METZ MTC61*Series LED TV

PREPARATION

Unpacking and Installation

Follow these steps for unpacking and initial installation:

1. Open the package.
2. Take out the TV.
3. Install the TV stands.
4. Connect the power cord.

Note: The pictures are only for reference.

Standard Accessories

Note: The pictures are only for reference.

• Batteries/2
• Remote Control
• Power Cord
• Warranty Card
• Base Installation Manual
• Quick Start Guide
• Screws: 32": Screws/2, 40": Screws/4, 43": Screws/4
• Base Stands/2
• AV inverter cable

A Bluetooth voice remote control is not included and may need to be purchased separately. The "Android TV" APP can be downloaded from a mobile device for voice control functionality.

WARNING AND PRECAUTION

Important Safety Instructions

• Read all instructions before operating the set. Keep these instructions for future reference.
• Heed all warnings on the appliance and in the operating instructions.
• Follow all operating and use instructions.
• Do not use the apparatus near water or moisture, such as in wet basements or near swimming pools.
• Clean only with a dry cloth.
• Do not block ventilation openings. Install according to manufacturer's instructions.
• Do not install near heat sources like direct sunlight, radiators, heat registers, stoves, or other heat-producing apparatus.
• Do not defeat the safety purpose of polarized or grounding plugs. Consult an electrician for outlet replacement if the plug does not fit.
• Protect the power cord from being walked on or pinched, especially at plugs and points where they exit the apparatus.
• Only use attachments/accessories specified by the manufacturer.
• Use only with the cart, stand, tripod, bracket, or table specified by the manufacturer or sold with the apparatus. Use caution when moving carts/apparatus combinations to avoid tip-over injuries.
• Unplug the apparatus during lightning storms or when unused for long periods.
• Refer all servicing to qualified personnel. Servicing is required if the apparatus is damaged (e.g., power cord, liquid spill, dropped, exposed to rain/moisture, not operating normally).
• CAUTION: Servicing instructions are for qualified personnel only. Do not perform servicing beyond operating instructions to avoid electric shock risk.
• Do not install in confined spaces (e.g., bookcase) without adequate ventilation. Do not impede ventilation with items like newspapers or curtains.
• Refer to rear enclosure for electrical and safety information before installation or operation.
• Do not expose the apparatus to rain or moisture. Do not place liquid-filled objects on the apparatus. Do not use near dust.

Battery Safety

• Terminals marked with a ⚡️ symbol may pose an electric shock risk. External wiring requires an instructed person or ready-made leads.
• To prevent injury, securely attach the apparatus to a table/wall using the stand/wall-mount bracket.
• Danger of explosion if batteries are replaced incorrectly. Use only the same or equivalent type.
• Batteries shall not be exposed to excessive heat (sunshine, fire, etc.).
• Excessive sound pressure from earphones/headphones can cause hearing loss. Listen at safe volume levels and for limited durations.
• The appliance coupler is the disconnect device and shall remain readily operable.
• When not in use or moving, tie up the power cord set. Ensure it is free from sharp edges. Check for damage before reuse; contact service for replacement if damaged.
• Pay attention to environmental aspects of battery disposal.
• Keep naked flame sources (e.g., lighted candles) away from the apparatus.
• If the apparatus has the ⎚ symbol and a two-pin power cord, it is Class II (double insulated) and does not require an earth connection.
• WARNING: For apparatus containing coin/button cell batteries: Do not ingest. Chemical Burn Hazard. Swallowing can cause severe internal burns in 2 hours and lead to death. Keep new and used batteries away from children. Stop use if the battery compartment does not close securely. Seek immediate medical attention if batteries are swallowed or placed inside the body.

CAUTION: RISK OF ELECTRIC SHOCK. DO NOT OPEN.

ATTENTION: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR.

The lightning flash with arrowhead symbol [⚡️] alerts users to non-insulated "dangerous voltage" inside the enclosure.

To reduce electric shock risk, do not remove covers. No user-serviceable parts inside. Refer to qualified service personnel.

The exclamation point symbol [❗] alerts users to important operating and maintenance instructions.

Symbols:

• ∿ Refer to alternating current (AC).
• ⎓ Refer to direct current (DC).
• ⎚ Refer to Class II equipment.
• ⏽ Refer to stand-by.
• ⏻ Refer to power ON.
• ⚡️ Refer to dangerous voltage.

WEEE Directive

Correct Disposal: This marking indicates that the product should not be disposed of with household waste throughout the EU. Recycle responsibly to promote sustainable reuse of material resources. Use return and collection systems or contact the retailer for environmental safe recycling.

Positioning the TV

• Install the display on a solid horizontal surface (table or desk).
• For ventilation, leave at least 10cm space around the set. Do not place objects on top of the set.
• The apparatus can be used in tropical and/or moderate climates.
• Fix the rear of the enclosure to the wall (in some countries).

Warning: Stability Hazard

A falling television can cause serious personal injury or death. Take simple precautions:

• ALWAYS use cabinets or stands or mounting methods recommended by the manufacturer.
• ALWAYS use furniture that can safely support the television.
• ALWAYS ensure the TV is not overhanging the edge of the supporting furniture.
• ALWAYS educate children about the dangers of climbing furniture for TV controls.
• ALWAYS route cords and cables so they cannot be tripped over, pulled, or grabbed.
• NEVER place the TV in an unstable location.
• NEVER place the TV on tall furniture without anchoring both the furniture and the TV to a suitable support.
• NEVER place the TV on cloth or other materials between the TV and supporting furniture.
• NEVER place items that might tempt children to climb (e.g., toys, remote controls) on top of the TV or furniture.
• If relocating an existing TV, apply the same considerations.

Mounting on a Wall

• An optional wall mount can be used. Consult your local dealer for the recommended bracket.
• Attach the wall mount bracket securely to the rear of the TV.
• Install the bracket on a solid wall perpendicular to the floor.
• For other building materials, contact qualified personnel for installation.
• Ensure the device is adequately secured to the wall with enough space for external device connectivity.

Disconnect power before moving or installing the TV to prevent electric shock.

Remove the stand before wall mounting by reversing the stand attachment process.

Installing on a ceiling or slanted wall may cause the TV to fall, resulting in severe injury. Use an authorized wall mount and contact a local dealer or qualified personnel; otherwise, the warranty may be void.

Do not overtighten screws, as this may damage the TV and void the warranty.

Wall Mount Screw Specifications

Use screws and wall mounts meeting the following specifications. Damages from misuse or improper accessories are not covered by the warranty.

Note: 1. The pictures are only for reference. 2. For TVs with terminals towards the wall, a rubber cushion (8mm inner diameter, 18mm outer diameter, ≥30mm height) is needed with each screw to provide sufficient space for terminal use.

Precautions For Using Remote Control

• Point the remote control towards the remote sensor. Items between the remote and sensor can interfere with operation.
• Do not vibrate the remote control violently. Do not splash liquid on it. Do not place it in high humidity.
• Do not place the remote control under direct sunlight, as heat can cause deformation.
• If the remote sensor is under direct sunlight or strong lighting, the remote control may not work. Change lighting, TV position, or move the remote closer to the sensor.

Precautions For Using Battery

Improper battery use can cause leakage. Follow these methods:

• Note battery polarity to avoid short circuits.
• Replace batteries when voltage is insufficient. Remove batteries if not using the unit for a long time.
• Do not mix battery types (e.g., Manganese and Alkaline).
• Do not put batteries in fire or attempt to decompose them.
• Dispose of batteries according to environmental regulations.
• WARNING: Batteries shall not be exposed to excessive heat (sunshine, fire, etc.).
• For Bluetooth pairing, ensure external Bluetooth devices are in pairing mode. For the supplied Bluetooth remote, press and HOME buttons together. For other devices, consult their manuals.

BASIC OPERATION

E-Manual

The E-Manual is built into your TV and can be displayed on screen. To learn more about TV features, access it via the following steps:

1. Press the HOME button to access the home page.
2. Press the directional buttons (Up/Down/Left/Right) and OK button to select "E-Manual" in "Apps".

Note: The pictures are only for reference.

1) Remote Control: To check detailed remote control functions, select and enter the icon.

2) How to use E-Manual: Select and enter the "?" icon for guidance on checking the E-Manual and understanding its icons/contents.

Install Remote Control Batteries

Place two AAA size batteries in the remote control's battery compartment, ensuring correct polarity alignment.

Note: The picture is only for reference.

TV Control Button

The TV Control Button allows basic operation:

• In standby mode, press it to turn on the TV.
• In working status, press it to turn the TV to standby mode.

Note: The picture is only for reference.

TROUBLE SHOOTING

Before contacting a service technician, check this table for possible causes and solutions:

General Problem / Solution

• Remote control does not work: Check remote sensor, change batteries, ensure batteries are installed correctly, verify main power connection.
• Poor Signal: Usually caused by interference from cell phones, walkie-talkies, automotive ignition systems, neon lights, electric drills, or radio interference sources.

Picture & Sound / Solution

• No picture, no sound: Check signal source. Plug another device into the outlet to test it. Check power plug connection. Check signal.
• No sound, picture OK: Ensure mute is off and volume is up. Open sound menu and adjust 'Balance'. Check if a headphone is inserted and remove it.
• Abnormal picture: For no color or poor quality, adjust color settings, keep TV away from other electronic products, or try another channel.
• Bad TV signal (Display mosaic or snowflakes): Check signal cable and adjust antenna. Fine-tune the channel. Try another channel.

Multimedia Player / Solution

• 'This file is invalid' or audio normal but video abnormal: Media file may be damaged. Check if it plays on a PC. Verify video and audio codec support.
• 'Unsupported audio' or video normal but audio abnormal: Media file may be damaged. Check if it plays on a PC. Verify video and audio codec support.

Network / Solution (May not be available)

• Network failure: Check router functionality. If using a USB dongle, ensure it's inserted. Confirm TV is connected to the router.

Browser / Solution (May not be available)

• Web page cannot be displayed completely: Flash may not be supported.
• Browser is forced to be shut down: Web pages with too many large pictures can lead to insufficient memory.

SPECIFICATION

• Working voltage: 100-240V~50/60 Hz
• Dimensions without stand (W x H x D): 32": 718.2 x 426 x 85.2mm; 40": 892.4 x 512.8 x 87.9mm; 43": 954.5 x 558.3 x 88.2mm
• Net weight without stand: 32": 3.5 kg; 40": 5.1 kg; 43": 5.9 kg
• RF aerial input: 75 ohm unbalanced
• Language of OSD: Multiple options
• System: DTV: DVB-T/T2/S/S2/C; ATV: PAL/SECAM BG/DK/I
• Channel coverage: DVB-S/S2: [KU] 950MHz ~ 2150MHz, [C] 5150MHz~5750MHz; DVB-T/T2: 174MHz ~ 230MHz, 470MHz~860MHz; DVB-C: 50MHz~858MHz; ATV: 47.25MHz~865.25MHz
• Environment (only for Tropical climates zone): Working temperature: 5°C~40°C; Working humidity: 20%~80%; Storage temperature: -15°C~50°C; Storage humidity: 10%~90%
• Environment (only for Moderate climates zone): Working temperature: 5°C~40°C; Working humidity: 20%~80%; Storage temperature: -15°C~45°C; Storage humidity: 10%~90%

Radio Module Specifications

Wireless Network (WLAN)

Bluetooth

Remark:

• 1) There are no restrictions of use.
• 2) The device should be positioned or operated at least 20cm away from the user.

LICENSE

Notes:

• Some specifications may vary by region or model. Use your actual TV set as the standard.
• Metz Consumer Electronics GmbH declares that the radio equipment type [MTC61*Series] complies with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at: www.metzblue.com.

Third-Party Licenses

• Android TV, Google Play, Chromecast, and YouTube are trademarks of Google LLC.
• HDMI and HDMI High-Definition Multimedia Interface, and the HDMI Logo are trademarks or registered trademarks of HDMI Licensing Administrator, Inc. in the United States and other countries.
• Manufactured under license from Dolby Laboratories. Dolby, Dolby Audio, and the double-D symbol are trademarks of Dolby Laboratories Licensing Corporation.

Notes:

• The information in this document is subject to change without notice. The manufacturer accepts no liability for damage resulting from faults, incompleteness, or discrepancies between the manual and the product.
• In dry environments, static electricity may cause the product to restart to the main OSD interface, USB player, or previous source mode. This is normal; continue operating the TV.