Instruction Manual for Xtralite models including: XL20717, XL20717 Small LED Tap Light, Small LED Tap Light, LED Tap Light, Tap Light, Light

XL20717 Manual

Download Manual

Omni Rechargeable LED Push Lights With Wireless Magnetic Strip – Xtralite


File Info : application/pdf, 2 Pages, 491.46KB

PDF preview unavailable. Download the PDF instead.

XL20717 Manual 122d319f-9d58-4b3f-84c6-d5ca160771f2 ?v=1719224833
Important Information

This is not a toy. Close attention is necessary when

When using electrical appliances, in order to

used near children.

reduce the risk of fire, electric shock, and/or injury Do not immerse the appliance in water or any

to persons, basic safety precautions should always other liquid.

be followed.

Do not allow children to play with the packaging

materials.

For your safety...
Read all instructions carefully, even if you are familiar with the appliance. Do not use this appliance if it appears to be damaged. Do not look directly into the light source or point it into the eyes of others. This can lead to retinal damage. This appliance is not watertight and is unsuitable for use in damp environments.

Small LED Tap Light

Unit 3a Eden Business Park Dunns Close Nuneaton Warwickshire CV11 4NE
t: 02476 586 845 e: info@xtra-lite.com
xtralite is a trading name of Trinity Xtras Ltd a Company registered in England No 4325172
One Year Limited Warranty Made in China For further product information visit www.xtra-lite.com

Instruction Manual Model: XL20717
Please read these instructions carefully before connecting or using the appliance. Keep for future reference.

EASY INSTALLATION:
1 122cm

2

3M 3M

on 3m 15m off
Before first use, use the micro USB cable (included) to charge the product until the indicator light turns green.

Place the magnetic strip on the back of the unit with the adhesive strip face up.

3

4

Remove the sticker from the magnetic strip and place the light onto the desired surface. Hold firmly against surface for 30 seconds.
EASY REMOVAL:
1

Tap the light to turn on.
SCREW FIXING:
1

Simply pull the unit off the wall. To remount it just place it back to where you had it previously mounted.

Locate the sites for the screws by measuring the distance from the centre from one keyhole slot to the other.

2

3

Mark the locations to install the 2 screws. Carefully drive screws in, leaving a little over a 1/16" gap.
SWITCH SETTINGS:
on 3m 15m off

Slide the product's two keyhole slots over the two screw heads until both sides are captured by the narrow end of the keyhole slots.
Switch Controls: On: Light stays on continuously 3m: Light turns off after 3 minutes after being activated. 15m: Light turns off after 15 minutes after being activated. Off: Light is off

on 3m 15m off

IMPORTANT: Failure to follow instructions carefully may cause damage. CAUTION: Do not hang over beds or on wallpaper. When disposing of, please locate local recycling centre.

Dimensions: 97mm x 77mm x 20mm Weight: 60g LED quantity: 3 Lamp CCT: 4000K Lumens: 50 Battery type: Rechargeable Li-ion 3.7V/1500mAH Power Switch: Tap ON/OFF Indoor use only



References

PDFlib PDI 10.0.0p1-i (Win32) Serif Affinity Designer 2 2.5.2