Introduction and Safety Notices
This guide details the installation, calibration, and operation of the Mercury DTS Dual Console Remote Control with CAN Trackpad (Model 877775A). It is essential that installation and service are performed by authorized Mercury Marine technicians to ensure product safety and prevent damage. The document stresses the necessity of electronic calibration before use.
Kit Components
The kit includes the main Electronic Remote Control (ERC), cover with gasket, lanyard switch kit, various screws (M4 x 20, M6 x 40), washers, nuts, and Allen wrenches.
Installation Procedures
Key installation steps include:
- Determining and adhering to required mounting clearances.
- Locating and preparing the mounting area, including drilling according to the template.
- Routing wiring and connecting harnesses securely.
- Fastening the control unit with provided screws.
- Adjusting control handle and detent tension screws for desired feel.
Features and Operation
The remote control offers:
- Intuitive throttle and shift control via the handle movement.
- Trim switch functionality (if equipped).
- Neutral indicator lights.
- Special functions activated by buttons such as TROLL, TRANSFER, DOCK, THROTTLE ONLY, 1 LEVER mode, and SYNC (auto synchronization).
Calibration and Configuration
Proper system calibration is crucial. This involves:
- Using a Computer Diagnostic System (CDS) for DTS system calibration.
- Configuring the DTS vessel settings to define module locations.
- Performing DTS handle adaptation for each control.
- Calibrating the CAN Trackpad to ensure correct system communication and functionality.
Technical Diagrams
The document includes a detailed wiring diagram illustrating component connections and a cut-out template with precise dimensions for console mounting.
Manufacturer Information
Products are from Mercury Marine, a division of Brunswick Corporation.
