EVEO Dual Monitor Mount

Required before installation

It is important to paste anti-slippery protective pads to prevent accidental damage to your belongings.

Peel the anti-slippery protective pads off and stick them on the base. Ensure the pads are correctly positioned before proceeding.

1. Setup the base

[warning] Make sure you pasted the anti-slippery protective pads before.

For thicker tables, use the bottom 2 holes for mounting.

Clamp the base securely onto the table and fix it in place.

2. Arms and Monitors

Ensure the slider faces upwards.

Choose the appropriate screws (e.g., M4 or M5) that fit your monitor's VESA mounting holes.

Attach the VESA plates to your monitors. This step is required for two monitors.

Place the lower arms and the upper arms onto the mount. This step is required for two arms.

Attach the monitor to the arm. Turn the lock to secure the monitor. Handle with care and ensure the lever is locked.

3. Adjustments

Adjust the arm tension by turning the screw. Increase tension if the monitor drops, and decrease tension if it rises unintentionally.

If necessary, tighten the screw to lock the arm's rotation.

Lift the arm before sliding it to adjust its position.

Attach the cable management clips and route your cables neatly.

Grommet Installation (Optional)

Use the provided drilling template to mark the desired hole location on your desk.

Drill a hole using a drill bit of at least 15mm (or 5/8 inch) diameter.

Disassemble the base, keeping the screws. Pass the base through the drilled hole. Reassemble and tighten the nut to secure the base.

Fix the base through the hole and secure it. Then, proceed with step '2. Arms & Monitors' for attaching the arms and monitors.