Behringer ULTRALINK ULM300USB
High-Performance 2.4 GHz Digital Wireless System with Handheld Microphone and Dual-Mode USB Receiver
Hook-up Diagram
Illustrates connecting the ULM300USB system to a Behringer XENYX QX2442USB mixer, a B115MP3 powered speaker, and a laptop.
Controls
ULM300USB Controls
Product Type: Wireless Microphone
Controls on Microphone/Receiver:
- 1. USB connector: For connecting the wireless receiver to compatible devices or computers.
- 2. POWER/STATUS LED: Indicates the power and connection status.
- 3. VOLUME UP Button: Powers on the device, increases volume, or unmutes. (Long press for power on/unmute, short press for volume up).
- 4. VOLUME DOWN Button: Decreases volume, mutes the microphone, or powers off from mute. (Long press for mute/power off from mute, short press for volume down).
Note: "--" (long dash) indicates a long press; "-" (hyphen) indicates a short press.
LED Status Key
The following table describes the LED behavior on both the microphone and the USB wireless receiver:
| Activity | LED Color | LED Behavior |
|---|---|---|
| No Signal | Amber | Flashes on/off slowly |
| Connected, Active | Green | Solid |
| Connected, Muted | Green | Flashes on/off quickly |
| Connected, Active, Low Battery | Green/Red | Alternating colors |
| Connected, Muted, Low Battery | Green/Red | Alternating colors, flashes on/off |
Getting Started
- Plug the USB wireless receiver into the designated USB socket on wireless-enabled Behringer mixers, powered speakers, or other compatible products, or into a USB port on a computer. The POWER/STATUS LED on the receiver will slowly flash amber.
- Press and hold the VOLUME UP button on the wireless microphone to switch it on and commence transmission. Both the LEDs on the wireless microphone and USB wireless receiver will light solid green once connected.
- Once switched on, the wireless microphone will be set at its previous operating volume level. Use the VOLUME UP and VOLUME DOWN buttons to adjust the volume.
- A long press of the VOLUME DOWN button will put the wireless microphone into mute. The mute condition is indicated by rapid green flashing of the LED. If the user does not unmute within 10 minutes, the wireless microphone will power down to save battery life.
- A further long press of the VOLUME DOWN button when in mute will switch off the wireless microphone.
- A short press of the VOLUME UP button will unmute the wireless microphone. When the wireless microphone is unmuted, it will return to the previous volume level.
Note: The connection range between speaker and Bluetooth streaming device may decrease if Bluetooth streaming and wireless microphones are used simultaneously.
Technical Specifications
| Specification | Value |
|---|---|
| RF output | < 10 dBm (10 mW) |
| Operating range | 60 m (200 ft)* |
| Dynamic range | 93 dB, A-weighted** |
| Equivalent input noise | -120 dBu |
| Frequency response (wireless link) | 10 Hz – 20 kHz, ±1 dB** |
| Sampling rate | 48 kHz |
| Resolution | 24-bit |
| Encoding | 4-bit ADPCM (192 kbps) |
| Latency | 14.3 ms |
| RF frequency | 2.4 GHz ISM band (2.404~2.468 GHz, 17 channels) |
| USB current consumption | 70 mA @ 5 VDC |
| Battery type | 2 x AA (LR6) Alkaline cells |
| Battery life | > 24 hrs |
| Dimensions (H x W x D) - Microphone | 260 x 53 x 53 mm (10.2 x 2.1 x 2.1") |
| Dimensions (H x W x D) - Wireless receiver | 8.5 x 76 x 22 mm (0.3 x 3.0 x 0.9") |
| Weight - Microphone | 0.3 kg (0.7 lbs) |
| Weight - Wireless receiver | 0.01 kg (0.02 lbs) |
*Achievable range will be dependent on nearby sources of RF interference and/or line of sight obstacles.
**Measured from analog input to analog output at maximum level.
FCC Compliance Information
Responsible Party Name: Music Tribe Commercial NV Inc.
Address: 122 E. 42nd St.1, 8th Floor NY, NY 10168, United States
Email Address: legal@musictribe.com
FCC ID: QWHULM300M
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Important Information: Changes or modifications to the equipment not expressly approved by Music Tribe can void the user's authority to use the equipment. This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled environment.
Legal Disclaimer
Music Tribe accepts no liability for any loss which may be suffered by any person who relies either wholly or in part upon any description, photograph, or statement contained herein. Technical specifications, appearances and other information are subject to change without notice. All trademarks are the property of their respective owners. Midas, Klark Teknik, Lab Gruppen, Lake, Tannoy, Turbosound, TC Electronic, TC Helicon, Behringer, Bugera, Aston Microphones and Coolaudio are trademarks or registered trademarks of Music Tribe Global Brands Ltd. © Music Tribe Global Brands Ltd. 2021 All rights reserved.
Limited Warranty
For the applicable warranty terms and conditions and additional information regarding Music Tribe's Limited Warranty, please see complete details online at community.musictribe.com/pages/support#warranty.
Safety and Battery Information
Warning:
- As with all small batteries, the batteries used with this product should be kept away from small children who still put things in their mouths. If they are swallowed, promptly call your local poison control center.
- Always purchase the correct size and grade of battery most suitable for intended use.
- Replace all batteries of a set at the same time.
- Clean the battery contacts and also those of the device prior to battery installation.
- Ensure the batteries are installed correctly with regard to polarity (+ and -).
- Always remove battery if consumed or if product is to be left unused for a long time.
- Replacement of a battery with an incorrect type that can defeat a safeguard! Replace only with the same or equivalent type!
- Risk of fire or explosion if the battery is replaced by an incorrect type.
- Disposal of a battery into fire or a hot oven, or mechanically crushing or cutting of a battery, that can result in an explosion;
- Leaving a battery in an extremely high temperature surrounding environment that can result in an explosion or the leakage of flammable liquid or gas; and
- A battery subjected to extremely low air pressure that may result in an explosion or the leakage of flammable liquid or gas
- Attention should be drawn to the environmental aspects of battery disposal.
EU Declaration of Conformity
Hereby, Music Tribe declares that this product is in compliance with Directive 2014/53/EU, Directive 2014/30/EU, Directive 2014/35/EU, Directive 2011/65/EU and Amendment 2015/863/EU, Directive 2012/19/EU, Regulation 519/2012 REACH SVHC and Directive 1907/2006/EC.
Full text of EU DoC is available at https://community.musictribe.com/
EU Representative: Music Tribe Brands DK A/S, Address: Gammel Strand 44, DK-1202 København K, Denmark
UK Representative: Music Tribe Brands UK Ltd., Address: 6 Lloyds Avenue, Unit 4CL London EC3N 3AX, United Kingdom
