Yaber JS-20 Jump Starter User Manual
Introduction
This manual provides instructions for the Yaber JS-20 portable car jump starter. It covers setup, operation, charging, and safety precautions.
Product Overview
The Yaber JS-20 is a portable device designed to jump-start car batteries and function as a power bank.
Key Features
- Jump-starting capability for vehicles
- LED flashlight with SOS and strobe modes
- Portable power bank for charging devices
Getting Started
Charging the Device
Before first use, charge the Yaber JS-20 for at least 7 hours or until all four indicator lights are illuminated. This ensures the device is fully powered.
Jump Starting Port
Locate the jump starting port on the device. Insert the clamp cable plug securely into this port when preparing to jump-start a vehicle.
How to Jump Start a Car
- Connect the clamps: Attach the red clamp to the positive (+) terminal of the car battery and the black clamp to the negative (-) terminal.
- Start the car: Attempt to start the vehicle's engine.
- Disconnect the clamps: Once the engine starts, disconnect the black clamp first, then the red clamp.
Force Starter Button
If the car battery voltage is too low, the device may not initiate the jump start. In such cases, press and hold the 'Force Starter' button for a few seconds to enable the jump-start function. The indicator light should turn solid green.
LED Light Functionality
Press and hold the ON/OFF button for 3 seconds to turn the LED light on or off. While the light is on, short presses of the button will cycle through different modes: SOS, strobe, and steady illumination.
Important Notes
- Ensure correct polarity when connecting clamps to the battery terminals.
- Do not attempt to jump-start if the battery is damaged or leaking.
- Keep the device away from extreme temperatures and moisture.
- Refer to the specific language sections for detailed instructions in German, French, Italian, and Spanish.
Support
For assistance, please contact support@yaberauto.com.
