Instructions for CSCLED models including: CLW08C, 2AW5A-CLW08C, 2AW5ACLW08C, CLW08C, LED Corn Lamp
ASMART LIGHT CO., LTD CLW08C LED Corn Lamp 2AW5A-CLW08C 2AW5ACLW08C clw08c
1. Installation LED Corn Lamp Instruction It could be easily installed using a straight screwdriver . Use a flat-blade screwdriver to unscrew the plug and removethe plug. And then. Choose motion sensor to install and tighten. Note: the motion sensor has no dialing code, and a remote control is needed for adjustment.Please refer to the instruction for remote control adjustment. 2. Function Adopted dual PD technology, HB01DMS-A/B is able to differentiate artificial light brightness from natural light after installed inside the fixture, and automatically turn off light when ambient brightness exceeds preset lux level Light automatically on when ambient brightness is lower than preset lux level. With insufficient ambient brightness, light dims to 100% when motion detected. Light dims to stand-by level if no motion detected after hold time. Light off when ambient lux level is higher than preset lux amount. 3. Warning DISCONNECT POWER AT SERVICE ENTRANCE BEFORE CLEANING OR SERVICING. ADD GRILLE CURRENT TO FAN CURRENT FOR TOTAL CURRENT DRAW. INSTALL ONLY WITH MODELS INDICATED IN THE INSTALLATION INSTRUCTIONS. COUPEZ L'ALIMENTATION AU PANNEAU ÉLECTRIQUE AVANT LES TRAVAUX DE NETTOYAGE OU D'ENTRETIEN. ADDITIONNEZ LA CONSOMMATION DE COURANT DE LA GRILLE À CELLE DU VENTILATEUR POUR OBTENIR L'APPEL TOTAL DE COURANT. S'INSTALLE UNIQUEMENT AVEC LES MODÈLES INDIQUÉS DANS LES DIRECTIVES D'INSTALLATION. FCC WARING This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference. (2)This device must accept any interference received, including interference that may cause undesired operation. 2. Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note:This equipment has been tested and found to comply with the limits for a class B digital device,pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and,if not installed and used in accordance with the instructions,may cause harmful interference to radio communications.However,there is no guarantee that interference will not occur in a particular installation.if this equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on,the user is encouraged to try to correct the interference by one or more of the following measures: · Reorient or relocate the receiving antenna. · Increase the separation between the equipment and receiver. · Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. · Consult the dealer or an experienced radio/TV technician for help.WPS 文字