Sealey - Leading Professional Tool & Workshop Equipment Supplier
Instruction Manual for SEALEY models including: CST980.V2, CST980.V2 Folding Sack Truck, Folding Sack Truck, Sack Truck, Truck
File Info : application/pdf, 2 Pages, 176.68KB
DocumentDocument90KG FOLDING SACK TRUCK MODEL NO: CST980.V2 Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions, and properly maintained, give you years of trouble free performance. IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. Refer to instruction manual 1. SAFETY fig.1 9 Always load evenly with the centre of gravity of the load as near the centre of the truck as possible. 9 Obtain additional support for large or wide loads to prevent tipping. 8 DO NOT overload the truck - see Specifications. 8 DO NOT leave unattended, especially when loaded, unless the wheels are chocked or the truck is otherwise secured. 8 DO NOT use truck on uneven ground and do not run over curbs or steps - use a ramp. 8 DO NOT allow others to ride on the truck. 8 DO NOT use the truck if any part is significantly damaged - pay particular attention to the wheels. 2. INTRODUCTION Lightweight aluminium frame, weighs only 7kg yet has a carrying capacity of 90kg. Folding steel foot plate and telescopic handle with spring release means that trolley can be packed away in seconds. Large back support makes light work of oversized loads. Fitted with Ø150mm wheels for easy-rolling over rough ground. Ideal for business and home use. 3. SPECIFICATION Model no ..............................................................CST980.V2 Height(s) ........................................................... 710-1080mm Overall width .............................................................. 395mm Platform depth............................................................ 240mm Wheel depth............................................................ Ø150mm 4. INTRODUCTION Lightweight aluminium frame, weighs only 7kg yet has a carrying capacity of 90kg. Folding steel foot plate and telescopic handle with spring release means that trolley can be packed away in seconds. Large back support makes light work of oversized loads. Fitted with Ø150mm wheels for easy-rolling over rough ground. Ideal for business and home use. 5. ASSEMBLY 5.1. Make sure the axle is clean from dust and dirt to allow free movement of the wheel. 5.2. Place the sleeve (fig.1.2) onto the axle (fig.1.1), as far as it will go. 5.3. Slide the wheel (fig.1.3) onto the axle, and complete by pushing the pin (fig.1.4) through the hole in the end of the axle. 5.4. Repeat the operation for the other side. 6. OPERATION 6.1. Firstly fold down the foot plate ready to accept a load (fig.2). 6.2. To extend the handle push the spring loaded locking bar forward (fig.2A) and lift the handle upwards until it latches in its fully extended position. 6.3. To lower the handle, push the spring loaded locking bar forward and push the handle downwards until it latches in the closed position. 6.4. After use close the handle, fold up the foot plate and store in a safe dry place. 6.5. Only use truck with handle fully closed or fully extended. fig.2 © Jack Sealey Limited Original Language Version CST980.V2 Issue:2 (HF) 21/01/21 ENVIRONMENT PROTECTION Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids according to local regulations. Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice. Please note that other versions of this product are available. If you require documentation for alternative versions, please email or call our technical team on technical@sealey.co.uk or 01284 757505. Important: No Liability is accepted for incorrect use of this product. Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim. Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR 01284 757500 01284 703534 sales@sealey.co.uk www.sealey.co.uk © Jack Sealey Limited Original Language Version CST980.V2 Issue:2 (HF) 21/01/21