? Small Parts. Not for children under 3 years.

Protect Your Hearing

• Use the lowest volume necessary.
• Turn up the volume only if you are in noisy surroundings.
• Turn down the volume before adding headset or earpiece.
• Limit the amount of time you use headsets or earpieces at high volume.

WARNING:

• When using the radio without a headset or earpiece, do not place the radio's speaker directly against your ear.
• Use earphones carefully; excessive sound pressure from earphones and headphones can cause hearing loss.

Note: Exposure to loud noises from any source for extended periods of time may temporarily or permanently affect your hearing. The louder the radio's volume, the less time is required before your hearing could be affected. Hearing damage from loud noise is sometimes undetectable at first and can have a cumulative effect.

Approved Accessories

WARNING:

• This radio meets the RF exposure guidelines when used with the Retekess accessories supplied or designated for the product. Use of other accessories may not ensure compliance with the RF exposure guidelines and may violate regulations.
• For a list of Retekess-approved accessories for your radio model, visit the following website: http://www.Retekess.com

EU Importer

Name: Germany Retevis Technology GmbH

Address: Uetzenacker 29,38176 wendeburg

Guarantee

Please fill in the following details for your warranty:

Model Number: TR626

Serial Number:

Purchasing Date:

Dealer:

Telephone:

User's Name:

Telephone:

Country:

Address:

Post Code:

Email:

Remarks

1. This guarantee card should be kept by the user; no replacement if lost.
2. Most new products carry a two-year manufacturer's warranty from the date of purchase.
3. The user can get warranty and after-sales service as below:
   • Contact the seller where you buy.
   • Products Repaired by Our Local Repair Center
4. For warranty service, you will need to provide a receipt proof of purchase from the actual seller for verification.

Exclusions from Warranty Coverage

1. To any product damaged by accident.
2. In the event of misuse or abuse of the product or as a result of unauthorized alterations or repairs.
3. If the serial number has been altered, defaced, or removed.

Manufacturer and Compliance Information

Manufacturer: Henan Eshow Electronic Commerce Co., Ltd

Address: 7/F, Sanjiang Building, No.170 Nanyang Road, Huiji District, Zhengzhou, Henan, China

Facebook: facebook.com/Retekess.ru

E-mail: support@retekess.com.ru

Web: retekess.com.ru

[CE Mark] [FCC Mark] [RoHS Compliant] [WEEE Symbol] MADE IN CHINA