Metz Consumer Electronics GmbH
Ohmstrasse 55 - 90513 Zirndorf
Tel. (0911) 9706-0 - info@metz-ce.de
Disassembly Instructions
Metz 43MQF7500Z
Necessary Tools
Screw driver PH2
Important Safety Precaution
⚠️ Pull out the mains plug before removing the rear panel.
1 Disassembly of the Rear Panel
a) Remove screws with a PH2 screw driver.
b) Lift the rear panel slightly, press the cable clamps and pull off the cable.
Diagram: Rear Panel Screw Locations
The rear of the Metz 43MQF7500Z television is shown. Six screws, each marked 'PH2', are positioned around the edges of the rear panel. Two additional screws, also marked 'PH2', are located near the center, securing a connector bracket. An arrow indicates the mains plug socket, emphasizing the need to disconnect power before proceeding.
2 Disassembly of the Printed Circuit Boards
⚠️ Elkos may contain residual charges.
Remove screws with a PH2 screw driver.
Diagram: Printed Circuit Board Screw Locations
The main printed circuit board is displayed. Three screws, marked 'PH2', are highlighted in yellow, indicating their positions for removal to detach the board.
