TINAD
METOD
Safety Information
WARNING! Before proceeding with installation, please read the safety information in the User Manual. For installation, please follow all steps in Assembly Instruction. Do not use an extension cable or circuit multi-plug when connecting to electricity.
(Safety information also provided in Hebrew and Arabic.)
Parts and Tools
Parts Included:
- Part A (8x) ?
- Part B (17x) ?
- Part C (2x) ?
- Part D (8x) ⚓ (Wall Anchor)
- Part E (1x) Drawer Slide (Left)
- Part F (2x) Door Hinge
- Part G (4x) Mounting Bracket
- Part H (1x) Ice Scraper
- Part I (1x) Drawer Runner (Left)
- Part J (1x) Drawer Runner (Right)
- Part K (4x) Drawer Slide Component
- Part M (2x) Drawer Front Connector
Tools Required:
- Screwdriver ?
- Hammer ?
- Pencil ✏️
- Gloves ?
- Scissors ✂️
- Measuring Tape ?
Technical Specifications and Dimensions
- Unit Height: 2350 mm (or 1850 mm, 1050 mm for specific configurations)
- Unit Widths: 545 mm, 540 mm
- Unit Depth: 630 mm
- Clearance Requirements: Minimum 2 mm gap on sides and top for ventilation; 0 mm gap allowed on the back if ventilation is sufficient. Minimum 200 cm² ventilation area required for the back of the appliance.
- Mounting Bracket Distance: 85 mm from edge.
- Appliance Height Options: 220 cm, 200 cm, 240 cm.
Assembly Instructions
- Open the cabinet doors.
- Remove the cabinet doors by unscrewing the hinges from the doors.
- Detach the hinge plates from the cabinet body by unscrewing them.
- Repeat step 3 for all hinge plates.
- Note: Keep all removed screws (?).
- Attach mounting brackets (G) to the cabinet sides using screws (B) and wall anchors (D). Ensure correct orientation. (Requires 8x screws B, 8x anchors D, 4x brackets G).
- Attach the lower support bracket to the bottom of the cabinet.
- Install drawer runners (I and J) onto the inside of the cabinet sides using screws (B).
- Install drawer slides (E) onto the inside of the cabinet sides using screws (B).
- Mount the cabinet to the wall. Use screws (part 3, 2) and anchors (part 0, E). Ensure the cabinet is level and securely fastened, maintaining a distance of 85 mm from the edge where applicable. (Diagrams show different configurations for 200 cm, 220 cm, and 240 cm height cabinets).
- Attach hinges (F) to the cabinet doors. Specific hinge parts (e.g., 43, 30, 17, 15 or 39, 28, 17, 15) are indicated for different door configurations.
- Attach the doors to the mounted cabinet by connecting the hinges to the corresponding mounting plates.
- Adjust the doors using the hinge screws to achieve proper alignment and ensure they close correctly. A 2 mm gap is indicated for adjustment.
- Install the ice scraper (H) into its designated slot within the cabinet.
- Attach the base support feet to the bottom of the cabinet using screws (B).
- Prepare drawer components: Attach drawer runners (H) and connectors (B, M) to the drawer box components.
- Install drawer slides (E) onto the drawer box components and secure them with screws (C).
- Attach drawer slides (K) to the cabinet doors.
- Align and attach drawer slides (K) to the cabinet doors, making 1 mm adjustments as needed for precise fitting.
- Insert the drawer runners (J) into the cabinet, completing the drawer assembly.
