Leuchten Direkt 992866 LED Ceiling Light
This document provides installation instructions and technical specifications for the Leuchten Direkt 992866 LED ceiling light.
Product Specifications
LED Module 1
Type: LED
Power: 2.8 W
Lumen Output: 270 lm
Equivalent Wattage: 7.5 W
Equivalent Lumen: 420 lm
Lifespan: 20,000 h
Color Temperature: 3,000 K
Switching Cycles: 15,000 x
Switching Time: <0.5 s
LED Module 2
Type: LED
Power: 3.1 W
Lumen Output: 300 lm
Equivalent Wattage: 7.5 W
Equivalent Lumen: 420 lm
Lifespan: 20,000 h
Color Temperature: 3,000 K
Switching Cycles: 15,000 x
Switching Time: <0.5 s
General Information
Model Number: 992866
Voltage: 230V / 50Hz~
Included LED Boards: 1x LED-Board 209V DC/2.8W, 1x LED-Board 209V DC/3.1W
Installation Instructions
Follow these steps for safe and correct installation:
- Step 1: Mounting Bracket Attach the provided mounting bracket to the ceiling using appropriate screws and anchors. Ensure the bracket is securely fastened.
- Step 2: Wire Connections Connect the mains supply wires to the terminal block inside the fixture. The terminals are typically labeled for Live (L), Neutral (N), and Earth (ground). Based on the diagram, connect Live to terminal 'c', Neutral to terminal 'b', and Earth to terminal 'a'.
- Step 3: Attach Fixture Secure the main light fixture onto the mounted bracket.
- Step 4: Internal Connections Make the final electrical connections between the mains supply and the LED boards within the fixture.
- Step 5: Final Check Ensure all electrical connections are secure and the fixture is properly and safely mounted to the ceiling.
Diagram Notes:
- A measurement of 6mm is indicated, likely for spacing or mounting clearance.
- The installation involves connecting electrical wires and securing components with screws.
Important Safety Disclaimer
The light source of this luminaire is integrated and should only be replaced by the manufacturer, a service technician commissioned by the manufacturer, or a person with comparable qualifications. Attempting to replace the light source yourself may lead to damage or safety hazards.
