Toshiba Electric Kettle

Safety Guide

Please follow all the safety precautions listed below for safety and to reduce the risk of injury or electrical shock.

• Do not touch the body of the kettle when it is hot. Always hold the appliance by the handle when using it.
• Always ensure the lid is closed when in use. Failure to close the lid will prevent the thermostat from switching off and cause the kettle to boil dry.
• Keep the appliance well away from hot surfaces, and objects that can be damaged by heat.
• Ensure there is at least 20 cm space left to operate the kettle and that steam can escape safely. Never use the kettle under a cupboard or shelf where the steam may damage the surface.
• Avoid contact with the steam from the spout when the water is boiling or just after it has switched off.
• Be careful when opening the lid for re-filling when the kettle is hot.
• Ensure that the kettle cannot fall into water.
• Do not fill or pour water from the kettle while it is on the base.
• Disconnect the kettle at the mains supply before filling or emptying the jug, before cleaning any of its components, and when it is not in use.
• Do not immerse the connecting cord in water or other liquids.
• Do not allow liquids to come into contact with the body connector of the kettle, its base or the connecting cord.
• Do not let the connecting cord overhang the edge of the work surface or allow it to touch hot surfaces or sources of heat or flame.
• If any part of this appliance is damaged or malfunctions in any way, or the connecting cord or mains plug is broken, do not continue to use it. Seek expert assistance.
• This appliance can only be used by children aged from 8 years and above and persons with reduced physical sensory or mental capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the appliance in a safe way and understand the hazards involved. Children shall not play with the appliance. Cleaning and user maintenance shall not be made by children unless they are older than 8 and supervised.
• Keep the appliance and its cord out of reach of children less than 8 years.

WARNING: Some accessible surfaces may be hot during operation of this appliance.

CAUTIONS

• Do not place the power base unit on a metal tray or metal surface when plugged into any power source.
• This appliance is for indoor domestic use only. Do not use it outdoors.
• This kettle jug and power base form an integral appliance. Do not use other kettle jugs with this power base, or this kettle jug with other bases.
• The switch on this appliance must be readily operable at all times. Do not hinder its operation by incorrect placement or by placing obstacles that may restrict its free movement.
• This appliance is intended to be used in household and similar applications such as: Staff kitchen areas in shops, office and other working environments; farm houses; by clients in hotels, motels and other residential type environments; In bed and breakfast type environments.
• If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order to avoid a hazard.
• If the kettle is overfilled, boiling water may be ejected.

Warning: Misuse may cause potential injury.

About Your Kettle

The Toshiba Electric Kettle (Model: KT-17DRRS) consists of the following parts:

• Lid: Located at the top, it covers the kettle opening.
• Spout: For pouring water.
• Filter: Situated inside the lid, it helps to strain impurities.
• Lid release button: Used to open the lid.
• Handle: For holding and carrying the kettle.
• Body: The main container of the kettle.
• Body connector: Located at the bottom of the kettle, it connects to the power base.
• Power cord: Connects the kettle to the power supply.
• Power plug: The plug that connects to the wall socket. (Note: The shape of the plug may differ from the illustration.)
• Power switch: Located below the handle, used to turn the kettle on/off.
• Power indicator: Illuminates when the kettle is in operation.
• Power base connector: The part on the power base where the kettle sits.
• Power base (Stand): The base unit that powers the kettle.

Using Your Kettle

Preliminaries

Unpack your kettle and any accessories carefully. Retain the packaging so that you can transport the appliance safely. If you dispose of it, please do so with regard to any recycling regulations in your area.

Before using your kettle: Check that the voltage marked on the rating plate under the kettle or the base matches your mains voltage. Please read all the instructions in this User Guide with particular reference to the safety notes.

Operation

1. Separate the kettle from the base. Ensure that the mains socket is switched off at the wall.

2. Lead the power cord out through the recess in the base. Place the kettle base on a stable level surface and connect the power cord to the wall socket. Excess cord may be safely stowed by feeding it carefully into the stowage compartment in the base. Ensure the power cable exits the cut-out slot; otherwise, the kettle base will not be stable.

3. Pour away previously boiled water.

4. Push the lid release button to lift up the lid.

5. Fill the kettle with fresh water. The MIN and MAX marks are located on the water scale. The water level must always cover the MIN (0.5 litres) mark. Do NOT fill the kettle above the MAX mark (1.7 litres), or boiling water may be ejected.

6. Close the lid. Place the filled kettle correctly on the power base.

Boiling the Kettle

1. Switch on the power at the wall socket.

2. The kettle ON/OFF switch is located below the handle. Press the switch down to switch the kettle on. The power switch will illuminate, showing the kettle is in operation.

3. When the water has reached the correct temperature, the power switch will switch off automatically.

4. You can stop the boiling at any time by lifting the switch up. To re-boil, press the switch again. If the water is very hot, it may be necessary to wait until the switch resets.

5. Always ensure the lid is tightly fitted and never lift it while the kettle is boiling, or you run the risk of scalding. If the lid is not correctly fitted while boiling, the automatic cut-out will not operate, you may boil the kettle dry and cause damage due to excessive steam emissions.

6. After boiling, switch off the appliance at the mains. The kettle can now be safely removed from its base and the boiled water poured out. Always pour boiling water slowly and carefully without tipping the kettle too quickly.

7. Never leave hot water in the kettle while it is unattended. After use, replace the kettle on its base.

Before First Use or After Storage

Fill the kettle with fresh water. Boil the water. Pour away the boiled water. Repeat this two or three times. The kettle is now ready for use.

Boil Switch with Auto Shut-Out

When boiling water, do NOT hold the switch down, or steam will be ejected from the lid, and you may damage the automatic shut-off mechanism. Always ensure that the ON/OFF switch is clear of obstructions, readily operable, and is not prevented from switching off.

Boil Dry Protection

Your kettle is fitted with a safety device which switches it off if the appliance is operated with insufficient water. If this occurs, the kettle should be switched off at the mains and allowed to cool thoroughly before refilling with cold water. The safety device will then reset.

Overheating Shut-Off

In the status of gross overheating, your kettle will automatically shut down to prevent further damage. Should this occur, take it to a qualified service person for examination and repair.

Cleaning

To prolong the kettle's lifespan, please clean the mineral deposits in the kettle regularly.

• Always unplug from the plug socket and allow to cool down before cleaning.
• Do not use chemical, steel wool, or abrasive cleaners to clean the outside of the kettle, as these will scratch the surface and fade the outside color.

Cleaning methods:

1. Fill the kettle with 0.5L white vinegar and the remainder with water and allow to stand for over 1 hour.
2. Empty the solution from the kettle. Wipe off the deposits remaining with a damp cloth.
3. Fill the kettle with clean water, bring to boil, and then discard the water. Repeat this process for the kettle to be ready for use.
4. If necessary, repeat the operations above for several times.
5. The surface of the kettle may be wiped over with a damp cloth and polished with a soft dry cloth.

Storage

Excess cord can be stowed by feeding the cord into the storage cavity in the base of the unit. When the kettle is not in use, it should be stored on its base and out of the reach of children and pets.

Specifications

THIS APPLIANCE MUST BE EARTHED

THIS APPLIANCE MUST BE ATTENDED AT ALL TIMES WHEN IN OPERATION