Laresar L6 Pro Robot Vacuum Cleaner Manual

Language Selection

The following languages are available:

• English (002-033)
• Deutsch (034-065)
• Français (066-097)
• Italia (098-129)
• Español (130-161)
• 日本語 (162-193)

Contents

1. Important Safety Warning
2. Packing List
3. Product Introduction
4. Maintenance
5. Specification
6. Troubleshooting
7. Warranty
8. Disposal

1. Important Safety Warning

ATTENTION: Before using this machine, please read all instructions in the manual and cautionary markings on the machine carefully.

This user's manual includes information for Regulatory Models: Laresar L6 Pro Robot Vacuum Cleaner and Laresar LS-01 Dust Collection Charging Base.

Range of Usage

• This device is for indoor use only. Do not use outdoors or on wet surfaces. A physical barrier should be used to prevent access to the balcony and to ensure safe operation.
• Do not use this device on unfinished, unsealed, waxed, or rough floors. It may result in damage to the floor and this device. Use only on hard floor surfaces or low-pile carpet.
• This device has been designed to be used on floors without scratching them. Test this device on a small area of the room to be cleaned to ensure no scratches are made before cleaning the whole room.
• Do not use this device to pick up spills of bleach, paint, chemicals, or anything wet.
• Do not use this device to pick up anything that is burning or smoking.
• Do not pour any liquids into the device and do not immerse in water.

About the Appliance Use

• This device can be used by children aged 8 years and above and persons with reduced physical, sensory, or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of this device in a safe way and understand the hazards involved.
• Children should be supervised to ensure they do not play with this device. Cleaning and maintenance shall not be performed by children without adult supervision.
• This device is not a toy. Do not sit or stand on this device. Small children and pets should be supervised when this device is operating.
• Before using this device, pick up objects like clothing and loose paper. Lift up cords for blinds or curtains, and move power cords and fragile objects out of the way. If this device passes over a power cord and drags it, an object could be pulled off a table or shelf.

About the Charging Base Use

• Children and pets should be supervised when the charging base is operating.
• Do not sit or stand on this charging base.
• Do not use without dust bag and/or filters in place.
• Do not put any object into openings. Do not use with any opening blocked; keep free of dust, lint, hair, and anything that may reduce air flow. Do not place foreign objects inside and ensure it is clear of debris.
• ⚡ Risk of electric shock, use this charging base in dry location only.
• Do not handle plug or appliance with wet hands.

Notes on Charging

• This device is only to be used with the power supply unit (LS-01) provided.
• The battery must be removed from this device before this device is disposed of.
• This product comes with a region-approved power supply cord and is designed to be plugged into a standard household AC power outlet only.
• Product may not be used with any type of power converter. Use of power converters will immediately void the warranty.
• If you live in an area prone to electrical storms, it is recommended that you use additional surge protection.
• The external flexible cable or cord of the power supply unit cannot be replaced; if the cord is damaged, the power supply unit shall be disposed of.
• If it will not be used for a long time, fully charge the appliance, turn it off, and put it in a cool and dry place. Charge the appliance at least once every 3 months to avoid battery damage due to over discharge.

About Storage and Maintenance

• Store and operate this device in room temperature environments only.
• Do not place the charging base close to heat sources (such as a radiator).
• To reduce the risk of electric shock, unplug your dirt disposal before cleaning or maintaining the product.
• Clean with a cloth dampened with water only.

Correct Disposal of this product

For the purposes of recharging the battery, only use the detachable supply unit provided with this appliance.

This marking indicates that this product should not be disposed of with other household wastes throughout the EU. To prevent possible harm to the environment or human health from uncontrolled waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return your used device, please use the return and collection systems or contact the retailer where the product was purchased. They can take this product for environmentally safe recycling.

FCC Radiation Exposure Statement

This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 20cm between the radiator & your body.

IC Statement

This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions:

• (1) This device may not cause interference.
• (2) This device must accept any interference, including interference that may cause undesired operation of the device.

This equipment complies with IC exposure limits set forth for an uncontrolled environment. This equipment shall be installed and operated with a minimum distance of 20cm between the radiator & body.

2. Packing List

The following items are included in the package:

• L6 Pro Robot Vacuum Cleaner
• Dust Collection Charging Base
• Two-in-one water tank
• Mop Cloth Support
• Mop Cloth *2
• Disposable mop cloth *10
• Dust Bag *5
• Filter Screen *2
• Main brush
• Side Brush *2
• Cleaning Knife
• User Manual

3. Product Introduction

Robot Vacuum Cleaner Components

• Infrared sensor
• Lidar
• Bumper
• Anti-collision strip
• Recharge button/indicator: Short press once to recharge.
• Power button/indicator: Long press for 3 seconds to turn on or off. Short press once to start global cleaning or pause cleaning.
• Infrared sensor

Indicator Reminder

*Indicator status definition:

• Breath: Gradually on and off in 4 seconds.
• Slowly flash: On for 0.7 seconds, off for 0.8 seconds.
• Faster flash: On for 0.1 seconds, off for 0.2 seconds.

Robot Vacuum Cleaner Parts Diagram

1. Mop cloth assembly

2. Main brush cover

3. Main brush

4. Side wheel

5. Side brush

6. Caster

7. Cliff sensor

Charging Base Parts Diagram

1. Charging electrode tip

2. Reset button (Press and hold for 1 second to restart)

3. Dust bin release button

4. Wall-following position sensitive detector

Dust Collection Charging Base Components

1. Upper cover

2. Dust bag chamber

3. Screen

4. Charging and dust collection sensor head

5. Infrared lens

6. Suction inlet

Dust bag status indicators:

• Dust bag is full: The light will be bright.
• Dust bag is not installed correctly: The light will flash.
• During dust collection: The lamp is bright and flashing.
• Full power: Two grids green long light.
• Power ≤ 50%: A grid green long light.

4. Maintenance

4.1 Replace the Dust Bag

When the dust bag is full, the "FULL UP" sign is keeping high brightness, and app notice is given. Please replace the dust bag in time.

The "COLLECTING" sign will be high brightness while the collector is working.

Steps to replace the dust bag:

1. Open the upper cover.
2. Pull up the lifting handle of the dust bag and take out the dust bag.
3. Throw away the used dust.
4. Install a new dust bag.
5. Close the upper cover.

4.2 Clean the Dust Passage

If all signs are twinkling after the dust bag is replaced, it is recommended to pull out the power plug and reverse the dust collection charging base to check whether there are foreign matters blocking the dust passage.

If the dust passage is blocked, remove the transparent cover of the dust passage with a screwdriver to remove foreign matters.

4.3 Clean the Infrared Lens/Charging and Dust Collection Sensor Head

Wipe them gently with a clean, soft, dry cloth. It is recommended to clean them once a month.

4.4 Clean the Filter Screen of the Fan

The filter screen of the fan is below the dust bag. If there is dust accumulation, wipe it gently with a clean, soft, dry cloth. It is recommended to clean them once a month.

4.5 Clean the Main Brush

The main brush is consumable and should be cleaned at least once a week. It is recommended to replace the main brush every 6-12 months to ensure the cleaning effect.

1. Reverse the robot vacuum, press the snap on the main brush cover, and remove the main brush cover and the main brush.
2. Cut off the hair wound on the main brush with the cleaning knife.
3. Replace the main brush and the main brush cover. Press and fasten the snap.

4.6 Clean/Replace the Side Brush

The side brush is consumable. It is recommended to replace it every 3-6 months to ensure the cleaning effect. Remove or install the side brush with a screwdriver.

To remove: Use a screwdriver to detach the side brush.

To install: Align the side brush with the mounting hole and press it firmly.

4.7 Clean the Sensor

It is recommended to use a clean, soft, dry cloth to wipe each sensor gently every week to ensure the normal use of the machine.

Sensors of the Robot Vacuum

• Cliff sensor ×4
• Infrared sensor ×3
• Charging electrode tip ×2
• Wall-following TOF sensitive detector ×1

Sensors of the Charging Base

• Infrared lens ×2
• Charging and dust collection sensor head ×2

Diagram of sensors on the Robot Vacuum:

• Infrared sensor
• Wall-following position sensitive detector
• Cliff sensor
• Infrared sensor

4.8 Battery Maintenance

• The robot vacuum has a built-in high-performance rechargeable lithium-ion battery pack. In order to maintain battery performance, please keep the battery pack charged every day.
• If the machine will not be used for a long time, please turn it off and store properly. Charge it at least every 3 months to avoid battery damage due to over discharge.

4.9 Clean the Two-in-one Water Tank

1. Press and hold the release button of the two-in-one water tank and at the same time pull it outwards.
2. Open the dust bin by pressing the dust bin snap.
3. Remove the debris on the filter screen and screen clip with a cleaning brush.
4. Turn on the tap to clean the dust bin.
5. Open the water tank cover and inject an appropriate amount of water.
6. Please remove the water tank fittings from the machine according to the illustration and reverse it, remove the mop or replace it.
7. (Additional step description for cleaning the water tank, based on diagram)
8. (Additional step description for cleaning the water tank, based on diagram)

Tips:

• It is suggested to use pure water without any cleaning agent.
• If the mop is too dirty, it will affect the effect of mopping, please clean it in time.
• Be sure to remove the mop for cleaning and screw it dry before installation. It is forbidden to clean on the two-in-one water tank.
• The mop is a consumable and it is recommended to replace it every 3-6 weeks.

5. Specification

Robot Vacuum Cleaner Specifications

Dust Collection Charging Base Specifications

6. Troubleshooting

When the machine runs abnormally, the power indicator will blink in orange, and the machine will give a voice prompt when some faults occur. Please refer to the table below for a solution.

Troubleshooting Table 1

Troubleshooting Table 2

7. Warranty

The 1-Year Limited Warranty

• Your Laresar machine has a 1-year warranty against original defects in material and workmanship, when used for private household purposes in accordance with the Laresar Instruction Manual.
• This warranty provides, at no extra cost to you, all labor and parts necessary to ensure your machine is in proper operating condition during the warranty period.

What is Covered?

According to the requirements outlined in this instruction manual, subject to the following conditions and exclusions.

• Only applies to purchases made from authorized retailers of Laresar.
• This warranty will only be valid if the machine is used in the country in which it was sold.

What is Not Covered?

Laresar shall not be liable for costs, damages or repairs incurred as a result of:

• Machines purchased from an unauthorized dealer.
• Careless operation or handling, misuse, abuse and/or lack of maintenance or use not in accordance with the Laresar Instruction Manual.
• The machines are used for commercial or rental purposes in addition to normal domestic use.
• Use of parts not in accordance with the Laresar Instruction Manual.
• Use of parts and accessories other than those produced or recommended by Laresar.
• External factors unrelated to product quality and use, like accidental water damage.
• Repairs or alterations carried out by unauthorized parties or agents.
• Normal wear and tear, including Water Tank, Filter, HEPA, Main Brush, Side Brush and Power Cord (or where external damage or abuse is diagnosed), carpet or floor damage due to use not in accordance with manufacturer's instructions or failure to turn the brush roller off when necessary.
• Reduction in battery discharge time due to battery age or use.

How to Claim?

Please keep your proof of purchase. To make a claim under our Limited Warranty, you need to provide your original purchase receipt with the purchase date and order number on it.

All work will be carried out by Laresar or its authorized agency.

Any replaced defective parts will become the property of Laresar.

Service under this warranty will not extend the period of this warranty.

8. Disposal

This product must not be disposed of as household waste. Dispose of the device at an authorized collection point for the recycling of electrical appliances.

The chemicals contained in the lithium-ion battery of the product will pollute the environment. Please remove the battery before scrapping and send it to a professional battery recycling station for centralized disposal.

Steps for removing the battery

The following information is only applicable to the discarding of the sweeping and mopping robot and not to daily operation.

• Make the robot vacuum run to a low battery level at which the robot cannot perform the cleaning task without contacting the dust collection charging pile.
• Turn off the robot vacuum.
• Remove the side brush and the mop cloth support of the robot.
• Unscrew the bottom cover of the robot cleaner, and remove the bottom cover.
• Pull out the connector plug of the battery, and remove the battery.

Notes:

• To remove the battery, make sure that the battery is exhausted and the product is disconnected from the dust collection charging pile.
• Please remove the battery pack as a whole. Do not damage the battery pack case to avoid short circuit or leakage of hazardous substances.
• If you contact substances leaking from the battery by accident, wash the contact part with plenty of water and see a doctor in time.

Contact Us

If your machine is not functioning properly, or you still have any questions after reading this manual carefully, please feel free to contact us, we will try our best to provide you with a satisfactory solution.

Email to Our Customer Service: support09@laresar.us

Laresar is always here and waiting for you.